Inhaltszusammenfassung zur Seite Nr. 1
ADSL 2/2+ VoIP Router
IAD-200, IAD-200W
User's Manual
Inhaltszusammenfassung zur Seite Nr. 2
Copyright Copyright (C) 2005 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable
Inhaltszusammenfassung zur Seite Nr. 3
Operation is subject to the Following two conditions: (1) This device may not cause harmful interference, and (2) This Device must accept any interference received, including interference that may cause undesired operation. Federal Communication Commission (FCC) Radiation Exposure Statement This equipment complies with FCC radiation exposure set forth for an uncon- trolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximi
Inhaltszusammenfassung zur Seite Nr. 4
Trademarks The PLANET logo is a trademark of PLANET Technology. This documenta- tion may refer to numerous hardware and software products by their trade names. In most, if not all cases, these designations are claimed as trademarks or registered trademarks by their respective companies. Safety This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricit
Inhaltszusammenfassung zur Seite Nr. 5
Table of Contents CHAPTER 1 INTRODUCTION..................................................................... 1 IAD-200 / IAD-200W Features ................................................................. 1 Package Contents ....................................................................................... 4 Physical Details........................................................................................... 5 CHAPTER 2 INSTALLATION .............................................
Inhaltszusammenfassung zur Seite Nr. 6
Routing...................................................................................................... 85 Upgrade Firmware................................................................................... 89 CHAPTER 7 OPERATION AND STATUS ................................................ 90 Operation .................................................................................................. 90 Status Screen .....................................................................
Inhaltszusammenfassung zur Seite Nr. 7
Chapter 1 Introduction 1 This Chapter provides an overview of the ADSL 2/2+ VoIP router (IAD-200) / 802.11g ADSL 2/2+ VoIP router's (IAD-200W) features and capabilities. Congratulations on the purchase of your new ADSL 2/2+ VoIP router – IAD-200 / 802.11g ADSL 2/2+ VoIP router – IAD-200W. The IAD-200 / IAD-200W is a multi-function device providing the following services: • ADSL 2/2+ Modem. • Shared Broadband Internet Access (NAT Router) for all LAN & WLAN users. • Wireless Access Poi
Inhaltszusammenfassung zur Seite Nr. 8
• Auto-detection of Internet Connection Method. In must situations, the IAD-200 / IAD-200W can test your ADSL and Internet connection to determine the connection method used by your ISP. • Fixed or Dynamic IP Address. On the Internet (WAN port) connection, the IAD-200 / IAD-200W supports both Dynamic IP Address (IP Address is allocated on connection) and Fixed IP Address. Advanced Internet Functions • Application Level Gateways (ALGs). Applications which use non-standard connec- tion
Inhaltszusammenfassung zur Seite Nr. 9
• WEP support. Support for WEP (Wired Equivalent Privacy) is included. Key sizes of 64 Bit and 128 Bit are supported. WEP encrypts any data before transmission, providing protection against snoopers. • WPA-PSK support. Like WEP, WPA-PSK encrypts any data before transmission, providing protection against snoopers. The WPA-PSK is a later standard than WEP, and provides both easier configuration and greater security than WEP. • Wireless MAC Access Control. The Wireless Access Control fea
Inhaltszusammenfassung zur Seite Nr. 10
Package Contents The following items should be included. If any of these items are damaged or missing, please contact your dealer immediately. • The IAD-200 / IAD-200W Unit • 1 Cat-5 Ethernet (LAN) cable • 1 RJ-11 (ADSL) cable • Power Adapter • Quick Installation Guide • CD-ROM containing the on-line manual. 4
Inhaltszusammenfassung zur Seite Nr. 11
Physical Details Front-mounted LEDs IAD-200 IAD-200W Figure 2: Front Panel Power LED On - Power on. (Green) Off - No power. Status LED Off - Normal operation. (Yellow) Blinking - This LED blinks during start up, and during a Firmware Up- grade. LAN • 100BT - This will be ON if the LAN connection is using 100BaseT, and Blinking if data is being transferred via the LAN port. • 10BT - This will be ON if the LAN connection is using 10BaseT, and Blinking if data is being trans
Inhaltszusammenfassung zur Seite Nr. 12
Internet On - Internet connection is available. Off - No Internet connection available. Flashing - Data is being transmitted or received. 6
Inhaltszusammenfassung zur Seite Nr. 13
Rear Panel IAD-200 IAD-200W Figure 3: Rear Panel Connect this port to your ADSL line. ADSL port PSTN Connect this to your PSTN line (normal analog phone line). Phone Connect a standard phone here. LAN Connect this port to your hub, using the supplied LAN cable. This button will reset the IAD-200 / IAD-200W to the factory default Reset Button (Reset to Defaults) settings. To do this, press and hold the Reset Button for five (5) seconds, until the Status LED is lit, then releas
Inhaltszusammenfassung zur Seite Nr. 14
Chapter 2 Installation 2 This Chapter covers the physical installation of the ADSL 2/2+ VoIP router (IAD-200) / 802.11g ADSL 2/2+ VoIP router (IAD-200W). Requirements • TCP/IP protocol must be installed on all PCs. • To use the Wireless Access Point, all Wireless devices must be compliant with the IEEE 802.11g or IEEE 802.11b specifications. • For Internet Access, an ADSL service and ISP account. • For VoIP, a SIP account with a VoIP service provider. Procedure Figure 4: Installa
Inhaltszusammenfassung zur Seite Nr. 15
2. Connect LAN Cable Use the supplied LAN cable to connect the LAN port on the IAD-200 / IAD-200W to your hub. 3. Connect ADSL Cable Connect the supplied ADSL cable from the ADSL port on the IAD-200 / IAD-200W to the ADSL terminator provided by your phone company. 4. Connect PSTN Line Connect the PSTN socket on the rear of the IAD-200 / IAD-200W to your normal phone line socket. 5. Connect Phone Connect a standard phone to the Phone socket on the rear of the IAD-200 / IAD-200W. 6. P
Inhaltszusammenfassung zur Seite Nr. 16
Chapter 3 Setup 3 This Chapter provides Setup details of the IAD-200 / IAD-200W. Overview This chapter describes the setup procedure for: • Internet Access • LAN configuration • Wireless setup • Assigning a Password to protect the configuration data. PCs on your local LAN may also require configuration. For details, see Chapter 4 - PC Con- figuration. Other configuration may also be required, depending on which features and functions of the IAD-200 / IAD-200W you wish to use. Use
Inhaltszusammenfassung zur Seite Nr. 17
Configuration Program The IAD-200 / IAD-200W contains an HTTP server. This enables you to connect to it, and configure it, using your Web Browser. Your Browser must support JavaScript. The configuration program has been tested on the following browsers: • Netscape 7.1 or later. • Mozilla 1.6 or later • Internet Explorer V5.5 or later Preparation Before attempting to configure the IAD-200 / IAD-200W, please ensure that: • Your PC can establish a physical connection to the IAD-200 / IA
Inhaltszusammenfassung zur Seite Nr. 18
If you cannot connect If the IAD-200 / IAD-200W does not respond, check the following: • The IAD-200 / IAD-200W is properly installed, LAN connection is OK, and it is powered ON. You can test the connection by using the "Ping" command: • Open the MS-DOS window or command prompt window. • Enter the command: ping 192.168.0.1 If no response is received, either the connection is not working, or your PC's IP address is not compatible with the IAD-200 / IAD-200W's IP Ad- dress. (See next
Inhaltszusammenfassung zur Seite Nr. 19
Common Connection Types Type Details ISP Data required Dynamic Your IP Address is allocated a) ADSL parameters (VPI and IP Address automatically, when you connect VCI) may be required, if they to you ISP. cannot be detected automatically. b) Some ISP's may require you to use a particular Hostname or Domain name, or MAC (physical) address. Static (Fixed) Your ISP allocates a permanent a) ADSL parameters (VPI and IP Address IP Address to you. VCI) may be required, if they Usually,
Inhaltszusammenfassung zur Seite Nr. 20
Home Screen After finishing the Setup Wizard, you will see the Home screen. When you connect in future, you will see this screen when you connect. An example screen is shown below. Figure 5: Home Screen Main Menu The main menu, on the left, contains links to the most-commonly used screen. To see the links to the other available screens, click "Advanced" or "Administration". The main menu also contains two (2) buttons: • Log Out - When finished, you should click this button to logout
