Inhaltszusammenfassung zur Seite Nr. 1
Snapshot
LX5™
OK on Dimmer
Outdoor OK
Sound Activated
DMX512
Master/Slave
115V/230V Switch
Replaceable Fuse
User Serviceable
Duty Cycle
USER MANUAL
th
Chauvet, 3000 N 29 Ct, Hollywood, FL 33020 U.S.A.
(800) 762-1084 – (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS 1. BEFORE YOU BEGIN....................................................................................................................................................... 3 WHAT IS INCLUDED................................................................................................................................................................................ 3 UNPACKING INSTRUCTIONS ...........................................................................................
Inhaltszusammenfassung zur Seite Nr. 3
1. BEFORE YOU BEGIN What is included 1 x LX5™ Power Cord Warranty Card User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the
Inhaltszusammenfassung zur Seite Nr. 4
Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixtu
Inhaltszusammenfassung zur Seite Nr. 5
2. INTRODUCTION Features LED moonflower effect Selectable functions: sound, rotating, static Additional power output for daisy chaining units (max 50 units) Sound sensitivity knob Ultra bright LEDs Low power consumption Product Overview Mounting Bracket Connection Panel (rear) Lens 110/230V Selector Switch Sound Sensitivity Adjustment Mode Knob Selector Switch IEC Power Power Output Connector with For LX series only! Fuse Holder Max 50 units LX5 5 9/17/2007 12:27 PM
Inhaltszusammenfassung zur Seite Nr. 6
3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement With a flat head screwdriver wedge the fuse The fuse is located holder out of its housing. Remove the damaged inside this compartment. fuse from its holder and replace with exact Remove using a flat same type fuse. Insert the fuse holder back in head screwdriver. its place and reconnect power. Mounting ORIENTATION This fixture may be mounted in any position prov
Inhaltszusammenfassung zur Seite Nr. 7
4. OPERATING INSTRUCTIONS The LX5 can operate in Sound-Active or Auto mode, which is determined by the position of the switch located on the rear of the unit. The mode of the unit refers to the reaction of the LEDs only as there are no moving parts in the unit. To switch between the two modes, place the switch in either the “I” or “O” position. In the “I” position, the fixture operates in Sound-Active mode, the sensitivity of which can be adjusted by the knob also located on the rear of t
Inhaltszusammenfassung zur Seite Nr. 8
General Troubleshooting Applies to Foggers Dimmers Symptom Solution(s) Lights & Snow Controllers & Chaser Auto shut off Check fan thermal switch reset Beam is very dim or Clean optical system or replace lamp not bright Check 220/110v switch for proper setting Breaker/Fuse keeps Check total load placed on device blowing Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Check device’s fuse. (internal and/or external) Fixture is on
Inhaltszusammenfassung zur Seite Nr. 9
General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power. Use a vacuum o
Inhaltszusammenfassung zur Seite Nr. 10
Technical Specifications WEIGHT & DIMENSIONS Length............................................................................................................................. 8.8 in (224 mm) Width .............................................................................................................................. 5.3 in (135 mm) Height ............................................................................................................................. 8.5 in (216 mm) Weig
