Inhaltszusammenfassung zur Seite Nr. 1
Network Management Adaptor BKM-FW32
2-560-787-02 (1)
Network
Management
Adaptor
JP
GB
Operating Instructions
FR
Mode d’emploi
DE
Bedienungsanleitung
ES
Manual de instrucciones
IT
Istruzioni per l’uso
CS
BKM-FW32
2004 Sony Corporation
Inhaltszusammenfassung zur Seite Nr. 2
1 b 2 3 JP 2
Inhaltszusammenfassung zur Seite Nr. 3
.................................................. 4 (JP) ..................................... 5 (JP) ........................ 5 (JP) .................................. 6 (JP) ................................... 7 (JP) ................... 10 (JP) ................................ 13 (JP) JP .................................................... 14 (JP) JP 3
Inhaltszusammenfassung zur Seite Nr. 4
JP 4
Inhaltszusammenfassung zur Seite Nr. 5
• • • ........................................................................................................................................................................... • • JP 5
Inhaltszusammenfassung zur Seite Nr. 6
RESET RESET 10BASE-T/ 100BASE-TX JP 6
Inhaltszusammenfassung zur Seite Nr. 7
1 1 1 2 COM FWD 2 • 1 • 2 1 2 2 JP 7 AUDIO OUT INPUT 2 R L AUDIO RGB / COMPONENT NETWORK MANAGEMENT AUDIO OUT INPUT 2 RL OUT IN OUT IN AUDIO IN VIDEO S VIDEO R L AUDIO RGB / COMPONENT VIDEO INPUT ADAPTOR
Inhaltszusammenfassung zur Seite Nr. 8
LAN LAN LAN LAN LAN JP 8
Inhaltszusammenfassung zur Seite Nr. 9
11 JP 6 IP • LAN 7 LAN • IP IP 1 LAN IP Address 2 3 30 4 IP IP 5 • • JP 9
Inhaltszusammenfassung zur Seite Nr. 10
Information Configuration Timer Screen Saver Picture and Picture 2 Internet 1 Explorer 6.0 http ://xxx.xxx.xxx.xxx 2 IP Enter 3 JP 10
Inhaltszusammenfassung zur Seite Nr. 11
Control Set up POWER INPUT PICTURE MODE ASPECT Owner Information CLOSED CAPTION Owner Display Location Memo Time Contrast +/ Time Brightness +/ Chroma +/ Network Internet Protocol (TCP/IP) Phase +/ JP 11
Inhaltszusammenfassung zur Seite Nr. 12
Password Account Name Mail Report * Password Send Test Mail Address Mail Account Mail Address • • Outgoing Mail Server (SMTP) Advanced Requires the use of POP Authentication before Send e-mail (POP before SMTP) RESET POP Ingoing Ma
Inhaltszusammenfassung zur Seite Nr. 13
t t t t JP 13
Inhaltszusammenfassung zur Seite Nr. 14
JP 14
Inhaltszusammenfassung zur Seite Nr. 15
Inhaltszusammenfassung zur Seite Nr. 16
WARNING This equipment has been tested and found Owner’s Record to comply with the limits for a Class B digital The model and serial numbers are located at device, pursuant to Part 15 of the FCC the rear. Record these numbers in the Rules. These limits are designed to provide spaces provided below. reasonable protection against harmful Refer to these numbers whenever you call interference in a residential installation. This upon your Sony dealer regarding this equipment generates, uses, and can
Inhaltszusammenfassung zur Seite Nr. 17
Table of Contents Precautions...................................... 4 (GB) About This Manual .......................... 4 (GB) Location and Function of Parts and Controls ........................................ 5 (GB) Preparations for Using the Networking Function ................... 6 (GB) Installing this device ........................... 6 (GB) System Configuration ......................... 8 (GB) Operations from a Computer ....... 10 (GB) Controlling the Display from a Computer ... 10 (GB)
Inhaltszusammenfassung zur Seite Nr. 18
Precautions About This Manual • Please note that the software This manual explains networking specifications are subject to change operations when this device is installed in without notice. the FWD series Flat Panel Display. • Some of the illustrations in this manual Refer to the Operating Instructions for the may differ from the actual application FWD series for operations other than software. networking. • For your safety, connect to an Ethernet network which does not exceed the voltage limit
Inhaltszusammenfassung zur Seite Nr. 19
Location and Function of Parts and Controls RESET button Network connector RESET button Press and hold the button for more than 3 seconds to clear the settings you made. Network connector (10BASE-T/ 100BASE-TX) Connect this device to the network with the LAN cable (10BASE-T/100BASE-TX). GB Location and Function of Parts and Controls 5
Inhaltszusammenfassung zur Seite Nr. 20
1 1 When the option slot is located on Preparations for the left side of a Display unit* Using the Networking Function You can connect this device to the network with a LAN cable (10BASE-T/100BASE- TX). This section describes the tasks required for using the networking function of this 2 device. Installing this device Before installation * The location of the option slot differs • Before installation, make sure that the depending on the model of the Display power to all the equipment is off. To
