Bedienungsanleitung Bunn FMD DBC-3 4-CUP

Inhaltszusammenfassung zur Seite Nr. 1

®
BUNN
FMD DBC-3 4-CUP
OPERATING & SERVICE MANUAL
ADDENDUM
BUNN-O-MATIC CORPORATION OF
CANADA LTD.
280 INDUSTRIAL PARKWAY SOUTH
AURORA, ONTARIO. L4G 3T9
PHONE: (905) 841-2866 FAX: (905) 841-2775
29215.7002 5/02 ©1998 Bunn-O-Matic Corporation

Inhaltszusammenfassung zur Seite Nr. 2

DISPENSER USE 1. Simply place a cup on the drip tray beneath the desired dispensing tip. 2. To select a mocha dispense, momentarily press the “MOCHA” switch at the appropriate position. Note that the “MOCHA” lights when mocha is selected. For non-mocha, dispenses, skip to step 3. 3. Momentarily press the appropriate dispense switch to froth and dispense the beverage. The dispenser will automatically dispense the beverage for the programmed dispense time at the programmed hopper dispense rate. Th

Inhaltszusammenfassung zur Seite Nr. 3

3. Increasing / Decreasing the Hopper Dispense Rate: a. Enter the program mode on the position you want to program (see step 1.a.) b. Place the Rinse/Run switch in the “Rinse” position. c. Press and hold down on the stop switch and press the “S” switch to decrease the dispense rate or press the “XL” switch to increase the dispense rate. Each time the button is pressed, the dispense rate will increase/ 1 decrease by approximately 2 / %. Each time the “S” or “XL” switch is pressed, the L.E.D. o

Inhaltszusammenfassung zur Seite Nr. 4

7. Password: The password is to be used to prevent unauthorized entering of the program modes. The password is preset at the factory to 0 (no password.) a. To enter the password programming, press and hold any two dispense size switches on any one of the positions for 10 seconds. All 3 position L.E.D.’s will begin flashing indicating that the dispenser is ready to accept a new password. b. When the switches are released the 3 L.E.D.’s will stop flashing. At this time press the Stop switch the