Inhaltszusammenfassung zur Seite Nr. 1
MODEL NO. MC1236ST (MC1236STA)
12 HP 36 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
193201 Rev. 1 7.20.04 MH
PRINTED IN U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. DO NOT: I. GENERAL OPERATION Do not turn on slopes unless necessary, and then, Read, understand, and follow all instructions in the turn slowly and gradually downhill, if possible. manual and on the machine before starting. Only al
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers Be sure the area is clear of other people before mowing. Stop WARNING: In order to prevent ac- machine if anyone enters the area. ci den tal starting when setting up, Never carry passengers or children even with the blades trans port ing, ad just ing or making off. repairs, al ways dis con nect spark Do not mow in reverse unless absolutely necessary. Al ways plug wire and place wire where it look down and behind
Inhaltszusammenfassung zur Seite Nr. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu factured to giv e you the best possible dependability and performance. Gasoline Capacity 1.25 Gallons and type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ (API-SG-SL): SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians a
Inhaltszusammenfassung zur Seite Nr. 5
UNASSEMBLED PARTS Steering Wheel Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge (1) Lock Washer 1/2 Steering Wheel Insert Steering Boot Steering (1) Bolt Extension Shaft Steering Wheel Adapter (1) Oil Drain Tube For Future Use Keys (2) Keys Slope Sheet (1) Locknut 1/2-20 (1) Large Flat Washer (1) Locknut 1/4-28 (1) Hex Bolt 1/4-28 x 1-1/4 5
Inhaltszusammenfassung zur Seite Nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard INSERT wrench sizes are listed. 1/2 HEX NUT (2) 7/16" wrenches Pliers (1) 3/4" wrench Tire pressure
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY DISCARD TER MI NAL SEAT PROTECTIVE CAPS KEPS TERMINAL NUT HEX BOLT COVER SEAT PAN SHOULDER BOLT 02604 NEGATIVE (BLACK) POSITIVE (RED) CABLE CABLE FIG. 3 FLAT WASHER LOCK WASHER SEAT PAN ADJUSTMENT LABEL 02465 BOLT FIG. 2 HOW TO SET UP YOUR TRACTOR 02602 CONNECT BATTERY (See Figs. 3 and 4) FIG. 4 CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wrist
Inhaltszusammenfassung zur Seite Nr. 8
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. CHECK TIRE PRESSURE Follow the appropriate instruction below to remove the The tires on your tractor were overinfl ated at the factory tractor from the skid. for shipping purposes. Correct tire pressure is important TO ROLL TRACTOR OFF SKID (See for best cutting performance. Op er a tion section for location and function Reduce tire pressure to PSI shown in “PRODUCT SPEC I FI CATIONS” section of this manual. of con
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. HIGH LOW FAST SLOW IGNITION REVERSE NEUTRAL CHOKE P LIGHTSON ENGINEON ENGINESTART PARKINGBRAKE ENGINEOFF PARKINGBRAKE PARKINGBRAKE LOCKED UNLOCKED OILPRESSURE BATTERY REVERSE OVERTEMP FUEL FORWARD MOWERHEIGHT MOWERLIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPEHAZARDS CLUTCHENGAGED DANGER,KEEPHANDS KEEPAREACLEAR CLUTCHDISENGAGED ANDFEETAWAY (SEESAFETYRULESSECTION) DANG
Inhaltszusammenfassung zur Seite Nr. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATTACHMENT LIGHT SWITCH IGNITION POSITION CLUTCH LEVER SWITCH THROTTLE/CHOKE CONTROL LIFT LEVER PLUNGER CLUTCH/BRAKE PEDAL ATTACHMENT LIFT LEVER MOWER DECK HEIGHT ADJUSTMENT POSITIONS PARKING BRAKE GEARSHIFT LEVER FIG. 5 Our tracto
Inhaltszusammenfassung zur Seite Nr. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per forming an y adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. 00155 IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DIS CHARGED, (DEAD). TO SET
Inhaltszusammenfassung zur Seite Nr. 12
01994 OPERATION To restart movement, slowly release parking brake and TO OPERATE MOWER (See Fig. 7) clutch/brake pedal. Your tractor is equipped with an operator presence sensing Make all turns slowly. switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged TO TRANSPORT will shut off the engine. You must remain fully and centrally Raise attachment lift to highest position with at tach ment positioned in the seat to p
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION MOWING TIPS CAUTION: Alcohol blended fuels (called gasohol or Mower should be properly leveled for best mowing per- using ethanol or methanol) can attract moisture which for mance. See “TO LEVEL MOWER HOUSING” in the leads to sep a ration and f or ma tion of acids during stor- Service and Adjustments section of this manual. age. Acidic gas can damage the fuel system of an engine The left hand side of mower should be used for trim- while in storage. To avoid engine p
Inhaltszusammenfassung zur Seite Nr. 14
maint_sch-tractore.new1 MAINTENANCE MAINTENANCESCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air
Inhaltszusammenfassung zur Seite Nr. 15
MAINTENANCE TRACTOR MANDREL TRAILING ASSEMBLY Always observe safety rules when performing any main- EDGE UP te nance. CEN TER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Ad just ments section of this manual). LOCK WASHER STAR TIRES Maintain proper air pressure in all tires (See “PROD UCT FLAT WASHER SPECIFICATIONS” section of this man ual). BLADE
Inhaltszusammenfassung zur Seite Nr. 16
MAINTENANCE BATTERY Change the oil after every 25 hours of operation or at least once a year if the tractor is not used for 25 hours in one Y our tractor has a battery charging system which is suf fi cient year. for normal use. However, periodic charging of the battery with an automotive charger will extend its life. Check the crankcase oil level before starting the engine Keep battery and terminals clean. and after each eight (8) hours of operation. Tighten oil fi ll cap/dipstick se
Inhaltszusammenfassung zur Seite Nr. 17
00667 MAINTENANCE CLEANING CLEAN AIR INTAKE/COOLING AREAS Clean engine, battery, seat, fi nish, etc. of all foreign To insure proper cooling, make sure the grass screen, matter. cooling fi ns, and other external surfaces of the engine are Keep fi nished surfaces and wheels free of all gasoline, kept clean at all times. oil, etc. Every 100 hours of operation (more often under extremely Protect painted surfaces with automotive type wax. dusty, dirty conditions), remove the blower
Inhaltszusammenfassung zur Seite Nr. 18
38 42 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
Inhaltszusammenfassung zur Seite Nr. 19
01156 SERVICE AND ADJUSTMENTS To lower front of mower loosen nut “E” on both front TO LEVEL MOWER HOUSING links an equal number of turns. Adjust the mower while tractor is parked on level ground When distance “D” is 1/8" to 1/2" lower at front than or driveway. Make sure tires are properly infl ated (See rear, tighten nuts “F” against trunnion on both front “PROD UCT SPECIFICATIONS” section of this manual). If links. tires are over or underinfl ated, you will not properly adjust
Inhaltszusammenfassung zur Seite Nr. 20
38 42 02472 SERVICE AND ADJUSTMENTS WITH PARKING BRAKE “ENGAGED” IDLER MANDREL PULLEYS 1-1/2" PULLEY NUT “A” JAM NUT OPERATING ARM FIG. 20 TO REPLACE MOTION DRIVE BELT (See Fig. 21) Park the tractor on level surface. En gage parking brake. For assis tance, there is a belt installation guide decal on MANDREL PULLEY bottom side of left footrest. BELT REMOVAL - Remove mower (See “TO RE MOVE MOWER” in this section of manual). FIG. 19 NOTE: Observe entire motion drive belt and position of
