Inhaltszusammenfassung zur Seite Nr. 1
IMPORTANT MANUAL Do Not Throw Away
03076
OPERATOR'S MANUAL
WARNING:
MODEL:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so can
re sult in serious in ju ry.
XT18542LT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan.com
427483 02.21.09 SR Printed in the U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac ci - working. den tal starting when setting up, trans- • Slow down before turning. port ing, ad just i
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to • Never operate machine in a closed area. • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. • Never tamper with safety devices. Check their proper children will remain where you last saw them. • Kee
Inhaltszusammenfassung zur Seite Nr. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give Gasoline Capacity 1.50 Gallons you the best possible dependability and performance. and Type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SG-SL): SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians
Inhaltszusammenfassung zur Seite Nr. 5
UNASSEMBLED PARTS Steering Wheel (1) Lock Washer Steering (1) Large Wheel Insert Flat Washer Steering Wheel (1) Hex Bolt Steering Steering Wheel Extension Adapter Steering Boot Shaft Seat (1) Washer (1) Knob (1) Seat Slope Sheet (1) Oil Drain Tube For Future Use Key(s) 5
Inhaltszusammenfassung zur Seite Nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY BEFORE REMOVING TRACTOR FROM A socket wrench set will make assembly easier. Stan dard SKID wrench sizes are listed. ATTACH STEERING WHEEL (See Fig. 2) (1) 5/
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY INSTALL SEAT (See Fig. 3) CHECK TIRE PRESSURE Adjust seat before tightening adjustment knob. The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important • Remove adjustment knob and flat washer securing for best cutting performance. seat to cardboard packing and set aside for assembly • Reduce tire pressure to PSI shown on tires. of seat to tractor. • Pivot seat upward and remove from the cardboard pack- CHECK DECK LEVELNESS
Inhaltszusammenfassung zur Seite Nr. 8
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH P REVERSE ENGINE ON ENGINE START PARKING BRAKE ENGINE OFF PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) FUEL OIL PRESSURE BATTERY REVERSE FORWARD OVER TEMP MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT BRAKE/CLUTCH KEEP AREA CLEAR SLOPE HAZARDS CLUTCH DISENGAGED CLUTCH ENGAGE
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. G H D B E F C A J Fig. 4 Our tractors conform to the safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise, lower, (F) IGNITION SWITCH - Used for starting and stopping and adjust t
Inhaltszusammenfassung zur Seite Nr. 10
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Failure to move throttle control between half and full HOW TO USE YOUR TRACTOR speed (fast) position, before stop ping may cause engine to “back fire”.
Inhaltszusammenfassung zur Seite Nr. 11
OPERATION TO ADJUST MOWER CUTTING HEIGHT REVERSE OPERATION SYSTEM (ROS) (See Fig. 8) Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse The position of the attachment lift lever (A) determines the direction with the attachment clutch engaged will shut off the cutting height. engine unless ignition key is placed in the ROS "ON" position. W ARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discour
Inhaltszusammenfassung zur Seite Nr. 12
OPERATION TO OPERATE MOWER BEFORE STARTING THE ENGINE Your tractor is equipped with an operator presence sensing CHECK ENGINE OIL LEVEL switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will The engine in your tractor has been shipped, from the shut off the engine. You must remain fully and centrally factory, already filled with sum mer weight oil. positioned in the seat to prevent the engine from hesitat- • Check engine oil
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION TO START ENGINE (See Fig. 4) MOWING TIPS When starting the engine for the first time or if the engine • Mower should be properly leveled for best mowing has run out of fuel, it will take extra cranking time to move per for mance. See "TO LEVEL MOWER HOUSING" in fuel from the tank to the engine. the Service and Adjustments section of this manual. • Sit on seat in operating position, depress clutch/brake • The left hand side of mower should be used for trim- ming. pedal and set parki
Inhaltszusammenfassung zur Seite Nr. 14
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 1,2 Change Engine Oil
Inhaltszusammenfassung zur Seite Nr. 15
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
Inhaltszusammenfassung zur Seite Nr. 16
MAINTENANCE • After oil has drained completely, close and lock the V-BELTS drain valve by pushing inward and turning clockwise Check V-belts for deterioration and wear after 100 hours and until the pin is in the locked position as shown. replace if necessary. The belts are not adjustable. Re place • Remove the drain tube and replace the cap onto to the belts if they begin to slip from wear. bottom fitting of the drain valve. TRANSAXLE COOLING • Refill engine with oil through oil fill dips
Inhaltszusammenfassung zur Seite Nr. 17
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN AT
Inhaltszusammenfassung zur Seite Nr. 18
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 20 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 18 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
Inhaltszusammenfassung zur Seite Nr. 19
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 25 & 26) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 23) IMPORTANT:
Inhaltszusammenfassung zur Seite Nr. 20
SERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 27) (See Fig. 28) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. En gage parking brake. For as sis tance, there is a belt installation guide decal on Park the tractor on level surface. Engage parking brake. bottom side of left footrest. BELT REMOVAL - BELT REMOVAL - • Remove mower from tractor (See “TO REMOVE MOW ER” in this section of manual). 1.
