Inhaltszusammenfassung zur Seite Nr. 1
®
GPSMAP 700 Series Installation Instructions
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
CAutIoN
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
Notice
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging your boat.
The GPSMAP 700 series chartplotter must be properly installed according to the following in
Inhaltszusammenfassung zur Seite Nr. 2
Bail Mounting the Chartplotter Use the included bracket to bail mount the GPSMAP 700 series chartplotter. You can route cables from under the mounting surface through the included bail-mount bracket, though it is not necessary. See page 3 for instructions on installing the bail-mount bracket without routing cables through the bracket. Hardware (included): t ools required (not included): • Bail-mount bracket • Jigsaw 1 1 • Cable-organizationbracket • Drilland drill bits—1 /4in. (32
Inhaltszusammenfassung zur Seite Nr. 3
t o install the bail-mount bracket without the cables routed through the bracket: 1. Usingthe included bail-mountbracket template, determine thebest place toinstall the bracket.Be sure toleave adequate clearance behind thechartplotter for the wiring. NotE: To avoid interference ,mount the GPSMAP 700 serieschartplotter at least 32in. (813 mm) from a magnetic compass. 2. Thebail-mount bracket templatehas adhesive on the back. Removethe
Inhaltszusammenfassung zur Seite Nr. 4
> > Installing the Power/Data Cable The chartplotter comes with a power/data cable that connects the chartplotter to power and to optional NMEA 0183 devices. If applicable, the power/data cable also connects the chartplotter to a sonar transducer. The power/data cable does not connect the chartplotter to a NMEA 2000 network. For instructions on connecting the chartplotter to a NMEA 2000 network, see page 6. To help make the cable-routing process easier, the locking ring is packaged separately
Inhaltszusammenfassung zur Seite Nr. 5
+ + -- Connecting the Power/Data Cable to Power 1. Usea test light or avoltmeter to determine the polarityof the voltage source. A A fuse fuse T To 10– o 10– Vdc boat supply Vdc boat supply 2. Connect thered (+ orpositive) wire tothe positive voltageterminal. (If you usethe Boat ground Boat ground 2A 2A 3A 3A fuse block on the boat,route the positive connection through the fuse, as shown on the diagram.) 3. Connect the black (- or ground)wire to
Inhaltszusammenfassung zur Seite Nr. 6
Connecting the Chartplotter to a NMEA 2000 Network (optional) You can connect the GPSMAP 700 series chartplotter to your existing NMEA 2000 network. You will need the appropriate NMEA 2000 cables and connectors, either to connect the chartplotter to your existing NMEA 2000 network or to build a NMEA 2000 network if you do not have one installed on your boat. Contact your local Garmin dealer. If you are unfamiliar with NMEA 2000, read the “NMEA 2000 Network Fundamentals” chapter of the Technic
Inhaltszusammenfassung zur Seite Nr. 7
Identifying theRear-Panel Connectors After the power/data cable is wired to the boat (and after any optional Garmin radar, NMEA 0183, NMEA 2000, or external GPS devices are installed) connect the cables to the GPSMAP 700 series chartplotter. NOTE: You must install the locking rings before connecting the power/data cable or a Garmin radar cable to the chartplotter (page 4). t o connect a cable to the back of a GPSMAP 700 series chartplotter: 1. Carefully press the cable into the correct port
Inhaltszusammenfassung zur Seite Nr. 8
Appendix Specifications Physical Specifications Specification Measurement 29 19 1 32 32 8 Size W × H × D: 8 / × 5 / ×3 / in.(226 × 142× 80mm) Weight 2.48 lb. (1.125kg) 19 32 Display W × H: 6 × 3 / in. (152× 91mm) Case Fully Gasketed, high-impact plastic andaluminum alloy,waterproof to IEC 60529 IPX-7 Temp. Range From5°F to 131°F(from -15°C to55°C) Compass Safe 32 in. (813 mm) Distance GPS Performance Specification Parameter Measurement Receiver High-sen
Inhaltszusammenfassung zur Seite Nr. 9
Receive t ransmit 128259 Speed - WaterReferenced 129283 Cross TrackError 128267 WaterDepth 129284 NavigationData 129038 AISClass A Position Report 129285 Navigation - Route/WP information 129039 AIS ClassB Position Report 129539 GNSSDOPs 129040 AIS Class B Extended PositionReport 129540 GNSS Satsin V iew 129794 AIS Class AStatic and V oyage Related Data 130306 Wind Data 129798 AIS SAR Aircraftposition report 129799 RadioFrequency/Mode/Power 129802 AISSafety
Inhaltszusammenfassung zur Seite Nr. 10
® ® ® Garmin , the Garmin logo, GPSMAP , and AutoLocate are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. GMR™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. ® NMEA 2000 and the NMEA 2000 logo are registered trademarks of the National Marine Electronics Association. For the latest free software updates (excluding map data) throughout the life of your Garmin products, vis
