Inhaltszusammenfassung zur Seite Nr. 1
Magnum 700X Mini-Concentrator
Corporate Headquarters
Garrett Communications
213 Hammond Avenue
Fremont, CA 94539
Phone (510) 438-9071
FAX (510) 438-9072
WWW: http://www.garrettcom.com
E-mail: support@garrettcom.com
Magnum 700X
Mini-Concentrator
eu
GARRETT
Installation and User Guide
GARRETT GARRETT
Inhaltszusammenfassung zur Seite Nr. 2
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) Magnum 700X Mini-Concentrator Installation and User Guide Part #: 84-00017 (R5/98) Trademarks UL is a registered trademark of Underwriters Laboratories Ethernet is a trademark of Xerox Corporation Velcro is a trademark of Velcro USA UL is a registered trademark of Underwriters Laboratories Magnum is a trademark of Garrett Communications, Inc. Important: Magnum 700X Mini-Concentrators contain no
Inhaltszusammenfassung zur Seite Nr. 3
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) Contacting Garrett Communications Please use the mailing address and phone and fax numbers listed below: Garrett Communications 47823 Westinghouse Drive Fremont, CA 94539 Phone (510) 438-9071 Fax (510) 438-9072 WWW: http://www.garrettcom.com E-mail: support@garrettcom.com Federal Communications Commission Radio Frequency Interference Statement This equipment generates, uses and can radiate frequency e
Inhaltszusammenfassung zur Seite Nr. 4
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) Table of Contents 1.0 SPECIFICATIONS ........................................................................................1 1.1 Technical Specifications ..................................................................................... 1 1.2,3 Specifications - Port Modules (RPMs and BPMs) .......................................... 3 1.4 Ordering Information ..........................................
Inhaltszusammenfassung zur Seite Nr. 5
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) MAGNUM ETHERNET CONNECTIVITY PRODUCTS "DESIGNED AND MANUFACTURED IN THE USA" Overview Garrett Communications offers the Magnum line of Ethernet LAN physical layer connectivity products with industry-standard functionality. Magnum products are available worldwide through OEMs, integrators, representatives, retailers and international distributors. Dual Speed 8-port & 16-por
Inhaltszusammenfassung zur Seite Nr. 6
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 1.0 SPECIFICATIONS This chapter gives the specifications of the Magnum 700X mixed-media concentrator, as well as those of the various Port Modules (PMs). 1.1 Technical Specifications Performance Data Rate: 10 Mbps RPM Partitioning: Enforced after 32 consecutive collisions. RPM Reconnect: Occurs after 512 bits error-free transmission. BPM Auto-learning Address List: 256 node capacity. BPM Filtering and
Inhaltszusammenfassung zur Seite Nr. 7
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) (1.1 Technical Specifications, continued) Connectors Seven Magnum PM ports on the front. BPMs are available with BNC, AUI, FST, and STP connectors. The following are available as RPM configurations. RJ-45: Shielded, 8-Pin Female (Note: Shielded 10BASE-T connectors accept either unshielded or shielded wiring plugs for standard twisted pair media wiring.) Fiber Optic: ST (Twis
Inhaltszusammenfassung zur Seite Nr. 8
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 1.2 Specifications - Repeater Port Modules (RPMs) RPM Type : BNC AUI DTE Fiber-mm Fiber-sgl.m TP* Front Access yes yes yes yes yes yes Connector Type BNC-f DB-15 f DB-15 m ST or SC Fiber-ST RJ-45 Partition (PART)LED yes yes yes yes yes yes Receive (RX) LED yes yes yes yes yes yes LINK LED n.a. n.a. n.a. yes yes yes Switch on Face Plate yes** n.a. n.a. n.a. n.a. yes*** “Fib
Inhaltszusammenfassung zur Seite Nr. 9
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 1.4 Ordering Information Magnum 700X Mini-Concentrator Magnum 700X Base chassis with 7 slots for RPMs and BPMs, power supply Magnum 700X-Br Multi-Bridge chassis with one RJ-45 RPM for the common port, and 6 slots for BPMs and other RPMs, power supply. Includes 5 face plates. Magnum RPM-BNC Repeater Module with 1 BNC connector, internal termination switch Magnum RPM-TP Repeater Mo
Inhaltszusammenfassung zur Seite Nr. 10
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 2.0 INTRODUCTION This chapter describes the functionality of the Magnum 700X and its Port Modules. 2.1 Inspecting the Package and Product Examine the shipping container for obvious damage prior to installing this product; notify the carrier of any damage which you believe occurred during shipment or delivery. Inspect the contents of this package for any signs of damage and ensure t
Inhaltszusammenfassung zur Seite Nr. 11
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) Each Magnum 700X unit is a complete operational unit with an internal power supply enclosed in a lightweight, compact, rugged metal enclosure. The media connectors and the status LEDs are conveniently accessed from the front. The unit is easily installed and is suitable for wiring closet shelf, table-top or vertical mounting. Magnum 700X units operate as multi-port repeaters a
Inhaltszusammenfassung zur Seite Nr. 12
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) The internal power supply is auto-ranging to handle any AC power type worldwide. Power input may range from 90 to 260 vac, with a frequency rating of 47 to 63 Hz. The unit is equipped with a rear mounted IEC-type recessed male AC power connector. (When shipped for use in areas other than 115 vac, a power cord will not be included). The 700X unit is convection cooled for silent o
Inhaltszusammenfassung zur Seite Nr. 13
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) take advantage of internal termination, the slide switch should be in the "DOWN" (or right-side) position. In this configuration, the 10BASE2 segment is directly attached to the BNC port where it is internally terminated. When the switch is in the "UP" (or left-side) position, the BNC port requires a "tee" connector (not Internal Termination supplied) and a 50 ohm terminator Stan
Inhaltszusammenfassung zur Seite Nr. 14
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) to provide connectivity to any media type. The RPM-AUI card is equipped with Partition (PART) and Receive (RX) LEDs which function the same as the identical LEDs on the RPM-BNC (Section 2.3.1 above). The Magnum RPM-AUI card is also used for connecting Ethernet devices using standard AUI cabling. In this situation, it is important to consider the AUI segment length or distance to th
Inhaltszusammenfassung zur Seite Nr. 15
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 2.3.3 RPM-DTE The Magnum RPM-DTE is a module equipped with a 15-pin male DTE connector with lock posts. (The RPM-DTE is a mating connector for the RPM-AUI which has a 15-pin Standard 15-pin female connector and slide locks. The pin male "AUI" assignments of the two are the same). The Partition LED 1 RPM-DTE card is designed to support direct 2 Receive LED connections (no tran
Inhaltszusammenfassung zur Seite Nr. 16
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) JUMPER ACROSS DISTANCES SUPPORTED 1 - 2 0 - 2 km 3 - 4 0.5 - 3 km* 5 - 6 1.5 - 4 km* 1 2 When fiber cable distances of 2 km or less are needed, the 3 4 jumper should be placed across pins 1 and 2. 5 6 * When fiber cable distances of more than 2 km are J1 DEFAULT selected, the minimum cable length must also be increased, as shown in the table above. 2.3.5 RPM-FSC (Fiber SC,
Inhaltszusammenfassung zur Seite Nr. 17
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) Note: Be sure to use single-mode fiber optic cable with this module. Single-mode fiber has a smaller diameter than multi-mode fiber (2/15 - 8/60 microns for single-mode, 50/125 or 62.5/125 microns for multi-mode, where xx/xx are the diameters of the core and the core plus the cladding respectively). NOTE: The RPM-SMF circuit board contains a six pin jumpers, but the jumper
Inhaltszusammenfassung zur Seite Nr. 18
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 2.3.7 RPM-TP (Twisted Pair) The Magnum RPM-TP card supports Ethernet twisted pair segments of any standard length. It is equipped with a single RJ-45 connector. The RJ-45 connector is shielded to minimize emissions and will allow MDI-X both unshielded twisted pair (UTP) Cross-Over Shielded RJ-45 Slide Switch Connector and shielded twisted pair (STP) segment connections. 1 T
Inhaltszusammenfassung zur Seite Nr. 19
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) 2.4 Bridge Port Modules (BPMs) To provide optional local segment isolation, individual Bridge Port Modules (BPMs) are available for Magnum 700Xs. For flexibility, any port of a Magnum 700X may be configured with a BPM. Multiple (up to 6) BPMs may be configured in one 700X chassis.. There are four different BPM cards and each is designed with its own media connector type. BPMs a
Inhaltszusammenfassung zur Seite Nr. 20
Magnum 700X Mini-Concentrators Installation and User Guide (05/98) the RPM-BNC section, 2.3.1. The BPM-BNC module includes an FWD-I LED and an FWD-X LED, which are visible from the front. The FWD-I LED blinks GREEN to indicate that packets are being forwarded INTO the local Magnum hub or stack.. The FWD-X LED blinks GREEN to indicate that packets are being forwarded OUT of the local Magnum hub or stack. 2.4.2 BPM-AUI This local-bridge module