Bedienungsanleitung Fostex Manual MN04

Inhaltszusammenfassung zur Seite Nr. 1

Mini Mixer
Model MN04 Owner's Manual
Thank you for purchasing the Fostex Model MN04.
The model MN04 is a four input two output mini mixer small in size and light in weight.
Channel 1 is an input for line/mic level (switchable type) and channels 2~4 are inputs for line level
signals.
Channel 1, in particular, has, in addition to the regular mic level position, an ALC (Automatic Level Control)
circuit position which minimizes distortion against input overload when using a microphone.
The MN04 can

Inhaltszusammenfassung zur Seite Nr. 2

IMPORTANT NOTES IN OPERATION 1. Avoid using headphones for long hours at high volume levels. 4. Switch off power to the mixer when interconnecting it to external Doing so can result in hearing failure. Any sudden increase in equipment. headphone sound levels must also be avoided. This could result in Always be sure to switch off the MN04 power when interconnecting damage to your hearing. external equipment to the MN04. 2. Turn down all sound volume controls when switching on power 5. Properly

Inhaltszusammenfassung zur Seite Nr. 3

CONNECTING THE AC ADAPTOR/INSTALLING THE BATTERY Plug the AC adaptor cable Open the mixer bottom battery Battery Compartment into the MN04 DC IN jack compartment lid by hand, correctly and plug the AC adaptor connect the plug to the battery, into the wall outlet. and place battery in compartment and replace lid as before. DC IN jack AC adaptor Be sure to remove the battery if it is not to be used for long hours or extensive periods of time. If not, it could result in leaking electrolyte

Inhaltszusammenfassung zur Seite Nr. 4

Load Impedance : Higher than 16Ω Specifications Frequency Response : 20Hz ~ 20kHz INPUT (Å~4) Distortion Rate (T.H.D.) : 0.05% Power Supply : DC9V(Exclusive AC adaptor) Mic Impedance : Less than 10kΩ : Battery x 1(Option/Equivalent Input Impedance :20kΩ to S-006P, 6F22) Rated Input Level Current Consumption : 40mA MIC INPUT : -60dBV Battery Life (Depends on : Manganese type (S-006P, 6F22) ALC ON : -50dBV ~ -20dBV application condition) =Approx. 4 hours, Alkali type LINE INPUT