Inhaltszusammenfassung zur Seite Nr. 1
Dell Vostro V131 Owner's Manual
Regulatory Model P18S
Regulatory Type P18S001
Inhaltszusammenfassung zur Seite Nr. 2
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Information in this publication is subject to change without notice. © 2011 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the wri
Inhaltszusammenfassung zur Seite Nr. 3
Contents Notes, Cautions, and Warnings..................................................................2 1 Working on Your Computer......................................................................7 Before Working Inside Your Computer.............................................................................7 Recommended Tools.........................................................................................................8 Turning Off Your Computer.................................
Inhaltszusammenfassung zur Seite Nr. 4
9 Removing The Palm Rest........................................................................25 Installing The Palm Rest..................................................................................................26 10 Removing The Wireless Local Area Network (WLAN) Card...........29 Installing The Wireless Local Area Network (WLAN) Card............................................30 11 Removing The Wireless Wide Area Network (WWAN) Card.........31 Installing The Wireless Wide Area Networ
Inhaltszusammenfassung zur Seite Nr. 5
21 Removing The HDMI Board..................................................................61 Installing The High-Definition Multimedia Interface (HDMI) Board...............................62 22 Removing The Speakers.......................................................................63 Installing The Speakers...................................................................................................64 23 Removing The Input/Output (I/O) Board............................................
Inhaltszusammenfassung zur Seite Nr. 6
6
Inhaltszusammenfassung zur Seite Nr. 7
Working on Your Computer 1 Before Working Inside Your Computer Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your personal safety. Unless otherwise noted, each procedure included in this document assumes that the following conditions exist: • You have performed the steps in Working on Your Computer. • You have read the safety information that shipped with your computer. • A component can be replaced or--if purchased separately--inst
Inhaltszusammenfassung zur Seite Nr. 8
NOTE: The color of your computer and certain components may appear differently than shown in this document. To avoid damaging your computer, perform the following steps before you begin working inside the computer. 1. Ensure that your work surface is flat and clean to prevent the computer cover from being scratched. 2. Turn off your computer (see Turning Off Your Computer). 3. If the computer is connected to a docking device (docked) such as the optional Media Base or Battery Slice, undock it. C
Inhaltszusammenfassung zur Seite Nr. 9
• #0 Phillips screwdriver • #1 Phillips screwdriver • Small plastic scribe • Flash BIOS update program CD Turning Off Your Computer CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your computer. 1. Shut down the operating system: • In Windows Vista : Click Start , then click the arrow in the lower-right corner of the Start menu as shown below, and then click Shut Down. • In Windows XP: Click Start → Turn Off Computer → Turn Off . The co
Inhaltszusammenfassung zur Seite Nr. 10
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer. 3. Replace the battery. 4. Connect your computer and all attached devices to their electrical outlets. 5. Turn on your computer. 10
Inhaltszusammenfassung zur Seite Nr. 11
Removing The Secure Digital (SD) Card 2 1. Follow the procedures in Before Working On Your Computer. 2. Press in on the SD card to release it from the computer. 3. Grasp the SD card and pull out to release from the computer. Installing The Secure Digital (SD) Card 1. Slide the SD card into its slot and press until it clicks into place. 2. Follow the procedures in After working inside your computer. 11
Inhaltszusammenfassung zur Seite Nr. 12
12
Inhaltszusammenfassung zur Seite Nr. 13
Removing The Battery 3 1. Follow the procedures in Before Working On Your Computer. 2. Remove the Secure Digital (SD) Card. 3. Slide the release latches to unlock the battery. 4. Remove the battery from the computer. 13
Inhaltszusammenfassung zur Seite Nr. 14
Installing The Battery 1. Insert the battery into its compartment. 2. Slide the battery into its slot until it clicks into place. 3. Install the Secure Digital (SD) Card. 4. Follow the procedures in After Working Inside Your Computer. 14
Inhaltszusammenfassung zur Seite Nr. 15
Removing The Subscriber Identity Module (SIM) Card 4 1. Follow the procedures in Before Working On Your Computer. 2. Remove the battery. 3. Press in on the SIM card to release it from the computer. 4. Grasp the SIM card and pull out to release from the computer. 15
Inhaltszusammenfassung zur Seite Nr. 16
Installing The Subscriber Identity Module (SIM) Card 1. Insert the SIM card into the slot. 2. Install the battery. 3. Follow the procedures in After Working Inside Your Computer. 16
Inhaltszusammenfassung zur Seite Nr. 17
Removing The Keyboard 5 1. Follow the procedures in Before Working On Your Computer. 2. Remove the battery. 3. Pry the keyboard using a flat-head screw driver to remove the keyboard retainers that secure keyboard to the computer. 4. Flip the keyboard over and lay it on the palm rest. 5. Lift the clip to release the keyboard cable and disconnect it from the system board. 17
Inhaltszusammenfassung zur Seite Nr. 18
6. Lift the keyboard up and away from the computer. Installing The Keyboard 1. Connect the keyboard cable to the system board. 2. Insert the keyboard in its compartment. 3. Press down until the keyboard clicks into place in the computer. 4. Install the battery. 5. Follow the procedures in After Working Inside Your Computer. 18
Inhaltszusammenfassung zur Seite Nr. 19
Removing The Base Cover 6 1. Follow the procedures in Before Working On Your Computer. 2. Remove the battery. 3. Remove the screw that secures the base cover to the computer. 4. Slide the base cover towards the back of the computer. Lift it up and away from the computer. 19
Inhaltszusammenfassung zur Seite Nr. 20
Installing The Base Cover 1. Align the edge of the base cover on the computer and slide it on the computer. 2. Tighten the screw to secure the base cover to the computer. 3. Install the battery 4. Follow the procedures in After Working Inside Your Computer. 20
