Inhaltszusammenfassung zur Seite Nr. 1
Safety • Assembly • Operation • Tips & Techniques • Maintenance • Troubleshooting • Parts Lists • Warranty
OPERATOR’S MANUAL
21” Rotary Mower — Model Series 410 thru 420
IMPORTANT
READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable lo
Inhaltszusammenfassung zur Seite Nr. 2
This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Table of Contents Slope Gauge........................................................ 3 Troubleshooting ................................................ 12 Safe Operation Practices ................................... 4 Safety Labels .................................................... 13 Setup and Adjustment
Inhaltszusammenfassung zur Seite Nr. 3
Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes. 1 Slope Gauge WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk- behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury. Operate RID
Inhaltszusammenfassung zur Seite Nr. 4
WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm. 2 DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing Safe
Inhaltszusammenfassung zur Seite Nr. 5
19. Shut the engine off and wait until the blade comes to a 6. Extinguish all cigarettes, cigars, pipes and other sources complete stop before removing the grass catcher or unclog- of ignition. ging the chute. 7. Never fuel machine indoor because flammable vapors will The cutting blade continues to rotate for a few seconds after accumulate in the area. the engine is shut off. Never place any part of the body in 8. Never remove gas cap or add fuel while engine is hot or 2 the blade area u
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the accompanying engine manual BEFORE operat- ing your mower. A 3 1. Remove any packing material which may be between upper and lower handles. Setup and a. Pull up and back on upper handle as shown in Figure 3-1. Make certain the lower handle is seated Adjustment securely into the handle mounting brackets. Do not crimp cable while lifting the handle up. b. Tighten star knobs s
Inhaltszusammenfassung zur Seite Nr. 7
5. Follow steps below to assemble the grass catcher (if needed). Make certain bag is turned right side out before assembling (warning label will be on the outside). 3 a. Place bag over frame so that its black plastic side is at the bottom. A b. Slip plastic channel of grass bag over hooks on Setup and the frame. See Figure 3-5. All the plastic channels except center top of bag attach from outside of Adjustment bag. c. Attach center top of bag from inside of bag. C 6. Follow steps below
Inhaltszusammenfassung zur Seite Nr. 8
Know Your Lawn Mower Blade Control 4 Operating Your Lawn Mower Recoil Starter Cutting Height Adjustment Levers (one at each wheel) WARNING The blade control is a safety device. DO NOT bypass its operations. Use extreme care when handling gasoline. Figure 4-1: The main components on the mower. Gasoline is extremely flammable and the vapors Now that you have setup your lawn mower, its important to become acquainted with its controls and features. are explosive. Never fuel the machine in
Inhaltszusammenfassung zur Seite Nr. 9
Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower 2 while starting engine or operating mower. Never 4 run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine Operating and lawn mower. Your Lawn Follow the set of instructions pertaining to your unit. Refer to engine manual for help with the e
Inhaltszusammenfassung zur Seite Nr. 10
Lubrication • Lubricate pivot points on the blade control at least once a season with light oil. The blade control must operate freely in both directions. See Figure 5-1. • Lubricate the wheels at least once a season with light oil (or motor oil). If wheels are removed for any reason, lubricate surface of the pivot arm and inner Maintaining surface of the wheel with light oil. See Figure 5-1. • Lubricate the torsion spring and pivot point on the rear Your Lawn discharge door periodical
Inhaltszusammenfassung zur Seite Nr. 11
Blade Care WARNING: When removing the cutting blade for sharpening or replacement, protect your hands with a pair of heavy gloves or use a heavy rag to hold the blade. Blade Blade Adapter Maintaining Periodically inspect the blade adapter for cracks, especially if you strike a foreign object. Replace when Bell Blade Your Lawn necessary. Follow the steps below for blade service. Support Hex Bolt 1. Disconnect spark plug wire from spark plug. Turn Mower mower on its side making sure th
Inhaltszusammenfassung zur Seite Nr. 12
Remedy Cause Problem Engine fails to start 1. Blade control disengaged. 1. Engage blade control. 6 2. Spark plug wire disconnected. 2. Connect wire to spark plug. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Engine not choked. 4. Choke engine as instructed in the “Operating Your Lawn Mower” section. Trouble 5. Clean, adjust gap, or replace. 5. Faulty spark plug. 6. Clean fuel line. 6. Blocked fuel line. Shooting 7. Wait a few minutes to restart, but do 7. Engi
Inhaltszusammenfassung zur Seite Nr. 13
Safety Label Found On Your Lawn Mower 7 Safety Labels TO REDUCE THE RISK OF INJURY, DO NOT OPERATE UNLESS DISCHARGE COVER OR GRASS CATCHER IS IN ITS PROPER PLACE. IF DAMAGED, REPLACE IMMEDIATELY. MAX 15 ˚ KEEP HANDS and FEET AWAY • DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND. AVOID SERIOUS INJURY OR DEATH • USE EXTRA CAUTION ON SLOPES. DO NOT • KEEP HANDS AND FEET AWAY FROM MOW SLOPES GREATER THAN 15 MOW ˚ ROTATING PARTS. ACROSS, NEVER UP AND DOWN. NEVER PULL MOWER CLOSE TO YOUR FEET. LO
Inhaltszusammenfassung zur Seite Nr. 14
Model Series 410 & 420 1 9 12 2 11 4 3 10 6 5 13 14 15 7 8 17 19 20 18 22 21 38 16 41 35 23 40 29 39 24 36 35 29 37 34 33 30 33 31 29 25 29 27 32 26 28 Wheel Treads Pin Bar Tread Zag Tread S-WaveTread K2 Tread 14
Inhaltszusammenfassung zur Seite Nr. 15
1 747-1161A Blade Control 687-02074A Ht. Adj. Assy. Front - RH (8” Wheel) 2 749-1092A Upper Handle 687-02099A Ht. Adj. Assy. Front - LH (7” Wheel) 3 710-1205 Rope Guide 687-02100A Ht. Adj. Assy. Front - RH (7” Wheel) 8 4 720-0279 Wing Nut, 1/4-20 24 782-5002B Front Baffle 5 710-1174 Carriage Bolt, 5/16-18 x 2 25 748-0377C Blade Adapter 6 720-04072 Hand Star Knob 26 742-0641 Standard Blade Parts List 7 749-0928A Lower Handle 742-0741† Mulch Blade 8 712-0397 Wing Nut, 1/4-20 27 736-0524B Blade Bel
Inhaltszusammenfassung zur Seite Nr. 16
MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by MTD LLC with respect e. MTD does not extend any warranty for products sold or exported to new merchandise purchased and used in the United States, its outside of the United States, its possessions and territories, except possessions and territories. those sold through MTD’s authorized channels of export distribution. “MTD” warrants this product against defects in material and workman- f. Replacement parts tha
