Inhaltszusammenfassung zur Seite Nr. 1
OWner’S ManUal
UWS-100
100-Channel Select UHF Wireless System
Inhaltszusammenfassung zur Seite Nr. 2
Contents System Features Introduction ............................................................................................................................. 2 UWS-100 System • UHT-100 Handheld Mic Transmitter Using this Manual .................................................................................................................... 2 • Unsurpassed state-of-the-art PLL UHF • Off/On/Mute power switch allows performance with 120dB dynamic range convenient audio muting with the Sy
Inhaltszusammenfassung zur Seite Nr. 3
1. DUAL ANTENNAS Permanently mounted. 8. DC INPUT JACK For connecting external AC/DC Quick User Controls Guide Rotate to 45° as shown for optimal reception adapter to power receiver (DC15VDC/400mA) 2. SELECT BUTTON Press once quickly to start 9. POWER ROCKER SWITCH Press right side to turn UWS-100 receiver: Front View the Auto Scan function to search for an On or press left side to turn Off receiver. The interference-free channel. Press and hold Channel Display (3) is lit when the unit i
Inhaltszusammenfassung zur Seite Nr. 4
Quick User Controls Guide Quick User Controls Guide UHT-100 Handheld Transmitter: Front and Back UB-100 Bodypack Transmitter 40 24 41 15 16 17 18 25 26 16A 42 16C 16B 19 20 27A 27 27B UBT-100 28 29 IR 21 22 ™ ASC SYSTEM 23 30 31 15. MIC BALL Windscreen 19. BATTERY COMPARTMENT Holds two AA alkaline 24. ANTENNA Removable antenna—should be 29. IR RECEPTOR SENSOR Infrared LED sensor for or NiMH batteries—observe correct polarity attached during operation linking the transmitter to the receiver
Inhaltszusammenfassung zur Seite Nr. 5
System Operation Press the Select button for one second adjusting the Squelch Instructions for Setup of Simultaneous UWS-100 receiver to start the 100 channel (00-99) Autoscan Multichannel Operation The MUTe leVel/rF SQUelCH (13) controls for open frequencies. A running bar in a the mute circuits in the receiver. The The UWS-100 receiver is capable of clockwise direction shows the scanning powering the r eceiver control should be adjusted clockwise to finding an open channel with its A
Inhaltszusammenfassung zur Seite Nr. 6
is controlled by the VOlUMe COnTrOl (12). simultaneous multichannel operation. Ir Sync programming UHT-100 Handheld Select the level for your application Use the wireless Ir r eCepTOr Sen SOr For unbalanced line output connection, plug Microphone Transmitter accordingly. A range walk test will WInDOW (17) infrared LED to download an audio cable with a ¼” mono (Tip/Sleeve) determine if the LO setting is adequate. pre-programmed channels from the receiver. plug into the Unbalanced Line Out
Inhaltszusammenfassung zur Seite Nr. 7
or somehow shield the link from outside light to batteries according to the correct polarity as Operating the UHT-100 programming the UBT-100 successfully program the transmitter with the indicated on the transmitter body. Slide the Handheld Transmitter to the Selected Channel pre-programmed group and channel info from battery compartment door back onto the The OFF/STBy/On pOWer SWITCH (18) has The transmitter must be programmed to the the receiver. transmitter, making sure it is secure.
Inhaltszusammenfassung zur Seite Nr. 8
After the unit is powered on, slide the power slide the power switch to STBY again. Adjust If you encounter slight receiving interference when the transmitter is far from the receiver switch to the ON position to un-mute the the volume of the receiver per the previous (from other than an operating TV station audio or to STBY to mute the audio. Set the section, Connecting the Audio Output. on the same frequency), it can often be power switch accordingly and the transmitter Note: Avoid acous
Inhaltszusammenfassung zur Seite Nr. 9
• If rackmounting the receiver, keep away Miscellaneous Tips Specifications from heat sources such as amps by • The receiver antennas should be kept allowing enough space between them for OVerall SySTeM perFOrManCe away from any metal surfaces whenever adequate ventilation. Operating Frequency range 667.0MHz-696.7MHz (U.S.) possible as they can reflect away or shield Freq. Synthesized (100 channels switchable) 300kHz/step • For the best operation, the receiver should pll system frequency st
Inhaltszusammenfassung zur Seite Nr. 10
Frequency Plan One Year Limited Warranty Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from Band 1: 667.000-696.700MHz (U.S.) any defects in material or workmanship for a period of one year from the date of original 100 Channels / 300 KHz per step retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or Channel 0 1 2 3 4
Inhaltszusammenfassung zur Seite Nr. 11
| 6701 Shellmound Street Emeryville, CA USA 94608 | | T 510.652.2411 F 510.652.5075 www.nady.com
