Bedienungsanleitung Lucent Technologies PC Octel 100

Inhaltszusammenfassung zur Seite Nr. 1

PC Specification Sheet
Octel 100 Version 3.2
This note provides information on the boards installed in the messaging system PC. You will need this information
when connecting the messaging system PC and when running the Configure utility.
There are two back panel diagrams provided later in this note. These diagrams provide the slot configurations for
the Desktop and Tower PC platforms.
Voice Boards
Use the following information when connecting the voice boards to the switch and when running the

Inhaltszusammenfassung zur Seite Nr. 2

PC SPECIFICATION SHEET Desktop Platform Backplane Diagram In the Desktop platform, voice boards are installed starting with the right-hand slot, as viewed from the back of the PC. On each card, the upper jack is tied to the lowest numbered ports. The example diagram indicates the connector designations for the DIALOG/4 board. When a single fax board is present, it is installed in the fourth slot from the right, as viewed from the back of the PC. If two fax boards are present, the first will be i

Inhaltszusammenfassung zur Seite Nr. 3

PC SPECIFICATION SHEET Configuring the IBM V.90 PCI Data/Fax Modem for Octel 100 The IBM V.90 PCI data/fax modem is an internal modem supported for use with Octel 100. This modem is preconfigured on Octel 100 systems. This note provides instructions for installing and configuring the modem’s device driver in the event you have to re-install the operating system. To install and configure the modem’s device driver: 1. If the messaging system running, shut it down. 2. Insert the disk labeled IBM V.

Inhaltszusammenfassung zur Seite Nr. 4

PC SPECIFICATION SHEET Notes: 101-1773-001 OCTOBER 1999, ISSUE 14