Inhaltszusammenfassung zur Seite Nr. 1
OPERATION AND PARTS MANUAL
MODEL MS-93
PLASTER AND MORTAR MIXER
(GASOLINE ENGINE/ELECTRIC MOTOR)
Revision #5 (03/26/10)
THIS MANUAL MUST ACCOMPANY
THE EQUIPMENT AT ALL TIMES.
Inhaltszusammenfassung zur Seite Nr. 2
Engine exhaust and some of itsconstituents,andsomedustcreated by power sanding, sawing, grinding, drillingandotherconstructionactivities containschemicalsknowntotheState of California to cause cancer, birth defects and other reproductive harm. Someexamplesofthesechemicalsare: Leadfromlead-basedpaints. Crystallinesilicafrombricks. Cementandothermasonryproducts. Arsenicandchromiumfromchemically treatedlumber. Yourriskfromtheseexposuresvaries, dependingonhowoftenyoudothistype of work.To reduce your
Inhaltszusammenfassung zur Seite Nr. 3
HERE'S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING STOW MAIN OffIce Post Office Box 6254 888-252-STOW Carson, Ca 90749 FAx: 310-537-1986 Email: stow@multiquip.com Internet: www.stowmfg.com PAr TS DePAr TMeNT 800-427-1244 FAx: 800-672-7877 310-537-3700 FAx: 310-637-3284 ServIce DePAr TMeNT 800-421-1244 FAx: 310-537-4259 310-537-3700 TechNIcAl ASSISTANce 800-478-1244 FAx: 310-631-5032 WArrANTy DePAr TMeNT 800-421-1244, Ext. 279 FAx: 310-537-1173 310-537-370
Inhaltszusammenfassung zur Seite Nr. 4
STOW MS-93 PLASTER/MORTAR MIXER — TABLE OF CONTENTS STOW — Plaster/Mortar Mixer HONDA GX240K1HA2 EN- Here's How To Get Help ...........................................3 GINE Table Of Contents .....................................................4 Air Cleaner Assembly ........................................58-59 Parts Ordering Procedures .......................................5 Camshaft Assembly ...........................................60-61 Specifications .................................
Inhaltszusammenfassung zur Seite Nr. 5
STOW MS-93 MIXER — PARTS ORDERING PROCEDURES When ordering parts, please supply the following information: ❒ Dealer account number ❒ Dealer name and address ❒ Shipping address (if different than billing address) ❒ Return fax number ❒ Applicable model number ❒ Quantity, part number and description of each part ❒ Specify preferred method of shipment: ✓ FedEx or UPS Ground Note: u nless otherwise indicated by customer, all orders are treated as “s tandard Orders”, and will ✓ FedEx or UPS S
Inhaltszusammenfassung zur Seite Nr. 6
STOW MS-93 PLASTER/MORTAR MIXER — SPECIFICATIONS Table 1. STOW MS-93 Mixer Specifications Capacity 9.3 cu. ft (263 liters) Bag Capacity 2-1/2 to 3-1/2 Bags Length Without Tow Bar 42 in. (107 cm.) Length Tow Bar 36 in. (91 cm.) Width 29 in. (74 cm.) Height W/Dump Handle 76 in. (193 cm.) Discharge Height 75 in. (191 cm.) Drive V-Belt/Gear Dump Action Manual Weight Approx. 693 lbs. (314 kg.) Table 2. Specifications (Engine & Electric Motor) Model HONDA GX240K1HA2 BALDOR 35LYS733 Air-cooled 4 stro
Inhaltszusammenfassung zur Seite Nr. 7
STOW MS-93 PLASTER/MORTAR MIXER — DIMENSIONS TABLE 3. DIMENSIONS Description Dimensions in. (cm) Length 67 in. (170 cm) (w/ Tow Bar) Width 50 in. (127 cm) Height 56 in. (142 cm) Figure 1. Dimensions STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10) — PAGE 7
Inhaltszusammenfassung zur Seite Nr. 8
STOW MS-93 MIXER — SAFETY MESSAGE ALERT SYMBOLS HAZARD SYMBOLS FOR YOUR SAFETY AND THE SAFETY OF OTHERS! Potential hazards associated with the operation of a MT-84f Safety precautions should be followed Tamping rammer will be referenced with Hazard Symbols at all times when operating this equip- ment. Failure to read and understand which appear throughout this manual, and will be referenced Lethal Exhaust Gases the Safety Messages and Operating in conjunction with Safety Message Alert
Inhaltszusammenfassung zur Seite Nr. 9
STOW MS-93 MIXER — SAFETY MESSAGE ALERT SYMBOLS Equipment Damage Rotating Parts Hazards CAUTION CAUTION Hazards NEVER operate equipment with covers, Other important messages are provided throughout this or guards removed. Keep fingers, hands, manual to help prevent damage to your light tower, other hair and clothing away from all moving property, or the surrounding environment. parts to prevent injury. Accidental Starting Hazards CAUTION ALWAYS disconnect the electrical power cord
Inhaltszusammenfassung zur Seite Nr. 10
STOW MS-93 PLASTER/MORTAR MIXER — RULES FOR SAFE OPERATION ■ NEVER touch the hot exhaust mani- Read this manual! fold, muffler or cylinder. Allow these DANGER parts to cool before servicing engine Failure to follow instructions in this manual may lead or mixer. to serious injury or even death! This equipment is to be operated by trained and qualified personnel only! This equipment is for industrial use only. The following safety guidelines should always be used ■ High Temperatures – Al
Inhaltszusammenfassung zur Seite Nr. 11
STOW MS-93 PLASTER/MORTAR MIXER — RULES FOR SAFE OPERATION TRANSPORTING ■ ALWAYS stop the engine before servicing, adding fuel and oil. ■ ALWAYS shutdown engine before transporting. ■ NEVER run engine without air filter. Severe engine may ■ Tighten fuel tank cap securely and close fuel cock to occur. prevent fuel from spilling. ■ ALWAYS service air cleaner frequently to prevent carbure- ■ Drain fuel when transporting mixer over long distances tor malfunction. or bad roads. ■ ALWAYS che
Inhaltszusammenfassung zur Seite Nr. 12
STOW MS-93 PLASTER/MORTAR MIXER — SAFETY CHAIN CONNECTION STOW MS-93 PLASTER/MORTAR MIXER — TOWING GUIDELINES Towing Safety Precautions ■ ALWAYS make sure that the fuel valve lever is in the OFF position (gasoline models only). Regularly Inspect ■ Check wheel mounting lug nuts with a torque wrench. CAUTION Towing Components Torque wheel lug nuts as described in the maintenance To reduce the possibility of an accident while transport- section of this manual. ing the mixer on public roads,
Inhaltszusammenfassung zur Seite Nr. 13
STOW MS-93 PLASTER/MORTAR MIXER — SAFETY CHAIN CONNECTION 2. Route the safety chain through the holes just above the Always Tow with CAUTION tow bar, located on each side of the mixer stand. a Safety Chain Loop the chain together and place under the tow bar. NEVER! tow the mixer with the safety chain removed. The Secure the loop with the connector link. safety chain is intended to prevent complete separation of the mixer from the towing vehicle in the event of a tow 3. extend the safety
Inhaltszusammenfassung zur Seite Nr. 14
MS-93 PLASTER/MORTAR MIXER — OPERATION AND SAFETY DECALS Machine Safety Decals The STOW MS-93 mortar and plaster mixer is equipped with a number of safety decals. These decals are provided for operator safety and maintenance information. Figure 4 below illustrates these decals as they appear on the machine. Should any of these decals become unreadable, replacements can be obtained from your dealer. Figure 4. Mixer Operation and Safety Decals PAGE 14 — STOW MS-93 MIXER — OPERATION MANUAL — RE
Inhaltszusammenfassung zur Seite Nr. 15
STOW MS-93 PLASTER/MORTAR MIXER — GENERAL INFORMATION Application Ensure that the extension cable is carefully laid out avoiding wet areas, sharp edges and locations where vehicles might The STOW MS-93 series mixers (drum capacity of 9.0 cu. ft./263 liters) are shipped completely assembled and have been run over it. Avoid allowing the extension cable to be trapped factory tested and are ready for use. underneath the mixer. This mixer is only intended for the production of plaster and Unrol
Inhaltszusammenfassung zur Seite Nr. 16
STOW MS-93 PLASTER/MORTAR MIXER — BASIC MIXER COMPONENTS 8. Mixing Paddles — Used in the mixing of material. This unit uses four different types of paddles to provide a fast uniform mix. 9. Bag Cutter— This feature allows compound mixing bags to be opened easily, therefore allowing the contents of the bag to fall directly into the mixing drum. 10. Safety Grill — Provided for operator safety. This safety grill is designed to keep hands and solid objects out of the mixing drum when in use.
Inhaltszusammenfassung zur Seite Nr. 17
STOW MS-93 PLASTER/MORTAR MIXER — BASIC ENGINE COMPONENTS Figure 6. Engine Controls and Components 5. Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop INITIAL SERVICING the flow of fuel. The engine (Figure 6) must be checked for proper lubrication 6. Choke Lever – Used in the starting of a cold engine, or and filled with fuel prior to operation. Refer to the manufactur- in cold weather conditions. The choke enriches the fuel ers Engine manual for instructions & details of operation
Inhaltszusammenfassung zur Seite Nr. 18
STOW MS-93 PLASTER/MORTAR MIXER — ELECTRIC MOTOR Electric Motor Table 5. Electric Motor Wiring Information For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with Motor 115-230 VAC - Single Phase the motor. Horsepower NEMA Plug Connector Mating NEMA Rating Protect the electric motor from dust as much as possible and Receptacle Connector keep ventilating openings clean. 2.0 HP L5-20P P/N EM940537 L5-20R P/N EM940538 (115 VAC) E
Inhaltszusammenfassung zur Seite Nr. 19
STOW MS-93 PLASTER/MORTAR MIXER — ELECTRIC MOTOR The motor supplied is wired for 115 VAC grounded operation. Table 6. Recommended Extension Cord Sizes s s s s Make certain that the correct size grounded (3-wires) extension cord is used. See Table 6. 50 ft. 75 ft. 100 ft. 200 ft. Model Motor Voltage (15.24 m) (22.86 m) (30.48 m) (60.96 m) Motors can burn out when the line voltage falls 10% below the voltage rating of the motor. Failure to use proper voltage will 115 No. 12 No. 10 No. 8 No. 6
Inhaltszusammenfassung zur Seite Nr. 20
STOW MS-93 — PADDLE BLADE ADJUSTMENT (STEEL DRUM) Adjust paddles as shown in Figure 8. Figure 8. Paddle Blade Adjustment, Steel Drum PAGE 20 — STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10)
