Inhaltszusammenfassung zur Seite Nr. 1
PGXD Wireless System
Shure PGXD Wireless
PGXD sans fil de Shure
Shure PGXD Sem Fio
©2010 Shure Incorporated
27B14513 (Rev. 2)
Printed in U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
Inhaltszusammenfassung zur Seite Nr. 4
D D D D
Inhaltszusammenfassung zur Seite Nr. 5
D D D
Inhaltszusammenfassung zur Seite Nr. 6
D
Inhaltszusammenfassung zur Seite Nr. 7
System Components PGXD All systems include PGX Digital Wireless Systems • PGXD4 receiver • 2 AA alkaline batteries Offering uniquely tailored wireless solutions for • Power supply vocalists, guitarists, and presenters, PGX-Digital • User guide combines the trusted legacy of Shure wired microphones with state-of-the-art, 24-bit digital Vocalist systems include wireless technology to deliver strong, clean RF • PGXD2 handheld transmitter performance. The result is wireless audio that sounds
Inhaltszusammenfassung zur Seite Nr. 8
⑧ Adapter cord tie-off ⑩ 6.35 mm (1/4”) instrument level output jack MIC INSTRUMENT ⑦ AC adapter jack ⑨ XLR microphone output jack Transmitter Controls and Connectors PGXD2 ① Indicator LED Displays battery level, mute, and IR transmission status (see table). PGXD ② Power / Mute Switch Press to mute or unmute. Press and hold to power on or off. PGXD ③ Infrared (IR) port Receives infrared beam to synchronize frequencies. When using multiple systems, only one transmitter IR port should be expo
Inhaltszusammenfassung zur Seite Nr. 9
Batteries Wearing the Bodypack Transmitter • A fresh set of alkaline batteries lasts up to 10 Clip the transmitter to a belt or slide a guitar strap hours (9 hours, PGXD2). through the transmitter clip as shown. • The transmitter LED and the receiver ready For best results, slide the transmitter until the belt is LED glow red to indicate low battery (typically pressed against the base of the clip. less than 60 minutes remaining). • NiMH rechargeable batteries may be used. However, the low b
Inhaltszusammenfassung zur Seite Nr. 10
Single System Setup Scan Synchronize Use the scan feature on the receiver to Synchronize the transmitter to the receiver by aligning the find a clear channel. infrared (IR) ports and pressing the sync button. Make sure the IR ports are closely aligned. After a successful sync, the transmitter LED momentarily flashes red and the receiver ready light illuminates. LED screen displays current channel press channel button to scan for a c h a n n e l clear channel NOTE: This wireless system may
Inhaltszusammenfassung zur Seite Nr. 11
Manual Channel and Group Selection (receiver only) Using the receiver to scan for a channel is the best way to find the best frequency for your system. However, for multiple system setup, you may need to manually set the group number. 1. Press and hold the channel button. 2. Hold the button until the channel or group display begins flashing. 3. Release and press the button again to advance the setting. At the desired channel or group number, wait for the flashing to stop. This activates the
Inhaltszusammenfassung zur Seite Nr. 12
Troubleshooting Issue Indicator Status Solution No sound or faint Receiver ready LED on Verify all sound system connections sound Receiver ready LED off • Turn on transmitter • Make sure the batteries are installed correctly • Perform automatic transmitter setup • Insert fresh batteries Receiver LED screen off Make sure AC adapter is securely plugged into electrical outlet Transmitter indicator LED Replace transmitter batteries. flashing red LED screen shows dash Error code displayed. Contact
Inhaltszusammenfassung zur Seite Nr. 13
SPECIFICATIONS Working Range (Line of Sight) PGXD2 Handheld Transmitter 60 m (200 ft) Audio Input Level Note: Actual range depends on RF signal absorption, reflection +5 dBV maximum at -10 dB gain position and interference. –5 dBV maximum at 0 dB gain position RF Carrier Range Gain Adjustment Range X8: 902–928 MHz 10 dB X8A: 915–928 MHz RF Output Power X8B: 902–907.5 MHz, 915–928 MHz 10 mW Note: varies by region varies by region Audio Frequency Response Dimensions 20–20000 Hz 254 mm X 51
Inhaltszusammenfassung zur Seite Nr. 14
CERTIFICATION PGXD1, PGXD2, PGXD4 This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Certified by IC in Canada under RSS-210 and RSS-102. (IC: 616A-PGXD1, 616A-PGXD2, 616A-PGXD4). PGXD1, PGXD2 Certified under FCC Part 15. (FCC ID: DD4PGXD1, DD4PGXD2). PGXD4 Approved under the Declaration of Conformity (DoC) provision of FCC Part 15. Operation of this device is subject to the following two con
Inhaltszusammenfassung zur Seite Nr. 15
Inhaltszusammenfassung zur Seite Nr. 16
Inhaltszusammenfassung zur Seite Nr. 17
Inhaltszusammenfassung zur Seite Nr. 18
United States, Canada, Latin United States, Canada, Latin United States, Canada, Latin Europe, Middle East, Africa: Europe, Middle East, Africa: Europe, Middle East, Africa: Asia, Pacific: Asia, Pacific: Asia, Pacific: America, Caribbean: Shure Europe GmbH Shure Europe GmbH Shure Europe GmbH America, Caribbean: America, Caribbean: Shure Asia Limited Shure Asia Limited Shure Asia Limited Shure Incorporated Shure Incorporated Shure Incorporated Wannenäckestr W . 28, annenäckestrW . 28, annenäckest
