Inhaltszusammenfassung zur Seite Nr. 1
®
O m m 'W//////aI&_AIIIIIIIIIIIIIF
/ m mllllllllllllllllml m
Operator's Manual
Rear-tine Tiller Models
630C--Tuffy ¢
634AmSuper Bronco TM
634KmProLine
Mode1634A Shown
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine's exhaust system is equipped with a spark attester meeting app
Inhaltszusammenfassung zur Seite Nr. 2
TABLEOFCONTENTS Content Page Content Page Customer Support 2 Maintenance 17 Safety 3 Off-season Storage 21 Assembly 6 Troubleshooting 22 Features and Controls 10 Parts List 23 Operation 12 Warranty Back Cover FINDINGMODELNUMBER This Operator's Manual is an important part of your new lawn tractor. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Before you start assembling your new equipment, please locate the model plate on t
Inhaltszusammenfassung zur Seite Nr. 3
SECTION 1: SAFETY This machine meets voluntary safety stan- dard B71.8-1996, which is sponsored bythe Outdoor Power Equipment Institute, Inc., and is published by the American National Standards Institute. ForwardClutchBail Reverse ClutchControl (Models634A) WARNING DepthRegulator The engine exhaust from this productcontains chemicals known to the State of California to TineHoodFlap cause cancer, birth defects or other reproduc- SafetyAlertSymbol in this manual and on the unit to alert Standard-
Inhaltszusammenfassung zur Seite Nr. 4
4.Exercise caution toavoid slipping orfall- If indoubtaboutthetilling conditions, al- 24. Do not touch engine parts which may ing. ways usethe following operating precau- behot from operation.Let parts cool down tionsto assistyouin maintainingcontrol sufficiently. 5.Iftheunitshould start tovibrate abnor- of the tiller: 25. Pleaseremember:Youcan alwaysstop mally, stoptheengine, disconnect the a. Walk behindandto one side of the spark plug wireandprevent itfromtouch- the tines and wheels by releas
Inhaltszusammenfassung zur Seite Nr. 5
Decals ReverseClutch Control Forward ClutchBail For your safety and the safety of others, vari- OperatingInstruction (Models 634A) ous safety and operational decalsare located on your unit (seeFigure 1-2). Keepthe decalsclean and legible at all times. StartingStabilization Contactyour local service dealeror thefactory Message (on engine) for replacementsif any decalsaredamagedor missing. WarningMessages Referto the Parts List pagesin this Manualfor decal locations, descriptions and part num- ber
Inhaltszusammenfassung zur Seite Nr. 6
SECTION 2: ASSEMBLY ASSEMBLY STEPS WARNING: Toprevent personal injury or property STEP 1: UNPACKING INSTRUCTIONS damage,do not start the engine _iiii NOTE:While unpacking, do not severely until all assemblysteps are bend any control cables. complete andyou have read and understandthe safety and 1. The tiller weighs approximately 133 Ibs. operating instructions in this Do not attempt to remove it from the ship- manual. ping platform until instructed to do so in these Assembly steps. INTRODUCTION
Inhaltszusammenfassung zur Seite Nr. 7
°-! ° Fig. 2-3: Wheel in FREEWHEEL position A STEP 4: INSTALL FORWARD CLUTCH CABLE 1. Carefully unwrap the forward clutch ca- ble(cable without an attached knob) from its shipping position and slide the thin ca- blewire (T,Fig. 2-4) into the slot in the ca- blebracket. Push the cable connector (U, Fig.2-4) upthrough the holein the bracket until the groove in the connector snaps into place. 2. Threadthe #10-24 hex nut (Z, Fig. 2-5) halfway onto the screw (V) which runs J through the spring (W, Fi
Inhaltszusammenfassung zur Seite Nr. 8
4. Checkfor correct tension onthe forward drive belt by taking two measurements of the cable spring, as follows: a. With the Forward Clutch Bail (Y,Fig. 2- 6) in an open (released)position, measure the length of the cable spring (W) from the outermost coil to the outermost coil. b. Squeeze the ForwardClutch Bailagainst the handlebar(see Fig. 2-7) and re-mea- sure the spring length. The belt tension is correct if this second measurementis be- tween 1/16" to 3/16" longer than the first measurement
Inhaltszusammenfassung zur Seite Nr. 9
5! 6: CHECK TRAHSMiSSiOH I El-'/: AUU IVlUI UH UIL _1 El-' 8: I.;HEI.;K HAHUWAHE OIL LEVEL Thetiller is shipped withoutoil in the en- Checkall nuts and screws for tightness. gine. Thetransmission was filled with gearoil at STEP g: CHECK AIR PRESSURE IN the factory. However,you should checkthe IMPORTANT:Do not start the engine with- TIRES (unitswithpneumatictires) gear oil level at this time to makecertain it out first adding motor oil. Severeengine Checkthe air pressurewith a tire gauge. is corr
Inhaltszusammenfassung zur Seite Nr. 10
SECTION 3: FEATURES ANDCONTROLS operating your machine, _ ARNING: Before carefully readand understand all safety, controls and operating instructions in this Manual,the separateEngine ForwardClutch Bail ReverseClutchControl Owner's Manual,and on the decalson the machine. Failureto follow these (Model 634A) instructions can result in serious personal injury. gulator INTRODUCTION HandlebarHeight Adjustment This Section describes the location and function of the controls on your tiller. Refer to th
Inhaltszusammenfassung zur Seite Nr. 11
begintilling at avery shallow depth setting and gradually increasethe tilling depth. _--'i_ caution when reversing or _ WARNING: Useextreme A pulling the machinetowards Y ,,_- D you. Look behindto avoid to till too deeplytoo quickly. _b ARNING: Do not attempt obstacles. Graduallywork down to deeper Neverattemptto till in reverse. tilling depths. Failureto follow this warning Placethe DepthRegulator could result in personal injury Lever in the "travel" position or property damage. before starting
Inhaltszusammenfassung zur Seite Nr. 12
SECTION 4: OPERATION 1. Completethe Pre-StartCheckliston this Reverse Clutch Control page. operating your machine, _ ARNING: Before (Model634A) carefully readand understand 2. Putthe wheels inthe WHEELDRIVEpo- all safety (Section 1), controls sition (see WheelDrivePinsin Section3 of (Section 3) and operating this manual). instructions (Section4) inthis Manual,the separateEngine ClutchBail preventserious personal injury ,_ WARNING: Tohelp ,epthRegulator Owner's Manual,and on the or damageto equip
Inhaltszusammenfassung zur Seite Nr. 13
4. For forwardmotion of the wheels and (b) Swing the handlebarto the left so the tines: right wheeltakes a "step" backward.Next (a) Pull Forward Clutch Bail (Fig.4-1) up swing the handlebarto the right so the left against handlebar.Releasebail to stop for- wheel"steps" backward.Repeatas needed. ward motion of wheels and tines. (c) If longer distances needto becovered in reverse,shut off the engine, then place (b) When tilling, relaxand let the wheels the two wheels in FREEWHEEL. pull the unit wh
Inhaltszusammenfassung zur Seite Nr. 14
TILLINGTIPS& TECHNIQUES • Avoid pushing down on the handlebarsinan attemptto forcethe tiller to dig deeper.Doing Tilling Depths sotakesthe weightoff the poweredwheels,causingthemto losetraction.Without the wheels helpingto holdthe tiller back,the tineswill attemptto propelthe tiller- oftencausingthe tiller WAHNINL_: Before to skip rapidly acrossthe ground. (Sometimes,slight downwardpressureonthe handlebars tilling, contact your will helpgetthrough a particularlytough sectionof sod or unbrokengro
Inhaltszusammenfassung zur Seite Nr. 15
TILLINGTIPS& TECHNIQUES (CON'T) PowerComposting Powercompostingsimply meanstilling underandburying in the soil all mannerof organic WAHNIN(3: When power matter suchas crop residues,leaves,grassclippingsand covercrops. Thismaterialwill de- composting, do not keepthe composeduring the non-growingseasonandadd importantnatural nutrientsto the soil. DepthRegulator Leverat a deepsetting if the tiller jumps Thefirst placeto beginis with crop residuessuchas leftovervines, stalks,stemsandroots. or bucks.
Inhaltszusammenfassung zur Seite Nr. 16
TILLINGTIPS& TECHNIQUES (CON'T) TerraceGardening(continued) • Tocreateaterrace,start at the top of the slopeandwork down.Gobackandforth acrossthe first row as shownin Fig.4-10. • Eachsucceedinglowerterraceis started bywalking belowthe terraceyou're pre- paring.Foraddedstabilityof thetiller,alwayskeepthe uphillwheelinthe soft,new- ly tilled soil. Do not till the last 12" or more of the downhill outsideedgeof each terrace. This untilled strip helps prevents the terracesfrom breakingapart and washi
Inhaltszusammenfassung zur Seite Nr. 17
SECTION 5: MAINTENANCE WARNING: Before TILLERLUBRICATION If acover is leaking,check for loose screws. If the screws aretight, a new inspecting, cleaning or servicing After every 10 operating hours, oil or gasket or oil seal may be required. the machine, shut off engine, grease the lubrication points shown in wait for all moving parts to come If the leak is from around a shaft and oil Figure5-1 and described below. to acomplete stop, disconnect seal, the oil seal probably needsto be Useclean lubr
Inhaltszusammenfassung zur Seite Nr. 18
moving partsto come to a complete stop, disconnect spark plug wire and move wire awayfrom ,_ WARNING: Beforeinspecting, cleaning or servicing the machine,shut off engine, wait for all spark plug. Failureto follow these instructions can result in serious personal injury or property damage. B. ToDrain theTransmissionGear Oil: 4. Thegear oil level is correct if the gear oil BOLO TINES is approximately halfway upthe side of the Thetransmission gear oil does not needto The bolo tines will wear with u
Inhaltszusammenfassung zur Seite Nr. 19
moving partsto come to a complete stop, disconnectspark plug wire and move wire awayfrom ,_ WARNING: Beforeinspecting, cleaning or servicing the machine,shut off engine, wait for all spark plug. Failureto follow these instructions can result in serious personal injury or property damage. b Unthreadthe hex nut (C,Figure 5-4) halfway up the adjustment screw (D). c. Unhookthe top of the spring from the Forward Clutch Bail. d. Usepliers to preventthe adjuster (B) FRONT/ FORWARD from turning andturn
Inhaltszusammenfassung zur Seite Nr. 20
moving partsto come to a complete stop, disconnectspark plug wire and move wire awayfrom ,_ WARNING: Beforeinspecting, cleaning or servicing the machine,shut off engine, wait for all spark plug. Failureto follow these instructions can result in serious personal injury or property damage. 5. Releasethe ReverseClutch Control FORWARDCLUTCH Replacement Belt Information knob.andthen unthread the inner jam nut BAIL ADJUSTMENT If the drive belt needsto be replaced,see (C, Figure 5-6) oneto two turns. P
