Bedienungsanleitung Snapper 28587 LT Series

Inhaltszusammenfassung zur Seite Nr. 1

DEALER SET-UP INSTRUCTIONS & PRE-SALE CHECKLIST for
EUROPEAN SNAPPER LT SERIES TRACTORS

INTRODUCTION: Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat
cushions removed. The following steps are required for set-up. Complete all items on the Dealer Pre-Sale
Checklist at time of purchase.

NOTE: Figure 1 shows the seat assembled to the seat
pedestal assembly. Some models are shipped
SEAT KNOB

with the seat loose and will require installation.
SEA

Inhaltszusammenfassung zur Seite Nr. 2

4. With cell caps removed, connect battery charger to battery terminals; RED to positive (+) and BLACK to negative (-) terminal. 5. If time allows, slow charge at 1 amp for 10 hours, or as an alternative, fast charge at not more than 2.5 amps for 4 hours to bring the battery to full charge. NOTE: Slow charging is recommended and extends battery life. 6. After charging, check level of electrolyte and add as needed to bring level to 3/16” above cell plates. 7. Reinstall cell caps.

Inhaltszusammenfassung zur Seite Nr. 3

5. Check for 5/16” flat washer under head of each STEP 6: INSTALL OPERATOR’S SEAT seat knob. Install washer, if missing, and tighten Some models are shipped with the seat, hinge rod and securely. See Figure 5. hair pin already installed. On those models verify all seat 6. Install seat cushions by pushing into receptacles hardware is tight and that the hair pin is inserted fully into located in seat pedestal. Seat must move freely on the hinge rod hole. See Figure 4. All models will r

Inhaltszusammenfassung zur Seite Nr. 4

DEALER PRE-SALE CHECKLIST The following must be accomplished prior sale. Refer to pages 1 - 3 for detailed set-up instructions. Review this list with purchaser. Check ( ) items actually performed and signed on this page. CUTTING BLADE & MOWER _____ BLADE RETAINING hardware checked for proper tightness. _____ BLADE TIP CLEARANCE inside lower edge of mower checked and corrected as needed. _____ MOWER CUTTING HEIGHT settings checked and adjusted as needed (with tires properly inflated).