Inhaltszusammenfassung zur Seite Nr. 1
03002
YTH2754XP
Owner's Manual
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. � Do not operate the machine while under the infl uence WARNING: In order to prevent ac- of alcohol or drugs. ci den tal starting when setting up, � Watch for traffi c when operating near or crossing road- trans port ing, ad just ing or making re-
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to � Never operate machine in a closed area. � Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. � Never tamper with safety devices. Check their proper children will remain where you last saw th
Inhaltszusammenfassung zur Seite Nr. 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES � Read and observe the safety rules. Gasoline Capacity 4 Gallons and type: Unleaded Regular � Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 10W30 (above 32°F) SAE 5W-30 (below 32°F) � Follow the instructions under “Maintenance” and “Stor- age” sec tions of this own er’s manual. Oil Capacity: W/ Filter: 1.8 QT Spark Plug: Champion RC12YC (Gap: .030") WARNING: This t
Inhaltszusammenfassung zur Seite Nr. 5
UNASSEMBLED PARTS Mower Mower Front Wheel (5) Large Retainer (1) 3/4 O.D. Washers Springs - 7/16 (1) Wheel (1) 1-1/4 O.D. Washer (2) Smaller Retainer Springs - 5/16 (1) Locknut (5) 1-3/16 O.D. Washers (1) Shoulder Bolt 3/8-16 Battery (2) Rear Lift Link (1) Anti-Sway Bar (2) Keps Nut 1/4-20 (2) Hex Bolts 1/4-20 x 3/4 Assemblies (1) Front Link Assembly Slope Sheet Keys (1) Oil Drain Tube For Future Use (2) Keys 5
Inhaltszusammenfassung zur Seite Nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur- poses. TOOLS REQUIRED FOR ASSEMBLY ADJUST SEAT (See Fig. 2) � Sit in seat. A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. � Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press (1) 3/4" wrench (1) Utility knife clutch/brake pedal all the way down. (1) 9/16" wrench (
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY � Slowly depress forward drive pedal and drive tractor off skid. � Apply brake to stop tractor and set park ing brake. � Turn ignition key to "STOP" position. Continue with the in struc tions that follow. ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3) � Using shoulder bolt, washer and locknut from parts bag, as sem ble front wheel to mower as shown. Tighten securely. A FIG. 5 NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tr
Inhaltszusammenfassung zur Seite Nr. 8
ASSEMBLY � ATTACH MOWER SIDE SUSPENSION ARMS (A) TO � Turn steering wheel to position wheels straight for- CHASSIS - Position hole in arm over pin (B) on outside ward. of tractor chassis and secure with washer and retainer � ATTACH FRONT LINK (E) - Work from left side of spring. tractor. Insert rod end of link assembly through front � Repeat on opposite side of tractor. hole in tractor front suspension bracket (F) and secure with7/16 retainer spring (G) through hole in link locat
Inhaltszusammenfassung zur Seite Nr. 9
ASSEMBLY ✓CHECKLIST M BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- FORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been com plet ed. ✓ No remaining loose parts in carton. ✓ Battery is properly prepared and charged. ✓ Seat is adjusted comfortably and tightened securely. ✓ All tires are properly infl ated. (For shipping purposes, FIG. 12 the tires were overinfl ated
Inhaltszusammenfassung zur Seite Nr. 10
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFE
Inhaltszusammenfassung zur Seite Nr. 11
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. P H D E G K L N B F J C A M FIG. 13 Our tractors conform to the applicable safety standards of the American National Standards Institute. (H) LIGHT SWITCH – Turns the headlights on and off. (A) ATTACHMENT LIFT LEVER – Used to raise
Inhaltszusammenfassung zur Seite Nr. 12
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. IMPORTANT: Leaving the ignition switch in any position HOW TO USE YOUR TRAC TOR other than "STOP" will cause the battery to discharge and go dead. TO SE
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION � The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth. � For best cutting performance, grass over 6 inches J in height should be mowed twice. Make the fi rst cut relatively high; the second to de sired height. TO ADJUST GAUGE WHEELS (See Fig. 19) Gauge wheels are prop er ly ad just ed when they are slight ly K off the ground w
Inhaltszusammenfassung zur Seite Nr. 14
OPERATION � To restart movement, slowly release parking brake and brake pedal. � Slowly depress appropriate drive pedal to slowest set- ting. S � Make all turns slowly. TO TRANSPORT (See Figs. 13 and 21) When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in free wheel ing po si tion. Free wheel control is located at the rear drawbar of tractor. FIG. 20 � Raise attachment lift to highest position with at tach ment lift control.
Inhaltszusammenfassung zur Seite Nr. 15
OPERATION � Insert key into ignition and turn key clockwise to “START” BEFORE STARTING THE ENGINE position and release key as soon as engine starts. Do not run starter continuously for more than fi fteen sec onds CHECK ENGINE OIL LEVEL per minute. If the engine does not start after several The engine in your tractor has been shipped, from the attempts, push choke control in, wait a few minutes and factory, already fi lled with sum mer weight oil. try again. If engine still does not st
Inhaltszusammenfassung zur Seite Nr. 16
OPERATION � Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual). � Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Dis en gage parking brake � Depress forward drive pedal to full forward position, hold for fi ve (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for fi ve (5) seconds and release pedal. Repeat
Inhaltszusammenfassung zur Seite Nr. 17
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
Inhaltszusammenfassung zur Seite Nr. 18
02544 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- worn, bent or damaged blades. te nance. CAUTION: Use only a replacement BRAKE OPERATION blade approved by the manufacturer of If tractor requires more than fi ve (5) feet to stop at highest your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is haz- surface, then
Inhaltszusammenfassung zur Seite Nr. 19
MAINTENANCE � Rinse the battery with plain water and dry. TO CHANGE ENGINE OIL (See Figs. 24 and 25) � Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classifi cation SG-SL. � Coat terminals with grease or petroleum jelly. � Be sure tractor is on level surface. � Reinstall battery (See “REPLACING BATTERY" in � Oil will drain more freely when warm. the SERVICE AND ADJUS
Inhaltszusammenfassung zur Seite Nr. 20
MAINTENANCE ENGINE OIL FILTER CLAMP Replace the engine oil fi lter every season or every other CLAMP oil change if the tractor is used more than 100 hours in one year. FUEL FILTER MUFFLER Inspect and replace corroded muffl er and spark arrester FIG. 26 (if equipped) as it could create a fi re hazard and/or dam- age. CLEANING SPARK PLUGS � Clean engine, battery, seat, fi nish, etc. of all foreign Replace spark plugs at the beginning of each mowing matter. season or after every 100 hours o
