Inhaltszusammenfassung zur Seite Nr. 1
Model CBC-1000
Manual Battery Charger
Voltage: 12
Amperage: 1
OWNER’S MANUAL
READ ENTIRE MANUAL BEFORE
USING THIS PRODUCT
00-99-000889/0708
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL. 1. IMPORTANT SAFETY INSTRUCTIONS 1.1 SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger Model CBC-1000. 1.2 Do not expose charger to rain or snow. 1.3 Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to per- sons. 1.4 To reduce risk of damage to electric plug and cord, pull by plug rather
Inhaltszusammenfassung zur Seite Nr. 4
2. PERSONAL PRECAUTIONS 2.1 Consider having someone close enough by to come to your aid when you work near a lead-acid battery. 2.2 Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 2.3 Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery. 2.4 If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood eye with running cold water for at l
Inhaltszusammenfassung zur Seite Nr. 5
4. CHARGER LOCATION 4.1 Locate charger as far away from battery as DC cables permit. 4.2 Never place charger directly above battery being charged; gases from bat- tery will corrode and damage charger. 4.3 Never allow battery acid to drip on charger when reading electrolyte spe- cific gravity or filling battery. 4.4 Do not operate charger in a closed-in area or restrict ventilation in any way. 4.5 Do not set a battery on top of charger. 5. DC CONNECTION PRECAUTIONS 5.1 Connect and disconnect DC
Inhaltszusammenfassung zur Seite Nr. 6
6.7 When disconnecting charger, turn switches to off, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery termi- nal. 6.8 See OPERATING INSTRUCTIONS for length of charge information. 7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY: 7.1 Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than NEGATIVE (NEG, N, –) p
Inhaltszusammenfassung zur Seite Nr. 7
8. BATTERY CHARGING - AC CONNECTIONS 8.1 For grounded, cord-connected battery chargers with an input rating less than 15 amperes and intended for use on a nominal 120-volt circuit: • This battery charger is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug illustrated in sketch A in Figure 8.3. A temporary adapter, which looks like the adapter illustrated in sketches B and C, may be used to connect this plug to a two-pole recep- tacle as shown in sketc
Inhaltszusammenfassung zur Seite Nr. 8
9. ASSEMBLY INSTRUCTIONS • No assembly required 10. OPERATING INSTRUCTIONS 10.1 This unit is a manual charger and care must be taken to prevent over- charging. Manual chargers will not shut off by themselves. While charging, manual chargers must not be left unattended as severe battery damage or other hazardous conditions may result. We recommend monitoring the battery’s condition at 1 to 2 hour intervals until full charge is reached. 10.2 Follow all safety and operating instructions in thi
Inhaltszusammenfassung zur Seite Nr. 9
When a battery is very cold, partially charged, or sulfated, it will not draw full rated amperes from charger. It is both dangerous and damaging to a battery to force a higher amperage into it than it can effectively use in recharging. 13.2 When an UNKNOWN OPERATING PROBLEM arises, please reread com- plete manual and call the customer service number for information that will usually eliminate need for return. 13.3 When charger requires repair of KNOWN DAMAGE, please call customer service n
Inhaltszusammenfassung zur Seite Nr. 10
• 8 •
