Bedienungsanleitung Telex ICW-3

Inhaltszusammenfassung zur Seite Nr. 1

INSTALLATION & OPERATION
INSTRUCTIONS
ICW-3 WINDOW INTERCOM
9350-7686-000 Rev. G 11/2002

Inhaltszusammenfassung zur Seite Nr. 2

TRADEMARKS ® AudioCom is a registered trademark of Telex Communications. Names of other products mentioned herein are used for identifi- cation purposes only and may be trademarks and/or registered trademarks of their respective companies. WARRANTY INFORMATION Products are warranted by Telex Communications, Inc. to be free from defects in materials and workmanship for a period of one year from the date of sale. The sole obligation of Telex during the warranty period is to provide, without charge

Inhaltszusammenfassung zur Seite Nr. 3

UNPACKING & INSPECTION ICW-3 Package 1. IEC cord. 2. Switching power supply. 3 3. ICW-3 to power supply cord. 4. #6 screws 1” (3). 4 5. Adjustment screwdriver. 5 2 6. Customer assembly. 7. Operator assembly. 1 6 7 Figure 1 - ICW-3 system components. Unpack the equipment from the shipping case and inspect for missing or damaged components. You should have all of the items listed next to Figure 1. RECOMMENDED ITEMS 1. No. 1 Phillips screwdriver 2. Equipment for cutting/drilling hole(s) for mountin

Inhaltszusammenfassung zur Seite Nr. 4

Figure 2 - ICW-3 Assembly detail. INSTALLATION 1. Remove the two screws (one on each side) holding the mounting plate to the operator assembly. (See Figure 3) 2. Measure and identify the location where the intercom is to be mounted. 3. Attach the mounting template to the window (customer assembly side) being sure to center the appropriate guide in the location identified in step 2. Note: There are two guides provided on the last page of these instructions. Use either the single large hole, or mu

Inhaltszusammenfassung zur Seite Nr. 5

Figure 3 - Customer and operator assemblies. Figure 4 - Mounting template. Figure 5 - Customer side mounted. Figure 6 - Connecting customer and operator assemblies prior to final mounting. VOX CIRCUIT ADJUSTMENT Note: The unit is shipped from the factory with the VOX circuit pre-adjusted. Use this procedure only if you encounter a problem where the VOX circuit does not properly switch between the operator and customer when they are talking. In some situations, particularly when ambient noise lev

Inhaltszusammenfassung zur Seite Nr. 6

OPERATION Operator Side Connection for goosneck microphone. Controls volume of loudspeaker on the operator side. Rotate Loudspeaker is inter- knob clockwise to rupted when head- increase volume. phones are in use. Controls volume of the loudspeaker on the customer side. Rotate knob clockwise to When the Mute button increase volume. is pushed in, the customer cannot hear VOX 1 Circuit Adjustment what the operator is (Customer Side) saying. VOX 2 Circuit Adjustment (Operator Side) Headphone connec

Inhaltszusammenfassung zur Seite Nr. 7

CUT HERE