Inhaltszusammenfassung zur Seite Nr. 1
Model iP90
The Home System
® ®
For Your iPhone or iPod
Questions? Visit www.ihomeaudio.com
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Quick Start ........................................................................................................................................................................1 Controls and Indicators / iP90 Display..........................................................................................................................2 Setting Up the iP90.......................................................................................................................
Inhaltszusammenfassung zur Seite Nr. 3
quick start 3: inserts 1: power 2: antennas RESET TEST DC 7.5V DST clock adj./time sync time zone am antenna line-in -1 +1 DST clock adj./time sync time zone am DC 7.5V -1 +1 Select the dock insert for your Snap AM antenna into provided Attach AC adaptor cable to iPhone or iPod® model from the stand, then plug antenna cable DC jack on back of the iP90 table below and place insert in into socket on back of iP90. and plug the other end into a dock. Never dock an iPhone/
Inhaltszusammenfassung zur Seite Nr. 4
Controls and Indicators Top Panel Dock Alarm 2 Button Alarm 1 Button Preset Buttons 1-6 Volume + Button Set + Button, skip/search FWD Volume - Button eq sleep Set - Button, skip/search REV Alarm Reset / Power Button Play/Pause Button snooze/dimmer Sleep Button Radio/line-in Button EQ Button Snooze/Dimmer Button Rear Panel Clock Adjust /Time Sync Button Line-in Jack AC Adaptor Jack DST switch Time Zone Button DC 7.5V DST clock adj./time sync time zone am antenna line-in -1
Inhaltszusammenfassung zur Seite Nr. 5
Setting Up the iP90 Connect iP90 to Power Source Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120V AC wall socket. Adaptor must be plugged in to operate unit. The iP90 does not operate on batteries (a battery back up system maintains clock settings during power failures). This unit is a preset clock: the clock is preset at the factory. It’s simple to match the Time Zone setting to your location (US only). 1. Depending on your location and whether or not
Inhaltszusammenfassung zur Seite Nr. 6
Using the iP90 Reviewing, Arming and Disarming Alarm (Turn Alarm Function On and Off) 1. Once an alarm is armed, the lower part of the display will show the alarm time. If more then one alarm is armed, the earliest alarm time will show. 2. To review the alarm time, press an alarm button once. The related alarm time will show on the lower part of the display. 3. During alarm review, press the alarm button once to toggle it on or off. If the alarm is armed, the related alarm icon will light up. R
Inhaltszusammenfassung zur Seite Nr. 7
Using the iP90 Using the Line-in Jack You can play any iPod without a docking port or other MP3 player or portable audio device through the iP90 via the Line-in Jack. 1. Plug one end of a standard audio patch cord (not included) into the headphone or line-out jack on your device and the other end of the patch cord into the iP90 Line-in Jack located on the back of the unit. 2. Press the Radio Button until “Line-in” appears in the lower part of the display. 3. Turn on and play your device. 4. Pr
Inhaltszusammenfassung zur Seite Nr. 8
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should no
Inhaltszusammenfassung zur Seite Nr. 9
Troubleshooting Symptom Possible Problem Solution iP90 does not turn on AC adaptor isn't plugged into a working wall Plug the AC adaptor into a working wall socket and plug the connector socket or not plugged into the power supply into the supply jack on the unit jack on back of the unit iP90 doesn’t respond iP90 requires a reset If unit is plugged in and doesn't respond, try resetting the unit by following these steps: a) remove iPhone/iPod from dock b) unplug unit from power source c) remo
Inhaltszusammenfassung zur Seite Nr. 10
Troubleshooting Possible Problem Solution Symptom Sound is distorted Volume level is set too high Decrease the volume Sound source is distorted If the iPhone/iPod original sound source (MP3) is old or of poor quality, distortion and noise are easily noticed with high-power speakers. Try a different audio source such as a music CD. If you are using an external sound source like older generation of iPod or iPod Shuffle, try reducing the output volume on the device itself. Also try turning bas
Inhaltszusammenfassung zur Seite Nr. 11
Solucionando problemas Síntoma Causa Solución La unidad no El adaptador de corriente AC no está conectado a Conecte el adaptador de corriente a un tomacorriente que funcione enciende un tomacorriente que funcione o no está conectado y a la parte posterior de la unidad en la parte posterior de la unidad La unidad no La unidad debe ser reprogramada Si la unidad está conectada y no responde, pruebe reprogramarla responde siguiendo estos pasos: a) Quite el iPod de la base b) Desconecte la unid
Inhaltszusammenfassung zur Seite Nr. 12
Solucionando problemas Síntoma Causa Solución La banda de AM se La antena circular no está ubicada correctamente. Aleje la antena de la unidad y del adaptador AC y gírela hasta escucha con distorsión mejorar la recepción. El sonido sale El volumen se encuentra muy alto Baje el volumen distorsionado El sonido sale distorsionado de la unidad Si el sonido original de su iPhone/iPod era de pobre calidad, las distorsiones y ruidos se harán más notables con los parlantes de alta potencia. Pruebe
Inhaltszusammenfassung zur Seite Nr. 13
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still
