Inhaltszusammenfassung zur Seite Nr. 1
Important Safeguards - 1 -
i
Instruction Manual
8mm Video Camcorder
VM-E220A
Hitachi Home Electronics (America), Inc. HITACHI (HSC) CANADA INC
3890 Steve Reynolds Blvd., Norcross, GA 30093 3300 Trans Canada Highway, Pointe Claire,
Tel. 770-279-5600 Quebec, H9R 1B1, CANADA
Tel. 514-697-9150
HITACHI SALES CORPORATION OF HAWAII, INC
3219 Koapaka Street, Honolulu, Hawaii 96819
Tel. 808-836-3621
Thank you for buying a Hitachi product. Please take time to become familiar wit
Inhaltszusammenfassung zur Seite Nr. 2
Important Safeguards - 2 - TABLE OF CONTENTS Important Safeguards .............................................................................................................................. 4 IMPORTANT SAFETY INSTRUCTIONS FOR AC ADAPTER/CHARGER .................................... 6 Read This First.......................................................................................................................................... 7 Before You Begin ...................................
Inhaltszusammenfassung zur Seite Nr. 3
Important Safeguards - 3 - Periodic Maintenance ........................................................................................................................ 42 Troubleshooting .................................................................................................................................. 42 Specifications ...................................................................................................................................... 46 Accessories Add Excit
Inhaltszusammenfassung zur Seite Nr. 4
Important Safeguards - 4 - -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Caution to the user: Changes or modifications not expressly approved by the manufacture could void the user's authority to operate the equipment. "Note to CATV system installer:
Inhaltszusammenfassung zur Seite Nr. 5
Important Safeguards - 5 - 5 Power Sources -- This video product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your video dealer or local power company. For video products intended to operate from battery power, or other sources, refer to the operating instructions. 6 Overloading -- Do not overload wall outlets and extension cords as this can result in a risk of fire or electric
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT SAFETY INSTRUCTIONS FOR AC ADAPTER/CHARGER - 6 - other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching or approaching such power lines or circuits as contact with them might be fatal. Installing an outdoor antenna can be hazardous and should be left to a professional antenna installer. USE 14 Cleaning -- Unplug this video product from the wall o
Inhaltszusammenfassung zur Seite Nr. 7
Read This First - 7 - 4. Caution -- To reduce risk of injury, charge only rechargeable battery, VM-BP82G, VM-BP82 or VM-BP84. Other types of batteries may burst causing personal injury and damage. 5. Do not expose charger to rain or snow. 6. Use of an attachment nor recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons. 7. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting
Inhaltszusammenfassung zur Seite Nr. 8
Before You Begin - 8 - Features • Easy to use • Instant zoom • 24x zoom ratio • Recorded date search • Automatic title recording Components and Accessories Check that you have all the following components and accessories before preceding. 1. Audio/Video output cable 2. Battery pack 3. AC adapter/charger 4. Batteries for date/title 5. DC cord 6. Lens cap string Optional RF Adapter If you wish to connect this camcorder to a television that does not have audio/video input jacks yo
Inhaltszusammenfassung zur Seite Nr. 9
Getting Started - 9 - Pass the string through the lens cap and grip belt and attach it as shown in the figure. Removing the lens cap Always attach the lens cap to protect the lens when carrying or storing the camcorder. During shooting attach the lens cap as shown in the figure to prevent it from being lost. Getting Started This section guides you through the initial preparation of the camcorder. None of these processes are complex. Set aside some time, relax, and familiarize yourself
Inhaltszusammenfassung zur Seite Nr. 10
Getting Started - 10 - After charging set the mark switch to red so that you may quickly identify whether the battery is charged or uncharged. Note: The marker switch does not guarantee the batteries charge status. Additional Information To use a battery in optimum condition: • Use the battery until the low charge light ( ) flashes. Using a battery for a short time and then recharging it may shorten the operation time. • It is recommended to refresh a battery before recharging it when it
Inhaltszusammenfassung zur Seite Nr. 11
Getting Started - 11 - Adjusting the Electronic Viewfinder The electronic viewfinder adjusts simply by pivoting it to a position where it is comfortable and easy to see through. Place the viewfinder back in its original position before storing the camcorder in its case or carrying the camera recorder around to avoid damaging the viewfinder or camcorder. Eyepiece Adjustment To use the electronic viewfinder, turn this control for your optimum focus adjustment. Adjustment the Hand Stra
Inhaltszusammenfassung zur Seite Nr. 12
Getting Started - 12 - Install the battery to prevent misplacing it. 1. Pull out the battery holder. 2. Insert the battery with the "+" terminal facing up. 3. Fully insert the battery holder into the camcorder. WARNING: KEEP THE BATTERIES AWAY FROM CHILDREN AND PETS. IF SWALLOWED CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT. Note: Replace the batteries with 3V micro lithium cells such as Maxell CR2025 or its equivalent. Note: Dispose of battery safely in accordance with
Inhaltszusammenfassung zur Seite Nr. 13
Getting Started - 13 - 3. Once the arrows are aligned, push down on the battery. 4. While pushing down the battery, slide it to the right until it "clicks" into place. 5. After installing the battery, close the cover. Hold the OPEN lever and align the tabs on both sides of the cover with the end of the attachment section. Note: If the OPEN lever is flat, the cover will not close. Note: Always remove the battery from the camcorder after use. Note: We cannot guarantee against malfun
Inhaltszusammenfassung zur Seite Nr. 14
Getting Started - 14 - 3. Remove the battery and close the cover. Checking the Battery's Charge A battery charge indicator is located on the upper right corner of the viewfinder. One of three symbols displays when the battery is used. This symbol indicates a fully charged battery. This symbol indicates a partially charged battery. This flashing symbol indicates a battery nearly out of power. Use an alternate power source or charge the battery before continuing to use the camcorder.
Inhaltszusammenfassung zur Seite Nr. 15
Getting Started - 15 - 3. Insert six alkaline batteries with the correct polarities. 4. After installing the batteries, close the cover. Hold the OPEN lever and align the tabs on both sides of the cover with the end of the attachment section. Note: Use only "AA" alkaline batteries marked "LR6". (Manganese batteries cannot be used to power the camcorder.) Note: It is recommended that you use alkaline batteries within the recommended period of use or within two years of the date of ma
Inhaltszusammenfassung zur Seite Nr. 16
Getting Started - 16 - Note: Since the supply voltage from batteries decreases more abruptly when compared to that from a battery pack, the battery remaining level indicator ( ) may not flash in the viewfinder, noise may occur, the picture and sound may not be recorded normally and/or the power may be turned off soon. These phenomena occur because the capacity of batteries becomes low. So turn the power switch off and replace the batteries. If the power switch is left turned on in this stat
Inhaltszusammenfassung zur Seite Nr. 17
Getting Started - 17 - Note: Only use the car battery cord with cars having 12/24 volt negative ground system. Inserting and Removing Cassettes A power source must be connected before inserting or removing cassettes. Once connected cassettes can be inserted or removed whether the CAM/OFF/VIDEO switch is on or off. Inserting a Cassette 1. Slide the EJECT switch in the direction of the arrow. The cassette door opens automatically. 2. Place the cassette in the cassette holder so that the tra
Inhaltszusammenfassung zur Seite Nr. 18
Getting Started - 18 - Using the Linear Time Counter The linear time counter displays the tape run in hours, minutes, and seconds, helping you to keep track of how long you've been filming or time you have left to film before running out of tape. Turn the camcorder on to display the linear time counter. The linear time counter keeps track from when you load a cassette into the camcorder and clears to 0:00:00 when the cassette is ejected. Remaining Tape The tape remaining display shows
Inhaltszusammenfassung zur Seite Nr. 19
Getting Started, Identifying Controls - 19 - 1. Load the battery ("Loading the Batteries: Camcorder batteries" p.15). Press the red button on the CAM/OFF/VIDEO switch as you slide it to CAM. 2. Press the DATE/TITLE button and look into the viewfinder. The date and time should appear in the lower right with the "1" flashing. 3. Pressing the F.F button gives you higher numbers while the REW button gives you lower numbers. Select the right month and press STOP button. Use the F.F, REW and
Inhaltszusammenfassung zur Seite Nr. 20
Getting Started, Identifying Controls - 20 - A power source must be connected to the camcorder before a cassette can be inserted or removed. 5. Microphone 6. Record Indicator This indicator lights when the camcorder is recording. 7. Infrared Receiver The area where infrared signals from the wireless remote are received. Aim the remote control to this area for best results. 8. EJECT Switch A power source must be connected before cassettes can be inserted or removed though the CAM/OFF/VID
