Inhaltszusammenfassung zur Seite Nr. 1
MODEL NO. PO165H42STA
16.5 HP 42 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
180471 Rev. 1 3.19.02 RD
PRINTED IN U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. DO NOT: I. GENERAL OPERATION • Do not turn on slopes unless necessary, and then, turn • Read, understand, and follow all instructions in the manual slowly and gradually downhill, if possible. and on the machine before starting. Do not mow near drop-o
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers Be sure the area is clear of other people before mowing. Stop Look for this symbol to point out im- machine if anyone enters the area. portant safety precautions. It means Never carry passengers or children even with the blades off. CAUTION!!! BECOME ALERT!!! YOUR Do not mow in reverse unless absolutely necessary. Always SAFETY IS INVOLVED. look down and behind before and while backing. Never carry children. They may fall off an
Inhaltszusammenfassung zur Seite Nr. 4
CONGRATULATIONS on your purchase of a new tractor. It PRODUCT SPECIFICATIONS has been designed, engineered and manufactured to give GASOLINE CAPACITY 1.25 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) remedy, please contact your nearest authorized service SAE 5W-30 (below 32°F) center/department. We have competent, well-trained tech- nicians and the proper to
Inhaltszusammenfassung zur Seite Nr. 5
UNASSEMBLED PARTS Steering Wheel Seat Steering Wheel Adapter (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering (1) Lockwasher 3/8 Wheel (1) Lock Insert Washer 1/2 Steering (1) Bolt Extension Shaft Steering Boot (1) Locknut Key 5/16-18 (1) Large Flat Washer (1) Hex Bolt 3/8-16 x 1 (2) Keys Slope Sheet (1) Hex Bolt 5/16-18 x 1-1/4 5
Inhaltszusammenfassung zur Seite Nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. INSERT TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard 3/8 HEX BOLT wrench sizes are listed. 3/8 LOCK WASHER (1) 9/16" wrench Pliers LARGE FLAT (2) 1/
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY INSTALL SEAT (See Fig. 3) TO ROLL TRACTOR OFF SKID (See Operation section, page 10, for location and function of Adjust seat before tightening adjustment bolt. controls) Remove adjustment bolt, lock washer and flat washer securing seat to cardboard packing and set aside for Press lift lever plunger and raise attachment lift lever to assembly of seat to tractor. its highest position. Pivot seat upward and remove from the cardboard Release parking brake by depressing clutch/brake
Inhaltszusammenfassung zur Seite Nr. 8
ASSEMBLY CHECKLIST CHECK TIRE PRESSURE BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- The tires on your tractor were overinflated at the factory for TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE shipping purposes. Correct tire pressure is important for BEST PERFORMANCE AND SATISFACTION FROM THIS best cutting performance. QUALITY PRODUCT. Reduce tire pressure to PSI shown in “PRODUCT PLEASE REVIEW THE FOLLOWING CHECKLIST: SPECIFICATIONS” section of this manual. ✓ All assembly instructions have b
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING LIGHTS ON OVER TEMP ENGINE ON ENGINE OFF OIL PRESSURE LIGHT PARKING BRAKE UNLOCKED MOWER LIFT FUEL CHOKE MOWER HEIGHT LOCKED P ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED 15 15 15 KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT (SEE SAFETY RULES SECTION) CLUTCH DISENGAGED IGNITION FREE WHEEL DANG
Inhaltszusammenfassung zur Seite Nr. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. ATTACHMENT LIGHT CLUTCH LEVER IGNITION SWITCH SWITCH POSITION LIFT LEVER PLUNGER THROTTLE/CHOKE ATTACHMENT CONTROL LIFT LEVER CLUTCH/BRAKE PEDAL PARKING BRAKE MOTION FREE WHEEL CONTROL CONTROL LEVER FIG. 4 Our tractors conform to the sa
Inhaltszusammenfassung zur Seite Nr. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). TO SET PARKING BRAKE (See
Inhaltszusammenfassung zur Seite Nr. 12
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 6) TO OPERATE ON HILLS Gauge wheels are properly adjusted when they are slightly CAUTION: Do not drive up or down hills off the ground when mower is at the desired cutting height in with slopes greater than 15° and do not operating position. Gauge wheels then keep the deck in drive across any slope. proper position to help prevent scalping in most terrain conditions. Choose the slowest speed before starting up or down NOTE:Adjust gauge wheels with
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION Insert key into ignition and turn key clockwise to BEFORE STARTING THE ENGINE “START” position and release key as soon as engine starts. Do not run starter continuously for more than CHECK ENGINE OIL LEVEL fifteen seconds per minute. If the engine does not start The engine in your tractor has been shipped, from the after several attempts, move throttle control to fast factory, already filled with summer weight oil. position, wait a few minutes and try again. If engine still Chec
Inhaltszusammenfassung zur Seite Nr. 14
OPERATION Sitting in the tractor seat, start engine. After the engine MOWING TIPS is running, move throttle control to slow position. With Tire chains cannot be used when the mower housing is motion control lever in neutral (N) position, slowly attached to tractor. disengage clutch/brake pedal. Mower should be properly leveled for best mowing Move motion control lever to full forward position and performance. See “TO LEVEL MOWER HOUSING” in hold for five (5) seconds. Move lever to full
Inhaltszusammenfassung zur Seite Nr. 15
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Filter N
Inhaltszusammenfassung zur Seite Nr. 16
CUSTOMER RESPONSIBILITIES TRACTOR TRAILING MANDREL EDGE UP ASSEMBLY Always observe safety rules when performing any mainte- BLADE nance. CENTER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at LOCK WASHER high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual). STAR FLAT WASHER TIRES HEX BOLT (GRADE 8)* Maintain proper air pressure in all tires (See “PRODUCT *A GRADE 8 HEAT TREATE
Inhaltszusammenfassung zur Seite Nr. 17
CUSTOMER RESPONSIBILITIES NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) TO CLEAN BATTERY AND TERMINALS improve starting in cold weather, these multi-viscosity oils Corrosion and dirt on the battery and terminals can cause the will result in increased oil consumption when used above battery to “leak” power. 32°F. Check your engine oil level more frequently to avoid Disconnect BLACK battery cable first then RED battery possible engine damage from running low on oil. cable and remove
Inhaltszusammenfassung zur Seite Nr. 18
CUSTOMER RESPONSIBILITIES ENGINE COOLING FINS (See Fig. 14) COVER Remove any dust, dirt or oil from engine cooling fins to KNOB prevent engine damage from overheating. Remove screws from blower housing and lift housing CARTRIDGE and dipstick tube assembly off engine. COVER NUT Cover oil fill opening to prevent entry of dirt. Use compressed air or stiff bristle brush to thoroughly clean engine cooling fins. To reassemble, reverse above procedure. FOAM PAPER PRE-CLEANER CARTRIDGE SCREWS B
Inhaltszusammenfassung zur Seite Nr. 19
SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress clutch/brake pedal fully and set parking brake. Place motion control lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key “OFF” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR TO INSTALL MOWER (SEE FIG. 17)
Inhaltszusammenfassung zur Seite Nr. 20
SERVICE AND ADJUSTMENTS SIDE-TO-SIDE ADJUSTMENT (See Figs. 18 and 19) Raise mower to its highest position. MANDREL At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" "D" "D" of each other. If adjustment is necessary, make adjustment on one FIG. 20 side of mower only. BOTH FRONT LINKS MUST BE EQUAL IN LENGTH BOTTOM EDGE BOTTOM EDGE OF MOWER OF MOWER TO GROUND TO GROUND GROUND LIN
