Bedienungsanleitung PYLE Audio PYD1100

Inhaltszusammenfassung zur Seite Nr. 1

Specifications
PYD1100
Input Sensitivity/Impedance High 10kHz; +10/-10dB
Mic 1-2 1.5 mV/600 Ohms, bal/unbal Mid 1 kHz; +10/-10dB
Phono 1-2 3.0 mV/50K Ohms
Low
100Hz; +10/-10dB
Line 1-7 150 mV/27K Ohms
MIC Tone Control
Output Level
High
Amp 2.0 V/10kOhms 10kHz; +10/-10dB
Booth 2.0 V/10kOhms
LOW
100Hz; +10/-10dB
Record 150mV/10kOhms
Talkover Attenuation
-16dB
Frequency Response 20Hz – 20kHz +/- 3 dB
11
S/N Ratio (at 1 kHz)
Power Source
120 VAC, 60Hz/230 VAC, 50 Hz
Mic >60 dB/1.5mV input
Phono

Inhaltszusammenfassung zur Seite Nr. 2

Your PYLE PRO Series Performance Mixer Features and Controls: PYD1100 Mixer is a sophisticated control center, perfect for mixing sound from multiple playback sources such as microphones, tuners, CD players, turntables or the audio outputs from a VCR. This mixer is ruggedly constructed for home or professional use. Wide range volume controls permit you to adjust sound levels accurately to achieve just the right mix for playing through your speaker system or for recording. Please read this manual

Inhaltszusammenfassung zur Seite Nr. 3

Presetting the Controls Before Use Connecting High Level Output Audio Sources Since sudden high output levels from your Pyle Pro mixer can damage not only audio devices connected to the mixer output but your hearing as well (especially if you are using headphones), please adjust Connect up to 7 such sources (tuner, cassette deck, CD Player, camcorder or VCR) to the input jacks the mixer’s controls BEFORE connecting AC power or turning on the unit. for Line 1 , Line 2(if not being used as Phono 1

Inhaltszusammenfassung zur Seite Nr. 4

Connecting the Mixer Outputs Using Headphones Plug a pair of stereo headphones (not supplied) with a 1/4” jack into the Phones input. Using Output to an Amplifier headphones not only affords you the opportunity to listen privately, but also enables you to monitor (”cue”) the incoming audio sources so you can locate an exact passage or section before mixing it To play the mixer’s output signal through your speaker system (for events such as parties, dances, in. It also gives you the opportunity t

Inhaltszusammenfassung zur Seite Nr. 5

Adding Equalization to the Mix Using the Mixer Controls Turning on the Mixer These high, mid and low 3 band equallzation controls, permit you to tailor the tone frequency of the master output processed through the mix. left in their center positions, the sound is 1. Turn on the output amplifier and temporarily set its volume to the minimum setting. unaffected. 2. On the mixer, turn ON the power switch. The power LED will illuminate. Using the Microphone 3. Turn on the audio input sources you wis

Inhaltszusammenfassung zur Seite Nr. 6

Troubleshooting Your mixer should require very little maintenance. If you have problems, refer to the chart below for possible solutions. If you cannot solve the problem, contact a qualified technician for assistance. PROBLEM POSSIBLE SOLUTION Nothing works • Check the AC connection. Make sure the AC outlet is “live.” • Check the power connection to the rest of the system (receiver/amplifier, etc.) No signal from an • Check the control setting audio input • Check the connection between the mixer