Bedienungsanleitung Memorex MKA381

Inhaltszusammenfassung zur Seite Nr. 1

MKA381
User’s Guide
Wireless Microphone
Before operating this product,
please read these instructions completely.

Inhaltszusammenfassung zur Seite Nr. 2

SAFETY PRECAUTIONS FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there

Inhaltszusammenfassung zur Seite Nr. 3

LOCATION OF CONTROLS MICROPHONE 1 2 3 RECEIVER FRONT RECEIVER 4 5 6 REAR 7 8 9 10 1. POWER Indicator 6. POWER ON/OFF Switch 2. Microphone 7. Antenna ON/STANDBY/OFF Switch 8. Battery Compartment 3. Battery Compartment (Bottom of Receiver) 4. Microphone ON Indicator + 9. DC 4.5V Jack - 5. POWER ON Indicator 10. Line OUT Jack 2

Inhaltszusammenfassung zur Seite Nr. 4

INSTALLATION REPLACING THE BATTERIES If the sound quality starts to become poor or the receiving distance has shortened, replace the batteries in the microphone and the receiver as follows: INSTALLING THE BATTERY INTO THE MICROPHONE 1 2 Insert one 9V battery, making sure to Remove the battery cover at the observe the correct polarity (+/–). bottom of the microphone by twisting Twist the battery cover clockwise to it counterclockwise. put it back on. INSTALLING THE BATTERIES INTO THE RECEIVER 1 2

Inhaltszusammenfassung zur Seite Nr. 5

OPERATION USING YOUR MICROPHONE (TRANSMITTING) To use your microphone, please see the following: 1 2 Insert the large end of the cord into the Slide the Microphone ON/STANDBY/ Microphone jack on the unit you are OFF switch to the ON position; the connecting this wireless microphone POWER indicator on the microphone to, and the small end into the Line OUT will light. jack on the receiver. 3 4 Slide the Receiver’s POWER switch Slide the Microphone ON/STANDBY/ to the ON position; the red POWER OF

Inhaltszusammenfassung zur Seite Nr. 6

SPECIFICATIONS Power Requirement Receiver .........................DC 3V, 2 X LR6 “AA” Alkaline Battery Microphone..........................................................DC 9V Battery Frequency ..............................................................171.045MHz Receive Distance...................................................................7m Specifications subject to change without notice. FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT OUR WEBSITE AT WWW.MEMOREXELECTRONIC

Inhaltszusammenfassung zur Seite Nr. 7

Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.com