Bedienungsanleitung ATN Night vision Monocular MO-4

Inhaltszusammenfassung zur Seite Nr. 1

MO-4
u s e r ` s g u i d e
AMERICAN
TECHNOLOGIES
NETWORK
CORP.

Inhaltszusammenfassung zur Seite Nr. 2

ON/OFF indicator light IR indicator light Computerized proximity sensor 5 Diopter Digital control for Proximity Sensor 3V lithium battery Power button Digital control for IR Built-in infra-red (IR) illuminator 90mm F 1.2 lens for maximum clarity Objective lens protective cover Camera adapter Doubler The information in this manual furnished for information use only, is subject to change without notice, is not to be construed as a commitment by ATN Corp. ATN Corp. assumes no responsibility or

Inhaltszusammenfassung zur Seite Nr. 3

APPLICATION The Night vision Monocular is a complex opticoelectronic system for individual use. The device consists of the objective lens assembly, eyepiece and the body. The body contains a 1st (MO-41) or 2nd Gen. + (MO-42) image intensifier tube assembly with an integrated high voltage power source and the three volt battery housing. When installing the battery one should keep in mind that the polarity of the battery should coincide with the diagram on the body next to the battery housing

Inhaltszusammenfassung zur Seite Nr. 4

You may desire a different field of coverage from the IR illuminator, if so, the beam is focus- able. By turning the lens of the IR illuminator you will slightly change the beam width. NOTE: The IR will automatically turn off when the unit’s main power switch is turned to the OFF position. LOW BATTERY INDICATOR The low battery indicator is another feature that is programmed into your “Smart” scope. If the batteries start losing voltage LED “B” will start to pulse, it is time to change your ba

Inhaltszusammenfassung zur Seite Nr. 5

OPERATION • Take the monocular out of the case. • Install the batteries into the housing with the polarity order as shown on the scope. Battery type: 3 Volt Lithium, #CR123A • Press the button marked -/O to turn unit on with the protective lens cover still attached to the lens. Do not turn unit on in the daytime without the protective lens cap on. You should see a green glow in the eyepiece. • Observe the scene and adjust the diopter for the optimal image clarity. • You may now enter a dark e

Inhaltszusammenfassung zur Seite Nr. 6

• Do not disassemble except to clean the front lens and eyepiece, install the 6x Doubler or any other “C” mount lens: it will void your warranty. • Evaluate the scopes function by looking through it in a lit environment with the daylight filter lens cap on. Never use in daylight without the daylight filter lens. • Never point the MO-4 at a bright light source. • Adverse atmospheric conditions such as fog, smog or haze and a lack of ambient light (moon or starlight) may diminish the effective

Inhaltszusammenfassung zur Seite Nr. 7

2 YEAR PRODUCT WARRANTY This product is guaranteed to be free from manufacturing defects in material and workmanship under normal use for a period of 2 (two) years from the date of purchase. In the event a defect that is covered by the foregoing warranty occurs during the applicable period stated above, ATN, at its option, will either repair or replace the product, and such action on the part of ATN shall be the full extent of ATN’s liability, and the Customer’s sole and exclusive remedy.

Inhaltszusammenfassung zur Seite Nr. 8

For customer service and technical support, please contact American Technologies Network Corp. North American Office 20 S. Linden Ave. Suite 1B, South San Francisco, CA 94080 phone: 800-910-2862, 650-875-0130; fax: 650-875-0129 European Office phone: 44(0)870-0111286, fax: 44(0) 845-3349142 The following countries can use our toll free number 00 800 9102-8620 Austria, France, Germany, Holland, Italy, Spain, Sweden, Switzerland www.atncorp.com ©2001 ATN Corporation