Bedienungsanleitung Royal Sovereign THINFLEX RSH-380

Inhaltszusammenfassung zur Seite Nr. 1

13. WARRANTY
Royal Sovereign International warrants the equipment sold is free from defects in
material and workmanship for a period of One (1) year for Parts and Labor from the date
of installation, excluding lamination rollers which are warranted for Six (6) months. This
warranty is extended only to the original purchaser. This warranty is the only warranty
made by Royal Sovereign International and cannot be modified or amended. Royal
Sovereign’s sole and exclusive liability and the customer’

Inhaltszusammenfassung zur Seite Nr. 2

RSH-380 TABLE OF CONTENTS 1. INTRODUCTION TOPIC PAGE Thank you for purchasing a Royal Sovereign RSH-380 table top laminator. It has been designed and manufactured to provide years of continuous service. For complete 1. Introduction ......................................................................................................... 3 operating and maintenance information please read this instruction manual thoroughly. 2. Package Contents ....................................................

Inhaltszusammenfassung zur Seite Nr. 3

RSH-380 5. CONTROL PANEL 3. SAFETY PRECAUTIONS Failure to comply with any of the following safety procedures could result in serious injury. Please read the instructions carefully and keep for future reference. 1. Only a licensed electrician should install wiring and outlet for the laminator. 2. Ensure the unit is plugged into a properly grounded outlet with the correct voltage. 3. Keep hands and clothing (i.e. Neckties) away from the roller. The rollers have pinch < TEMPERATURE >

Inhaltszusammenfassung zur Seite Nr. 4

RSH-380 6. FILM LOADING & THREADING < Film Threading > < Thermal Film Loading & Threading > Loading Film 1. Remove the upper and lower film shafts from the machine and load the films (do not tighten the core screws at this time) 2. To load the top film, insert 1" core as shown on Figure 1 (Note the direction that the film is wound) Figure 1 3. Insert the shaft as shown in Figure 2. Figure 2 1. Turn the power switch on (“I” position). (The Power 4. Insert the core plug on the left h

Inhaltszusammenfassung zur Seite Nr. 5

RSH-380 7. BEFORE LAMINATING 8. OPERATING INSTRUCTIONS 1. For High Quality Lamination 1. Turn the laminator on, the power switch is located - Refer to the "Recommended Temperature and Speed Settings" section before on the rear of the machine. laminating. 2. Adjust the tension of the upper and lower films. Clockwise to tighten and Counter - The upper and lower film tension must be the same. Clockwise to loosen. 2. Changing Roll film. 3. Set the pressure lever to the "Laminating mod

Inhaltszusammenfassung zur Seite Nr. 6

RSH-380 9. RECOMMENDED TEMPERATURE AND SPEED SETTINGS < Using Cross Cutter > 1) The cross cutter is located on the rear exit table Paper speed Temperature Function of the machine. 2 80 g/m o Paper(both side can be used) 100~110 C 4~5 25~38mic o 2 120g/m (212~230 F) (1~1.5mil) 2 200g/m 3~4 Figure 1 color paper 2) After lamination, move the cutter approximately 2 80g/m to the center of the application at the desired point of detachment (Figure 1). Paper(both side can be used) o 100~110 C 75

Inhaltszusammenfassung zur Seite Nr. 7