Inhaltszusammenfassung zur Seite Nr. 1
Operator’s Manual
SERIES 5000
TRACTOR
MODEL 5264D
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved
forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark
arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective
working order by the operator. In the Stat
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS TO THE OWNER .................................................................................................................... 2 CALLING SERVICE INFORMATION ...................................................................................... 2 RECORDING MODEL AND SERIAL NUMBER INFORMATION ........................................... 3 IMPORTANT SAFE OPERATION PRACTICES ..................................................................... 4 SAFETY LABELS ....................
Inhaltszusammenfassung zur Seite Nr. 3
RECORDING MODEL AND SERIAL NUMBER INFORMATION Product identification plates are provided for major components of your tractor. The numbers on these plates are important if your tractor should require dealer service, or if you need additional information on your tractor. Prior to using your tractor for the first time, record the numbers from the identification plates in the appropriate spaces provided below. The tractor model plate is located on the right frame rail behind the right front tire
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFE OPERATION PRACTICES WARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR UNIT. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. WHEN YOU SEE THIS SYMBOL, HEED ITS WARNING. WARNING: The engine exhaust, some of its constituents, and certain vehicle components contain or em
Inhaltszusammenfassung zur Seite Nr. 5
Check overhead clearance carefully before Disengage all attachment clutches, thoroughly depress the brake pedal and shift into neutral driving under power lines, wires, bridges or low before attempting to start the engine. hanging tree branches, before entering or leaving buildings, or in any other situation Your mower is designed to cut normal where the operator and/or roll bar may be residential grass of a height no more than 10”. struck, which could result in serious injury. Do not atte
Inhaltszusammenfassung zur Seite Nr. 6
Never attempt to straighten or reweld any part 3. CHILDREN of the main frame or retaining brackets that Tragic accidents can occur if the operator is not have been damaged. Doing so may weaken alert to the presence of children. Children are the structure and endanger your safety. often attracted to the machine. Never assume children will remain where you last saw them. Never secure any parts on the main frame or attach the safety frame with anything other than Keep children out of the m
Inhaltszusammenfassung zur Seite Nr. 7
Prior to disposal, determine the proper method Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. to dispose of waste from your local Environmental Protection Agency. Recycling Never tamper with safety devices. Check their centers are established to properly dispose of proper operation regularly. materials in an environmentally safe fashion. After striking a foreign object, stop the engine, Use proper containers when draining fluids. Do and tho
Inhaltszusammenfassung zur Seite Nr. 8
DIE OUTLINE DOES NOT PRINT SAFETY LABELS WARNING WARNING AVOID SERIOUS INJURY OR DEATH KEEP HANDS 1. GO UP AND DOWN SLOPES, NOT ACROSS. AND CLOTHING 2. AVOID SUDDEN TURNS. 3. DO NOT OPERATE UNIT WHERE IT COULD SLIP OR TIP. 4. IF MACHINE STOPS GOING AWAY FROM UPHILL, STOP PTO AND BACK DOWN HILL SLOWLY. 5. DO NOT MOW WHEN CHILDREN ROTATING FAN OR OTHERS ARE AROUND. 6. DO NOT ALLOW PASSENGERS ON THE TRACTOR AT ANY TIME. AND BELTS TO LOOK DOWN AND BEHIND 7. BEFORE AND WHILE BACKING. 8. KEEP SA
Inhaltszusammenfassung zur Seite Nr. 9
SECTION 1: CONTROLS AND FEATURES X W V A U B C D FUEL HOURS 1/10 RPM 0 x1000 4 EF T E F S H G H R J Q K P L M M O N Figure 1 A. Steering Wheel J. Trans. 4WD Shift Lever R. PTO Reverse Override Switch B. Throttle Handle K. Hydraulic Lift Lever S. Parking Brake Lever C. PTO Switch L. Cup Holder T. Differential Lock Pedal D. Ignition Switch M. Amber Hazzard Light U. Hazzard Light Switch E. Brake Pedal N. Seat Adjustment Lever V. Headlight Switch F. Reverse Pedal O. Seat Belt W. Foldable ROPS G. F
Inhaltszusammenfassung zur Seite Nr. 10
OFF - Engine and electrical system is turned off. NOTE: References to LEFT and RIGHT indicate that side of the tractor when facing forward while ON - The tractor electrical system is energized. seated in the drivers seat. Reference to FRONT START- The starter motor will turn over the engine. indicates the grille end of the tractor; to REAR, the Release the key immediately when the tow plate end. engine starts A. Steering Wheel E. Brake Pedal The steering wheel is centered on the dash panel, and
Inhaltszusammenfassung zur Seite Nr. 11
P. Fuel Fill Cap H. Hand Holds Hand holds are built into both the left and right hand The fuel fill cap is located on the left fender beside fender covers. The handles can be used to assist in the operator’s seat. mounting and dismounting the tractor. Q. Transmission Hi/Lo Range Shift Lever J. Transmission 4WD Shift Lever The Hi/Lo range shift lever is located on the left fender. The lever has two speed range settings and The 4WD shift lever is located on the right fender. a neutral position. T
Inhaltszusammenfassung zur Seite Nr. 12
T. Differential Lock Pedal Diff. Lock Pedal Symbol Figure 9 WARNING: Always activate the flash- Figure 8 ing hazard lights when operating the tractor on, or near, roadways. Located at the front of the left running board, the differential lock pedal engages the transmission differential lock. V. Headlight Switch The differential lock is used to gain additional trac- tion when operating the tractor on wet or loose soil. When the pedal is depressed the rear wheels of the Headlight tractor are
Inhaltszusammenfassung zur Seite Nr. 13
X. Instrument Panel 7 Green 4 8 3 9 Range 2 1 HOURS 1/10 RPM FUEL EF 04 x1000 5 6 Figure 11 1. Fuel Gauge 6. Brake Engaged Indicator The fuel gauge monitors the fuel level in the fuel This indicator illuminates whenever the brake pedal tank. The needle pointing to the right indicates a full is fully depressed or the parking brake is engaged tank. The ignition switch must be in the ON position and the key switch is turned to the "ON" position. to activate the fuel gauge. Check this indicator if
Inhaltszusammenfassung zur Seite Nr. 14
SECTION 2: OPERATION ROLLOVER PROTECTIVE STRUCTURE (ROPS) WARNING: A folded ROPS does not provide rollover protection. When the This tractor is equipped with a foldable Rollover ROPS is in the folded position, the seat Protection Structure (ROPS) and seat belts. When belt must NOT be used. used together they are effective in reducing injuries to the operator in the event of an accidental tractor Reposition the ROPS as follows: rollover. The safety provided by the ROPS is Loosen the two clamp k
Inhaltszusammenfassung zur Seite Nr. 15
NEW TRACTOR BREAK-IN PROCEDURES lock is engaged. NOTE: The PTO switch must be moved to the “OFF” position to restart the Proper care in the first hours of operation will help engine. to assure optimal performance of your new tractor. The safety interlock system will shut off the Never operate a new engine immediately under PTO if the reverse control pedal is depressed, full load. Allow the engine to warm up. unless the reverse override function is Avoid operating the engine for prolonged
Inhaltszusammenfassung zur Seite Nr. 16
disconnect the jumper cables in the exact Turn the ignition key clockwise to the "RUN- PREHEAT" position, and observe the glow plug reverse order of their connection. indicator light on the instrument panel. Wait Have the tractor’s electrical system checked until the glow plug indicator light turns off and repaired as soon as possible to eliminate before cranking the engine. the need for jump starting. NOTE: Preheating may not be necessary if the engine has been running and is warm. STOPPIN
Inhaltszusammenfassung zur Seite Nr. 17
IMPORTANT: Do not use the forward or reverse con- STOPPING THE TRACTOR trol pedals to change the direction of travel when the Fully depress the brake pedal to bring the trac- tractor is in motion. The abrupt direction change may tor to a complete stop. Push downward on the unseat the operator and will cause premature wear in parking brake lever and release the pedal to the transmission. Allow the tractor to stop before engage the parking brake. Refer to Figure 15. changing directions. Depres
Inhaltszusammenfassung zur Seite Nr. 18
differential lock. It may be necessary to slow the DRIVING ON SLOPES tractor, or reverse the direction of travel, to WARNING: Do not operate on inclines disengage the differential lock. with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). The tractor could overturn and cause serious injury. IMPORTANT: Always shift into LOW speed range before beginning to climb or descend a DIFFERENTIAL LOCK PEDAL slope. Shift into 4WD when descending a slope. (Depress and Oper
Inhaltszusammenfassung zur Seite Nr. 19
USING THE HYDRAULIC LIFT LEVER THROTTLE HANDLE The hydraulic lift system provides power for raising and positioning three point hitch and belly mounted equipment. To raise an attachment using the hydraulic lift system, the engine must be running. Generally, an attachment can be lowered with the engine running or off. Mid Throttle Move the lift lever forward in the slot to lower to Engage the equipment to the desired height setting. Refer to Figure 19. 3000-3500 RPM Move the lift lever rearwa
Inhaltszusammenfassung zur Seite Nr. 20
Hazard Lights Always use the flashing amber hazard lights along REAR PTO SHAFT with the SMV (Slow Moving Vehicle) emblem when operating the tractor on, or near, roadways. Also PTO activate the hazard lights when necessary to warn COVER SLOTS others that the tractor is being operated in the area. To turn on the flashing hazard lights, depress the top end of the hazard light switch located to the left of the headlight switch. Slide to Right To turn off the hazard lights, depress the and Pull O
