Inhaltszusammenfassung zur Seite Nr. 1
TL-WR842ND
300Mbps Multi-Function Wireless N Router
Rev: 1.0.0
1910010537
Inhaltszusammenfassung zur Seite Nr. 2
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2011 TP-LINK TECHNOLOGIES CO.,
Inhaltszusammenfassung zur Seite Nr. 3
FCC RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. “To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all per
Inhaltszusammenfassung zur Seite Nr. 4
This device has been designed to operate with the antennas listed below, and having a maximum gain of 5 dBi. Antennas not included in this list or having a gain greater than 5 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communi
Inhaltszusammenfassung zur Seite Nr. 5
TP-LINK TECHNOLOGIES CO., LTD DECLARATION OF CONFORMITY For the following equipment: Product Description: 300Mbps Multi-Function Wireless N Router Model No.: TL-WR842ND Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all the technical regulations applicable to the product within the scope of Council Directives: Directives 1999/5/EC The above product is in conformity with the following standards or other normative documents EN 301 893 V1.5.1
Inhaltszusammenfassung zur Seite Nr. 6
CONTENTS Package Contents.....................................................................................................1 Chapter 1. Introduction.........................................................................................2 1.1 Overview of the Router...............................................................................................2 1.2 Conventions ...............................................................................................................3
Inhaltszusammenfassung zur Seite Nr. 7
4.7.2 DHCP Clients List.........................................................................................47 4.7.3 Address Reservation ....................................................................................48 4.8 VPN..........................................................................................................................49 4.8.1 IKE................................................................................................................49 4.8.2 IPse
Inhaltszusammenfassung zur Seite Nr. 8
4.16.2 ARP List........................................................................................................95 4.17 Dynamic DNS...........................................................................................................95 4.17.1 Comexe.cn DDNS ........................................................................................96 4.17.2 Dyndns.org DDNS ........................................................................................97 4.17.3 No-ip.com DD
Inhaltszusammenfassung zur Seite Nr. 9
TL-WR842ND 300Mbps Multi-Function Wireless N Router Package Contents The following items should be found in your package: TL-WR842ND 300Mbps Multi-Function Wireless N Router DC Power Adapter for TL-WR842ND 300Mbps Multi-Function Wireless N Router Quick Installation Guide Resource CD for TL-WR842ND 300Mbps Multi-Function Wireless N Router, including: • This Guide • Other Helpful Information Note: Make sure that the package contains the above items. If any of the listed items are
Inhaltszusammenfassung zur Seite Nr. 10
TL-WR842ND 300Mbps Multi-Function Wireless N Router Chapter 1. Introduction Thank you for choosing the TL-WR842ND 300Mbps Multi-Function Wireless N Router. 1.1 Overview of the Router The TL-WR842ND 300Mbps Multi-Function Wireless N Router integrates 4-port Switch, Firewall, NAT-Router and Wireless AP. Powered by 2x2 MIMO technology, the 300Mbps Multi-Function Wireless N Router delivers exceptional range and speed, which can fully meet the need of Small Office/Home Office (SOHO) networks
Inhaltszusammenfassung zur Seite Nr. 11
TL-WR842ND 300Mbps Multi-Function Wireless N Router 1.2 Conventions The Router or TL-WR842ND mentioned in this guide stands for TL-WR842ND 300Mbps Multi-Function Wireless N Router without any explanation. 1.3 Main Features Complies with IEEE 802.11n to provide a wireless data rate of up to 450Mbps. One 10/100M Auto-Negotiation RJ45 Internet port, four 10/100M Auto-Negotiation RJ45 LAN ports, supporting Auto MDI/MDIX. Provides USB Port supporting storage/FTP/Media/Print Server. Prov
Inhaltszusammenfassung zur Seite Nr. 12
TL-WR842ND 300Mbps Multi-Function Wireless N Router 1.4 Panel Layout 1.4.1 The Front Panel Figure 1-1 Front Panel sketch The Router’s LEDs are located on the front panel (View from left to right). Name Status Indication The device has a system error. Off （SYS） The device is initialising. On Flashing The device is working properly. Off The wireless function is disabled. (Wireless) Flashing The wireless function is enabled. Off There is no device linked to the corresponding po
Inhaltszusammenfassung zur Seite Nr. 13
TL-WR842ND 300Mbps Multi-Function Wireless N Router Note: After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes and then turn off. 1.4.2 The Rear Panel Figure 1-2 Rear Panel sketch The following parts are located on the rear panel (View from left to right). POWER: The Power socket is where you will connect the power adapter. Please use the power adapter provided with this TL-WR842ND 300Mbps Multi-Function Wireless N Rou
Inhaltszusammenfassung zur Seite Nr. 14
TL-WR842ND 300Mbps Multi-Function Wireless N Router 2) Use the Factory Default WPS/RESET button: With the Router powered on, use a pin to press and hold the WPS/RESET button (approximately 8 seconds) until the SYS LED becomes quick-flash from slow-flash. And then release the button and wait the Router to reboot to its factory default settings. WIFI ON/OFF: Press this button to enable or disable Wi-Fi. Wireless antenna: To receive and transmit the wireless data. - 6 -
Inhaltszusammenfassung zur Seite Nr. 15
TL-WR842ND 300Mbps Multi-Function Wireless N Router Chapter 2. Connecting the Router 2.1 System Requirements Broadband Internet Access Service (DSL/Cable/Ethernet) One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is connected directly to the Ethernet.) PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors TCP/IP protocol on each PC Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari 2.2 In
Inhaltszusammenfassung zur Seite Nr. 16
TL-WR842ND 300Mbps Multi-Function Wireless N Router Note: If you want to use the Router to share files or printer, plug the USB storage device to the USB port or connect the printer to the Router with a matching cable. 6. Connect the power adapter to the power socket on the Router, and the other end into an electrical outlet. The Router will start to work automatically. 7. Power on your PC and Cable/DSL Modem. Figure 2-1 Hardware Installation - 8 -
Inhaltszusammenfassung zur Seite Nr. 17
TL-WR842ND 300Mbps Multi-Function Wireless N Router Chapter 3. Quick Installation Guide This chapter will show you how to configure the basic functions of your 300Mbps Multi-Function Wireless N Router using Quick Setup Wizard within minutes. 3.1 TCP/IP Configuration The default domain name of the Router is http://tplinklogin.net and the default Subnet Mask is 255.255.255.0. These values can be changed as you desire. In this guide, we use all the default values for description. Connect t
Inhaltszusammenfassung zur Seite Nr. 18
TL-WR842ND 300Mbps Multi-Function Wireless N Router If the result displayed is similar to Figure 3-2, it means the connection between your PC and the Router failed. Figure 3-2 Failure result of Ping command Please check the connection following these steps: 1. Is the connection between your PC and the Router correct? Note: The 1/2/3/4 LEDs of LAN ports which you link to on the Router and LEDs on your PC's adapter should be lit. 2. Is the TCP/IP configuration for your PC correc
Inhaltszusammenfassung zur Seite Nr. 19
TL-WR842ND 300Mbps Multi-Function Wireless N Router Settings interface may not be opened with some web browsers, it is strongly recommended that you use Internet Explorer. 1. To access the configuration utility, open a web-browser and type in the default domain name http://tplinklogin.net in the address field. Figure 3-3 Log in the Router After a moment, a login window will appear, similar to Figure 3-4. Enter admin for the User Name and Password, both in lower case letters. Then clic
Inhaltszusammenfassung zur Seite Nr. 20
TL-WR842ND 300Mbps Multi-Function Wireless N Router Figure 3-5 Quick Setup 3. Click Next, and then WAN Connection Type page will appear as shown in Figure 3-6. Figure 3-6 WAN Connection Type The Router provides Auto-Detect function and supports three popular ways PPPoE, Dynamic IP and Static IP to connect to the Internet. It’s recommended that you make use of the Auto-Detect function. If you are sure of what kind of connection type your ISP provides, you can select the very type an
