Inhaltszusammenfassung zur Seite Nr. 1
3-861-410-32(1)
CD Radio
Cassette-Corder
EN
EN
Operating Instructions page 2
ES
ES
Manual de instrucciones página 2
CFD-V14
CFD-V15
CFD-V24
1998 by Sony Corporation
Inhaltszusammenfassung zur Seite Nr. 2
Notice for customers in the United Warning Kingdom To prevent fire or shock hazard, do A moulded plug complying with BS 1363 is not expose the player to rain or fitted to this equipment for your safety and moisture. convenience. Should the fuse in the plug supplied need to To avoid electrical shock, do not open be replaced, same rating fuse approved by the cabinet. Refer servicing to ASTA or BSI to BS 1362, (i.e. marked with qualified personnel only. or mark) must be used. Information If the p
Inhaltszusammenfassung zur Seite Nr. 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player Additional Information 12 Using the display 19 Precautions EN 13 Locating a specific point in a 21 Troubleshooting track 23 Maintenance 14 Playing tracks repeatedly 24 Specifications (Repeat Play) 25 Index 15 Playing tracks in random order (Shuffle Play) 16 Creating your own program (Program Play) Setting Up 17 Choosing the power sources 18 Adjusting t
Inhaltszusammenfassung zur Seite Nr. 4
Basic Operations Playing a CD 1 4 2,3 Connect the supplied AC power cord (see page 17). 1 Set FUNCTION to CD. 2 Press 6 PUSH OPEN/CLOSE down to open the CD compartment and place a CD on the CD compartment. With the label side up 3 Close the CD compartment. EN 4 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 5
Basic Operations Display 4 Press ^ . The player plays all the tracks once. Playing time Track number Use these buttons for additional operations VOLUME =/+ ^ p 6 PUSH OPEN/CLOSE FUNCTION To Do this Adjust the volume Turn VOLUME. Stop playback Press p. Pause playback Press ^. Press again to resume play after pause. Go to the next track Press +. Go back to the previous track Press =. Remove the CD Press 6 PUSH OPEN/ CLOSE. Turn off the player Set FUNCTION to TAPE (CD/RADIO OFF). EN Basic Operatio
Inhaltszusammenfassung zur Seite Nr. 6
Listening to the radio 1 2 Connect the supplied AC power cord (see page 17). 1 Set FUNCTION to FM or AM. 2 Turn TUNING to tune in a radio station. If the received FM stereo is too weak, the reception becomes monaural. EN 6 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 7
Basic Operations Use these buttons for additional operations VOLUME FUNCTION Tip To Do this To receive an FM stereo Adjust the volume Turn VOLUME. program (only for the models equipped with Turn off the radio Set FUNCTION to TAPE FM MODE selector at (CD/RADIO OFF). the rear) Set the FM MODE selector at the rear to To improve broadcast reception STEREO. If the FM Reorient the antenna for FM. Reorient the player itself broadcast is noisy, set for AM. the selector to MONO and the radio will play in
Inhaltszusammenfassung zur Seite Nr. 8
Playing a tape 32 1 Connect the supplied AC power cord (see page 17). 1 Set FUNCTION to TAPE (CD/ RADIO OFF). 2 Press p6 to open the tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing upward 3 Press (. EN 8 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 9
Basic Operations Use these buttons for additional operations 0/)p6 P VOLUME To Do this Adjust the volume Turn VOLUME. Stop playback Press p6. Fast-forward or rewind the tape Press ) or 0. Pause playback Press P. Press the button again to resume play after pause. Eject the cassette Press p6. EN Basic Operations 9
Inhaltszusammenfassung zur Seite Nr. 10
Recording on a tape 31 Connect the supplied AC power cord (see page 17). 1 Press p6 to open the tape compartment and insert a blank tape. Use TYPE I (normal) tape only. With the side you want to record on facing upward 2 Select the program source you Display want to record. To record from the CD player, set FUNCTION to CD and insert a CD (see page 4). To record from the radio, set FUNCTION to FM or AM and tune in the station you want (see page 6). EN 10 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 11
Basic Operations 3 Press r to start recording. (( is depressed automatically). Use these buttons for additional operations p6 P Tips To Press • Adjusting the volume or Stop recording p6 the tone will not affect the recording level. Pause recording P • For the best results, use Press the button again to the AC power as a resume recording. power source for recording. • To erase a recording, proceed as follows: 1 Set FUNCTION to TAPE (CD/RADIO OFF). 2 Press r . EN Basic Operations 11
Inhaltszusammenfassung zur Seite Nr. 12
The CD Player Using the display DISPLAY/ENTER You can check information about the CD using the display. Checking the total track number and playing time Check the display in stop mode. Total playing time Total track number Checking the remaining time Press DISPLAY/ENTER while playing a CD. To display Press DISPLAY/ENTER Remaining time on the Once current track* Remaining time on the CD Twice and the number of tracks left Playing time and the current Three times track number * For a track whose n
Inhaltszusammenfassung zur Seite Nr. 13
The CD Player Locating a specific =/+ point in a track You can locate a specific point in a track while playing a CD using + or =. To locate Press a point while listening to + (forward) or = the sound (backward) while playing and hold down until you find the point. a point while observing + (forward) or = the display (backward) in pause and hold down until you find the point. EN The CD Player 13
Inhaltszusammenfassung zur Seite Nr. 14
Playing tracks =/+ PLAY MODE ^ FUNCTION repeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or program play modes (see page 16). 1 Set FUNCTION to CD. 2 Press PLAY MODE until the repeat mode you want appears in the display. To repeat Select a single track REP 1 all tracks REP ALL tracks in random order SHUF REP programed tracks PGM REP 3 Do either of the following to start repeat play: • When you’ve selected REP 1, select the track by pressing the = or + and press ^. • Whe
Inhaltszusammenfassung zur Seite Nr. 15
The CD Player Playing tracks in PLAY MODE ^ FUNCTION random order (Shuffle Play) You can play tracks in random order. 1 Set FUNCTION to CD. 2 Press PLAY MODE until the “SHUF” appears in the display. 3 Press ^ to start shuffle play. To cancel Shuffle Play Press PLAY MODE until “SHUF” disappears from the display. EN The CD Player 15
Inhaltszusammenfassung zur Seite Nr. 16
Creating your PLAY DISPLAY/ FUNCTION =/+ ^ own program MODE ENTER (Program Play) You can arrange the playing order of the tracks on a CD. Tips 1 Set FUNCTION to CD. • You can play the same program again, since 2 Press PLAY MODE until “PGM” appears in the the program is saved display. until you open the CD 3 Press the = or + then press DISPLAY/ compartment or switch FUNCTION. ENTER for the tracks you want to program in the • The current program order you want. You can program up to 20 tracks. wil
Inhaltszusammenfassung zur Seite Nr. 17
Setting Up Setting Up Choosing the AC IN power sources You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Battery compartment To a wall outlet Tip Connecting the AC power cord Only for the Insert one end of the supplied AC power cord to the customers supplied AC IN socket located at the rear of the player, and the with an AC plug other end to the wall outlet. adaptor: Use the supplied AC plug adaptor if the pl
Inhaltszusammenfassung zur Seite Nr. 18
Adjusting the MEGA BASS TONE sound emphasis (TONE/MEGA BASS) You can adjust the tone. You can also reinforce the bass sound (CFD-V15/ V24 only). Adjusting the tone Turn TONE. Turn the control clockwise to enhance the high tone and counterclockwise to enhance the low tone. Reinforcing the bass sound (CFD-V15/V24 only) Press MEGA BASS. To return to normal sound, press the button again. EN 18 Setting Up
Inhaltszusammenfassung zur Seite Nr. 19
Additional Information Precautions On safety On placement • As the laser beam used in the CD • Do not leave the player in a location player section is harmful to the eyes, near heat sources, or in a place subject do not attempt to disassemble the to direct sunlight, excessive dust or casing. Refer servicing to qualified mechanical shock. personnel only. • Do not place the player on an inclined • Should any solid object or liquid fall or unstable place. into the player, unplug the player, and • D
Inhaltszusammenfassung zur Seite Nr. 20
Precautions (continued) Notes on CDs Notes on cassettes • Before playing, clean the CD with a • Break off the cassette tab from side A cleaning cloth. Wipe the CD from the or B to prevent accidental recording. If center out. you want to reuse the tape for recording, cover the broken tab with adhesive tape. Side A • Do not use solvents such as benzine, Tab for side A Tab for side B thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. • The use of a cassette with m
