Inhaltszusammenfassung zur Seite Nr. 1
EZ Card 1000
1000 Mbps Gigabit Ethernet
PCI Network Card
High performance for instant access to network resources
Delivers 2 Gbps of bandwidth over installed
Category 5 UTP
Support for 32-bit PCI bus up to 66 MHz
Full- and half-duplex operation at 1000, 100, and
10 Mbps
IP, TCP and UDP checksum off-loading capability to reduce
CPU overhead
User Guide
SMC9452TX
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
EZ Card 1000 User Guide From SMC’s EZ line of low-cost workgroup LAN solutions 6 Hughes Irvine, CA 92618 June 2001 Phone: (949) 707-2400 Pub. # 150000003500A
Inhaltszusammenfassung zur Seite Nr. 4
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2001 by SMC Networks, Inc. 6 Hughes Irvine, CA 92618 All rights
Inhaltszusammenfassung zur Seite Nr. 5
Limited Warranty Limited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable
Inhaltszusammenfassung zur Seite Nr. 6
LIMITED WARRANTY WARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER'S SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMC'S OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUME
Inhaltszusammenfassung zur Seite Nr. 7
COMPLIANCES FCC - Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea- sonable protection against harmful interference in a residential installation. This equip- ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communi- cations. However, there is no
Inhaltszusammenfassung zur Seite Nr. 8
COMPLIANCES EC Conformance Declaration - Class B SMC contact for these products in Europe is: SMC Networks Europe, Edificio Conata II, o a Calle Fructuós Gelabert 6-8, 2 , 4 , 08970 - Sant Joan Despí, Barcelona, Spain. This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within cer- tain voltage limits a
Inhaltszusammenfassung zur Seite Nr. 9
COMPLIANCES Industry Canada - Class B This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of Communications. Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques,” NMB-003 édictée par
Inhaltszusammenfassung zur Seite Nr. 10
COMPLIANCES vi
Inhaltszusammenfassung zur Seite Nr. 11
TABLE OF CONTENTS 1 Installing The Network Card . . . . . . . . . . . . . . . 1-1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Hardware Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 12
Offload Checksum . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2 Packet Size (Maximum) . . . . . . . . . . . . . . . . . . . . . . . . 3-2 Pause Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Receive Buffer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 VLAN ID . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Using VLANs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 Traffic Priority
Inhaltszusammenfassung zur Seite Nr. 13
CHAPTER 1 INSTALLING THE NETWORK CARD Introduction SMC’s EZ Card 1000, SMC9452TX, is a Gigabit Ethernet network interface card for 32-bit PCI local bus-compliant computers. It operates under the 1000BASE-T specification over Category 5 UTP Cable, as well as being compatible with 100BASE-TX and 10BASE-T connections. This network card provides up to ten times the bandwidth of Fast Ethernet, and can deliver a full 2 Gbps of throughput to the host PC. A true plug-and-play device, the card is
Inhaltszusammenfassung zur Seite Nr. 14
ACT 100 LINK 1000 10 INSTALLING THE NETWORK CARD Hardware Description The EZ Card 1000 is a Gigabit Ethernet network card designed for 32-bit PCI-bus computers. The card has a single RJ-45 connector to attach to Category 5 UTP cable and supports 10 Mbps, 100 Mbps and 1000 Mbps Ethernet operations. It also supports full- and half-duplex and features auto-negotiation. Socket for Optional Boot ROM LED Indicators RJ-45 Connector for 10/100 Mbps Figure 1-1. The EZ Card 1000 SMC9452TX 1-2
Inhaltszusammenfassung zur Seite Nr. 15
INSTALLING THE NETWORK CARD LED Indicators The EZ Card 1000 network card includes status LED indicators as described in the following figure and table. Figure 1-2. Status LEDs LED Status Description Link On Green Indicates a valid 1000BASE-T connection. ACT Flashing Indicates that the adapter is Green transmitting or receiving data. 1000 On Green Indicates that the adapter is operating at 1000 Mbps. 100 On Green Indicates that the adapter is operating at 100 Mbps. 10 On Green Indicates tha
Inhaltszusammenfassung zur Seite Nr. 16
INSTALLING THE NETWORK CARD Package Contents After unpacking the EZ Card 1000, check the contents of the box to be sure you have received the following components: EZ Card 1000 network card SMC9452TX SuperDisk™ network drivers diskette This User Guide SMC Warranty Registration Card Immediately inform your dealer in the event of any incorrect, missing or damaged parts. If possible, please retain the carton and original packing materials in case there is a need to return the product.
Inhaltszusammenfassung zur Seite Nr. 17
INSTALLING THE NETWORK CARD System Requirements Before you install the EZ Card 1000, check your system for the following requirements: A PC and BIOS that support the PCI Local Bus Specification v2.0 or later An available bus-mastering 32-bit PCI slot Category 5 or 5e UTP cable with RJ-45 connectors An IEEE 802.3ab-compliant Gigabit Ethernet device installed in your network Note: If you are installing in an older PC model (Pentium or earlier), upgrade the BIOS to the latest version.
Inhaltszusammenfassung zur Seite Nr. 18
INSTALLING THE NETWORK CARD When using a 32-bit PCI slot, the end of the card’s edge connector will be exposed. Be careful that it does not touch any conducting parts on the PC motherboard. 3. Install the network card into the slot so that it is firmly seated. Then screw the card’s bracket securely into the PC’s chassis. 32-Bit PCI Slot Figure 1-3. Inserting the Network Card 1-6
Inhaltszusammenfassung zur Seite Nr. 19
INSTALLING THE NETWORK CARD 4. Replace the chassis cover on your PC and power it on. 5. The EZ Card 1000 should be automatically configured by the host computer’s BIOS. However, if you have an older computer, you may have to manually configure the computer’s BIOS settings (see Appendix, A “Troubleshooting”). 6. The SMC SuperDisk that accompanies the EZ Card 1000 contains all the network operating system drivers supported by this card. Please read the “RELEASE.TXT” file on the diskette for
Inhaltszusammenfassung zur Seite Nr. 20
INSTALLING THE NETWORK CARD Connecting Category 5 Cable To connect to a 1000BASE-T Gigabit Ethernet device, use the RJ-45 connector on the network card and Category 5, 5e or better UTP cable. This connection can be made directly to the device, or indirectly via a wall outlet that has the proper wiring for an RJ-45 connector. Connections can be made for a distance of 100m (328 ft). It is recommended that for all critical connections, or any new cable installations, Category 5e (enhanced Cat
