Inhaltszusammenfassung zur Seite Nr. 1
Operating instructions
Steam oven
DG 4064 / DG 4164
DG4064L/DG 4164 L
en-GB
To avoid the risk of accidents or
damage to the appliance it is
essential to read these
instructions before it is installed
and used for the first time. M.-Nr. 06 786 680
Inhaltszusammenfassung zur Seite Nr. 2
Contents Description of the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Front view.........................................................4 Controls and displays ...............................................5 Accessories supplied ...............................................6 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Caring for the environment. . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
Contents Extracting juice with steam ..........................................34 Disinfecting containers .............................................35 Preparing yoghurt .................................................35 Safety features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Pressure release / Safety valve .......................................36 Overheating protection .............................................38 Safety loc
Inhaltszusammenfassung zur Seite Nr. 4
Description of the appliance Front view a Controls and displays b On/Off button c Overheating protection device cover cap d Door handle e Door release f Pull-out shelf g Appliance door h Door button i Opening for adding descaling agent j Lift-up door (only on appliances with an "L" in the model number) k Temperature sensor l Steam vent m Deflector plate for water nozzle n Shelf runners o Door contact switch p Drain filter 4
Inhaltszusammenfassung zur Seite Nr. 5
Description of the appliance Controls and displays q Programme/temperature display with symbols for the following programmes: Steam with pressure Steam without pressure Reheat Defrost Safety lock Descale P Programming r Temperature button - s Programme button t Temperature button + u Time display with symbol for: Duration of programme v Time button - w Start/Stop button x Time button + 5
Inhaltszusammenfassung zur Seite Nr. 6
Description of the appliance Accessories supplied The accessories supplied with your appliance as well as a range of optional ones are available to order from Miele (see "Optional accessories"). DGGL 1 2 perforated cooking containers for steaming gross capacity 1.5 l / useable capacity 0.9 l Gastronorm size GN 1/3 325x175x40 mm (WxDxH) DGG 2 1 solid cooking container for steaming gross capacity 2.5 l / useable capacity 2.0 l Gastronorm size GN 1/3 325x175x65mm (WxDxH) 1 tray For placing your own
Inhaltszusammenfassung zur Seite Nr. 7
Warning and Safety instructions Correct application This appliance conforms to current This appliance is not designed for safety requirements. Please note commercial use. It is intended for use in that improper use can cause both domestic households and for use in personal injury and damage to similar working and residential property. environments such as: To avoid the risk of accidents and – Shops, damage to the appliance, please – Offices and showrooms, read these instructions carefully befo
Inhaltszusammenfassung zur Seite Nr. 8
Warning and Safety instructions Safety with children Technical safety The appliance must be installed at Before installation, check the such a height that small children cannot appliance for visible signs of damage. reach the appliance door, which gets Do not use a damaged appliance. It hot during use. could be dangerous. Use the system lock to ensure that Before installation, check the water children cannot switch the appliance on hoses for visible signs of damage. by mistake. The stopc
Inhaltszusammenfassung zur Seite Nr. 9
Warning and Safety instructions Before connecting the appliance, Faulty components must only be make sure that the connection data on replaced by genuine Miele original the data plate (voltage, frequency and spare parts. The manufacturer can only connected load) match the mains guarantee the safety of the appliance electricity supply. when Miele replacement parts are This data must correspond in order to used. avoid the risk of damage to the During installation, maintenance and appliance.
Inhaltszusammenfassung zur Seite Nr. 10
Warning and Safety instructions Correct use When using an electrical appliance, e.g. a hand-held food blender, near the The appliance, especially the door, steam oven, ensure that the cable of becomes extremely hot during use, and the electrical appliance does not come remains hot for some time after into contact with the hot appliance. The switching off. Be careful only to touch insulation on the cable could become the door button and door handle when damaged, giving rise to an electric the
Inhaltszusammenfassung zur Seite Nr. 11
Warning and Safety instructions Do not leave cooked food in the Miele cannot be held liable for oven and do not use any cooking containers which are susceptible to damage caused by non-compliance corrosion as this could lead to with these Warning and Safety corrosion in the appliance. instructions. The appliance is designed to detect and then self-correct certain operational faults. If a fault is detected, the fault messages F06 to F95 will appear in the display. The door of the appliance ca
Inhaltszusammenfassung zur Seite Nr. 12
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for disposal human health and to the environment. and should be recycled. They are, however, essential for the Packaging, e.g. cling film, polystyrene correct func
Inhaltszusammenfassung zur Seite Nr. 13
Before using for the first time Setting the water hardness Location level If the steam oven is installed at an altitude higher than 1000 m above sea The steam oven is set at the factory to level, the boiling point for water will be water hardness range IV (04) . lower than the boiling point for water at If your water hardness level differs from sea level. To cater for this, the boiling this you will need to re-programme the point for water in the appliance can be appliance. Proceed as described
Inhaltszusammenfassung zur Seite Nr. 14
Before using for the first time Opening and closing the door To close the door Pull out the shelf underneath the Turn the handle to the horizontal appliance before opening the door. You position. can place hot containers on the shelf This ensures that the door lugs are and it will also collect any drops of hot lined up with those on the cooking water. compartment opening (see arrows). To open the door Using the thumb of your right hand, push the door release forwards and turn the handle upwa
Inhaltszusammenfassung zur Seite Nr. 15
Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service, data plate" section of this booklet. Cleaning and heating up for the first time Remove any protective foil. Take all accessories out of the oven. Wash them in a mild solution of washing-up liquid and hot water or in the dishwasher. The appliance has been treated at the factory with a conditioning agent. To remove this, cle
Inhaltszusammenfassung zur Seite Nr. 16
Operation Before each use Programming steps in brief A Close the steam oven door. Check that - the stopcock is open. B Switch the appliance on. - the filter at the bottom of the C Select a programme. appliance is correctly positioned to prevent pieces of D Adjust the recommended food blocking the drain. temperature if required. - the door is properly shut. E Set the duration. The steam oven is then ready for use. F Start the programme. These steps are described in more detail on the following pa
Inhaltszusammenfassung zur Seite Nr. 17
Operation Programme chart Symbol Function Recommended Temperature range which temperature* can be set** in °C in °C Factory default Available range setting Steam with 120 105 - 120 101 - 120 pressure Steam cooking 100 40 - 100 40 - 100 Reheat 95 - - Defrost 60 50 - 60 50 - 60 * The recommended temperatures were established by our test kitchen as being the optimum temperatures for the different programmes. ** The recommended temperature can be altered in 5 °C increments within the range q
Inhaltszusammenfassung zur Seite Nr. 18
Operation Switching on and selecting a If you want to use a different programme, press the programme programme button repeatedly until the programme you want shows in the You will hear a humming sound when display, e.g. Steam without pressure the appliance is switched on, during . operation or after the appliance has been switched off. This sound does not indicate a malfunction or fault with the appliance. It happens when the water is pumped in and out. Close the appliance door. Switch th
Inhaltszusammenfassung zur Seite Nr. 19
Operation Setting a cooking duration Starting the programme In the time display, you will see 3 zeros A cooking programme can only be and the flashing symbol. started when Use the + or - time buttons to set the – the appliance door is closed. required duration, e.g. 20 minutes. – a cooking duration has been set. If the door is not properly shut, an alarm will sound and the word door will appear in the time display. Press the Start/Stop button . A cooking duration of between 1 minute (0:01
Inhaltszusammenfassung zur Seite Nr. 20
Operation Interrupting operation The cooling down phase lasts approx. one minute. The last temperature set You can interrupt a programme at any will reappear in the time, for example, to place another programme/temperature display. container in the cooking compartment. Wait until you hear several beeps, Press the Start/Stop button . and the symbol is flashing in the time display. Pull out the shelf. Open the door. "Stop" will appear in the time display. The cooling down phase will beg
