Inhaltszusammenfassung zur Seite Nr. 1
IMPORTANT MANUAL Do Not Throw Away
02478
OWNER'S MANUAL
WARNING:
Read this Owner's Man u al and follow all Warn-
MODEL:
ings and Safety Instructions. Fail ure to do so
can re sult in serious in ju ry.
PD2042STA
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
185491 Rev. 3 02.17.03 RH/rad/RH
Printed in U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. DO NOT: I. GENERAL OPERATION Do not turn on slopes unless necessary, and then, Read, understand, and follow all instructions in the manual and on the machine before starting. turn slowly and gradually downhill, if possible. Only al
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Be sure the area is clear of other people before mowing. Stop machine if anyone enters the area. WARNING: In order to prevent ac- ci den tal starting when setting up, Never carry passengers or children even with the blades off. trans
Inhaltszusammenfassung zur Seite Nr. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give GASOLINE CAPACITY 2.0 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily rem- OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have competent, w
Inhaltszusammenfassung zur Seite Nr. 5
UNASSEMBLED PARTS Seat Steering Wheel Steering (1) Washer Wheel Insert 17/32 x 1-3/16 x 12 Gauge (1) Knob Steering Gauge Wheel Extension Shaft (4) Adjusting Steering Bar Sleeve (4) Clevis Pins (4) Wheels (4) Retainer Springs (double loop) Steering Adapter (4) Washers 3/8 x 3/4 x 14 Ga. (1) Large Flat Washer (4) Locknut 3/8-16 (4) Shoulder Bolt Blade (1) Oil Drain Tube (1) Locknut 1/2-20 Slope Sheet (2) Mulch Blades (1) Hex Bolt 1/4-28 x 1-1/4 (1) Locknut 1/4-28 (2
Inhaltszusammenfassung zur Seite Nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY INSERT A socket wrench set will make assembly easier. Stan dard 1/2 HEX NUT wrench sizes are listed. Utility knife Pliers (1) 3/4" wrenches Tire pressure
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY Get off seat without moving its ad just ed position. Remove banding holding the de fl ec tor shield up against tractor. Raise seat and tighten adjustment knob securely. TO DRIVE TRACTOR OFF SKID (See Op- SEAT er a tion section for location and func tion of con trols) WARNING: Before starting, read, un der stand and follow all in struc tions in the Operation section of this manual. Be SEAT PAN sure tractor is in a well-ventilated area. Be sure the area in front of t
Inhaltszusammenfassung zur Seite Nr. 8
ASSEMBLY IMPORTANT: FOR SHIPPING PURPOSES, THE MULCHER CHECK TIRE PRESSURE PLA TE WAS PREA TT ACHED TO Y OUR MOWER. THE MULCHER PLATE MUST ONLY BE USED WITH THE MULCHING BLADES The tires on your tractor were overinfl ated at the factory THAT CAME PACKED SEPARATELY IN THE CARTON. for shipping purposes. Correct tire pressure is important for best cutting performance. YOUR MOWER CAME FACTORY EQUIPPED WITH HIGH PERFORMANCE BLADES, WHICH ARE THE BEST BLADES Reduce tire pressure to PSI sho
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST IGNITION REVERSE NEUTRAL HIGH LOW SLOW CHOKE P LIGHTS ON ENGINE ON ENGINE START PARKING BRAKE ENGINE OFF PARKING BRAKE PARKING BRAKE LOCKED UNLOCKED FUEL OIL PRESSURE BATTERY REVERSE FORWARD OVER TEMP MOWER HEIGHT MOWER LIFT LIGHT 15 15 15 ATTACHMENT ATTACHMENT SLOPE HAZARDS CLUTCH ENGAGED CLUTCH DISENGAGED DANGER, KEEP HANDS KEEP AREA CLEAR AND FEET AWAY
Inhaltszusammenfassung zur Seite Nr. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. IGNITION LIGHT AT TACHMENT SWITCH SWITCH CLUTCH LEVER POSITION AMMETER CHOKE CONTROL LIFT LEVER PLUNGER THROTTLE ATTACHMENT CONTROL LIFT LEVER CLUTCH/ BRAKE PEDAL HEIGHT ADJUSTMENT KNOB PARKING BRAKE GEARSHIFT LEVER FIG. 5 Our
Inhaltszusammenfassung zur Seite Nr. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per forming an y adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “browning” of
Inhaltszusammenfassung zur Seite Nr. 12
OPERATION For best cutting performance, grass over 6 inches "ENGAGED" PO SI TION in height should be mowed twice. Make the fi rst cut ATTACHMENT relatively high; the sec ond to desired height. LIFT LEVER HIGH PO SI TION TO ADJUST GAUGE WHEELS (See Fig. 7) AT TACHMENT Gauge wheels are properly adjusted when they are slightly CLUTCH LEVER LOW "DIS EN GAGED" off the ground when mower is at the desired cutting height POSITION PO SI TION in operating position. Gauge wheels then keep the d
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION TO START ENGINE (See Fig. 5) BEFORE STARTING THE ENGINE When starting the engine for the fi rst time or if the engine has run out of fuel, it will take extra cranking time to move CHECK ENGINE OIL LEVEL fuel from the tank to the engine. The engine in your tractor has been shipped, from the Sit on seat in operating position, depress clutch/brake factory, already fi lled with sum mer weight oil. pedal and set parking brake. Check engine oil with tractor on level groun
Inhaltszusammenfassung zur Seite Nr. 14
OPERATION MOWING TIPS MULCHING MOWING TIPS Mower should be properly leveled for best mowing per- IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN formance. See “TO LEVEL MOWER HOUSING” in the AFTER EACH USE. Service and Adjustments section of this manual. The spe cial mulch ing blade will recut the grass clip- The left hand side of mower should be used for trim- pings many times and reduce them in size so that as ming. they fall
Inhaltszusammenfassung zur Seite Nr. 15
MAINTENANCE MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Filter N 2 G Clean Air
Inhaltszusammenfassung zur Seite Nr. 16
MAINTENANCE TRACTOR MANDREL TRAILING ASSEMBLY EDGE UP Always observe safety rules when performing any main- BLADE te nance. CEN TER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Ad just ments FLAT WASHER section of this manual). LOCK WASHER STAR TIRES Maintain proper air pressure in all tires (See “PROD UCT SPECIFICATIONS” section of this man ual).
Inhaltszusammenfassung zur Seite Nr. 17
MAINTENANCE NOTE: The original equipment battery on your tractor is TO CHANGE ENGINE OIL (See Figs. 13 and 14) maintenance free. Do not attempt to open or remove caps Determine temperature range expected before oil change. or covers. Adding or checking level of electrolyte is not All oil must meet API service classifi cation SF-SJ. necessary. Be sure tractor is on level surface. TO CLEAN BATTERY AND TERMINALS Oil will drain more freely when warm. Corrosion and dirt on the battery
Inhaltszusammenfassung zur Seite Nr. 18
MAINTENANCE CLEAN AIR SCREEN ENGINE OIL FILTER Air screen must be kept free of dirt and chaff to prevent Replace the engine oil fi lter every season or every other engine dam age from overheating. Clean with a wire brush oil change if the tractor is used more than 100 hours in or compressed air to re move dirt and stubborn dried gum one year. fi bers. MUFFLER CLEAN AIR INTAKE/COOLING AREAS Inspect and replace corroded muffl er and spark arrester To insure proper cooling, make sure the grass
Inhaltszusammenfassung zur Seite Nr. 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
Inhaltszusammenfassung zur Seite Nr. 20
SERVICE AND ADJUSTMENTS Before making any necessary adjustments, check that TO LEVEL MOWER HOUSING both front links are equal in length. Adjust the mower while tractor is parked on level ground If links are not equal in length, adjust one link to same or driveway. Make sure tires are properly infl ated (See length as other link. “PROD UCT SPECIFICATIONS” section of this manual). If To lower front of mower loosen nut “E” on both front tires are over or underinfl ated, you
