Inhaltszusammenfassung zur Seite Nr. 1
3-070-124-11 (2)
Modem Adaptor
™
with Bluetooth
Function
GB
Operating Instructions
Before operating the unit, please read this manual thoroughly, and retain
it for future reference.
Owner’s Record
The model and serial numbers are located on the bottom. Record the serial
number in the space provided below. Refer to these numbers whenever
you call upon your Sony dealer regarding this product.
Model No. BTA-NW1
Serial No.
FR
Mode d’emploi
BTA-NW1
© 2001 Sony Corporation
Inhaltszusammenfassung zur Seite Nr. 2
WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Countries and areas This product is intended to be used in the following countries or areas. Australia, Austria, Belgium, Canada, Denmark, Finland, France, Germany, Greece, Hong Kong, Ireland, Japan, Luxembourg, Netherlands, New Zealand, Norway, Portugal, Singapore, Sweden, Switzerland, UK, USA This product is intended to be in indoor use only in Canada and France. Regulatory Information For the Customers in the
Inhaltszusammenfassung zur Seite Nr. 3
The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company to determine the maximum REN for the calling area. If the terminal equipment (
Inhaltszusammenfassung zur Seite Nr. 4
The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections
Inhaltszusammenfassung zur Seite Nr. 5
Table of contents Precautions .................................................................................................................................. 6 Identifying the parts .................................................................................................................. 7 Preparing the unit ...................................................................................................................... 8 Installing the exclusive modem card and exclusive modem ca
Inhaltszusammenfassung zur Seite Nr. 6
Precautions The set is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the set itself has been turned off. Installation/storage Do not place the unit in locations that are: •Extremely hot such as in a car parked in the sun •Under direct sunlight or near sources of high temperature, such as a heating device •Subject to strong vibration •Near devices which generate strong magnetic fields •Dusty or dirty When you use the unit on a sandy beach
Inhaltszusammenfassung zur Seite Nr. 7
Identifying the parts 6 7 8 9 q; 1 qa 2 3 qs 4 5 1 POWER lamp (green) 6 TONE/PULSE10/PULSE20 selector 2 ON LINE lamp (orange) 7 CLEAR button Note 3 lamp (blue) Resets all the setup items to the default Lamp POWER ON LINE values. (green) (orange) (blue) Communication 8 BONDING/NORMAL switch standby with a z – z 9 AREA CODE switches (1–8) Bluetooth device 0 Battery cover Dialing z z qa Exclusive modem card slot Data transmissionzz z qs Exclusive modem card eject switch Insufficient battery capacit
Inhaltszusammenfassung zur Seite Nr. 8
Preparing the unit Before using the unit, carry out the following preparations. If the plug of the exclusive modem cable does not match the telephone terminal jack, attach an optional plug adaptor. The plug of the exclusive modem cable is an RJ-11 plug. Installing the exclusive modem card and exclusive modem cable to the Modem Adaptor with Bluetooth Function 12 v mark To the telephone terminal jack Exclusive modem card eject switch Incorrect Correct installation installation (1) Insert the excl
Inhaltszusammenfassung zur Seite Nr. 9
Preparing the unit x Using the supplied AC power adaptor Connect the AC power adaptor to the DC IN jack on the unit and a wall outlet (mains). AC power adaptor AC-PT1 To a wall outlet (mains) To DC IN or To a wall outlet (mains) AC power adaptor AC-PW1 Notes •The socket outlet should be as close as possible to the unit and easily accessible. •The shape of your AC power adaptor differs depending on your area. x Installing the size AA alkaline dry batteries The batteries are convenient for outdoor
Inhaltszusammenfassung zur Seite Nr. 10
Setting up the unit You must make certain settings before you can connect the unit to your phone line. Choose the proper settings for your telephone signaling type. You also have to set the AREA CODE switches according to your area. 4 3 1 (1) Before making the settings, check that the POWER ON/OFF switch is set to OFF. (2) Remove the battery cover. (3) Select the telephone signaling type with the TONE/PULSE10/PULSE20 selector. TONE: When your phone line has tone signaling. PULSE10: When your pho
Inhaltszusammenfassung zur Seite Nr. 11
Setting up the unit To check the dial speed of a pulse dialing phone You can change the dialing speeds of some pulse dial phones. To check the dial speed, switch the dial speed selector on the phone and check the clicking sound. The slower one is the normal setting. When you select the fast dial speed, set the TONE/PULSE10/ PULSE20 selector to PULSE20. The setup of the AREA CODE switches Set the AREA CODE switches to the appropriate positions using a sharp-pointed object following the informatio
Inhaltszusammenfassung zur Seite Nr. 12
Registering Bluetooth devices Up to 16 Bluetooth devices can be registered with this unit. When registering devices, consult the operating instructions supplied with the Bluetooth device. When you try to register the 17th device, you must clear all of the previous registrations. 3, 7 1, 4, 6, 9 (1) Before registering, be sure to set the POWER ON/OFF switch to OFF. (2) Remove the battery cover. (3) Set the BONDING/NORMAL switch to BONDING. (4) Set the POWER ON/OFF switch to ON. The POWER lamp (gr
Inhaltszusammenfassung zur Seite Nr. 13
Registering Bluetooth devices When you try to register a 17th Bluetooth device You have to clear all the previous registrations. Press CLEAR using a sharp-pointed object to clear all the registrations. Once you turn the unit off and on, you can register a new Bluetooth device. Notes •When you register Bluetooth devices, be sure to set the BONDING/NORMAL switch to BONDING before turning on this unit. •Up to 16 Bluetooth devices can be registered. If you try to register a 17th Bluetooth device, th
Inhaltszusammenfassung zur Seite Nr. 14
Communicating with the Bluetooth device After registering a Bluetooth device, you can communicate with that Bluetooth device. 1 (1) Set the POWER ON/OFF switch to ON. The lamps turn on as described below. (z: The lamp turns on) POWER ON LINE (green) (orange) (blue) z –– m m m Communication standby with a z – z Bluetooth device (2) Turn on the registered Bluetooth device and start communication. The lamps turn on or flash as described below. (z: The lamp turns on, : The lamp flashes) POWER ON LI
Inhaltszusammenfassung zur Seite Nr. 15
Troubleshooting If you experience trouble with your unit, first check the following items. Should your unit still not operate properly after you have made these checks, consult your Sony dealer or local authorized Sony service facility. Power Symptom Cause and/or solution The unit will not turn on. • The size AA alkaline dry batteries are completely dead. c Replace them with new size AA alkaline dry batteries. • You are using batteries other than the recommended ones. c Use the recommended batte
Inhaltszusammenfassung zur Seite Nr. 16
Troubleshooting Communication Symptom Cause and/or solution The unit cannot communicate with • The exclusive modem card is not inserted properly. Bluetooth devices. c Insert it properly. See “Preparing the unit” on page 8. • The size AA alkaline dry batteries are completely dead. c Replace them with new size AA alkaline dry batteries. • The setup of the AREA CODE switches is wrong. c Set them up correctly. See “Setting up the unit” on page 10. • The position of the TONE/PULSE10/PULSE20 selector
Inhaltszusammenfassung zur Seite Nr. 17
Specifications Modulation mode standard Wireless AC power adaptor ITU-T V.21/V.22/V.22bis/V.32/ communication V.32bis/V.34/V.90, BELL 212A/ Power requirements 103, K56flex™ (The type of your adaptor is Communication system Sender sensitivity shown on your adaptor.) Bluetooth specification Ver. 1.1 –10 to –15 dBm AC-PT1: 120 V AC, 60 Hz (For Maximum communication Receiver sensitivity 1) 2) customers in the USA and speed –10 to –40 dBm Canada), 230 to 240 V AC, 50 Hz Approx. 723 kbps Error corre
Inhaltszusammenfassung zur Seite Nr. 18
AVERTISSEMENT Pour prévenir tout risque d’incendie ou d’électrocution, conserver cet appareil à l’abri de la pluie et de l’humidité. Pays et régions Ce produit est destiné à être utilisé dans les régions et pays suivants : Allemagne, Australie, Autriche, Belgique, Canada, Danemark, Etats-Unis, Finlande, France, Grèce, Hong Kong, Irlande, Japon, Luxembourg, Nouvelle-Zélande, Norvège, Pays-Bas, Portugal, Singapour, Suède, Suisse et Royaume-Uni. Au Canada et en France, ce produit est destiné à être
Inhaltszusammenfassung zur Seite Nr. 19
Avertissement: L’utilisateur ne doit pas tenter de faire ces raccordements lui-même; il doit avoir recours à un service d’inspection des installations électriques, ou à un électricien, selon le cas. AVIS: L’indice d’équivalence de la sonnerie (IES) assigné à chaque dispositif terminal indique le nombre maximal de terminaux qui peuvent être raccordés à une interface. La terminaison d’une interface téléphonique peut consister en une combination de quelques dispositifs, à la seule condition que la
Inhaltszusammenfassung zur Seite Nr. 20
4-FR
