Bedienungsanleitung GE Magnetic Swipe Card Reader TS0861

Inhaltszusammenfassung zur Seite Nr. 1

g
GE Interlogix
TS0861 Magnetic Swipe Card Reader
Installation Guide

1 x TS0861 Magnetic Swipe Card Reader.
Installation Kit
1 x Installation Guide (this document).
2 x 3x6mm post button head screws that can be used to
replace the standard Phillips head screws for increased
resistance to tampering.
• The TS0861 interfaces to the
Product Features
TS0862 Smart Door Controller.
• Operates from +5VDC supplied by
TS0862, eliminates the need for extra
power supply.
• Mounts on stan

Inhaltszusammenfassung zur Seite Nr. 2

The TS0861 Magnetic Swipe Card Reader is designed to Description mount on metal window or door frames (mullions or architraves) and is suitable for any indoor location that requires a small reader. The TS0861 incorporates all interface electronics necessary to interface to the TS0862 Smart Door Controller. The reader operates on +5VDC supplied directly from the TS0862. The TS0861 may also be used with other suitably-configured products that have a Wiegand interface, including the TS

Inhaltszusammenfassung zur Seite Nr. 3

Caution The TS0862 pwr link (or other supply) must be set to +5 volts. Using the holes provided on the base, mount the TS0861 to Mounting the metal window or door frame using suitable hardware (not supplied). See Figure 1 for connection details. Connections TS0861 Magnetic Swipe Card Reader Installation Guide 3

Inhaltszusammenfassung zur Seite Nr. 4

Key to J2 wiring block on TS0862: EG = Egress. + = 5V power supply, red wire. 0V = LAN Ground — 0V connection, black wire. D0 = Data 0 — Clock connection to Reader, green wire. D1 = Data 1 — Data connection to Reader, white wire. L1 = LED 1 — Reader green LED, brown wire. See Door Data Menu. L2 = LED 2 — Reader red LED, orange or yellow wire. See Door Data Menu. BZ = Buzzer — Reader beeper, blue wire. Figure 1 Connecting the TS0861 Magnetic Swipe Card Reader to the

Inhaltszusammenfassung zur Seite Nr. 5

Note — LED operation is configurable via the TS0862 Smart Testing Door Controller. Refer to the TS0862 Smart Door Controller Installation & Programming Guide for details. The following process checks a typical installation of a TS0861 Magnetic Swipe Card Reader interfacing with a TS0862 Smart Door Controller. Check for correct operation: 1. Set the door to the ‘Access’ state and check that the Green LED (LED 1) is illuminated. 2. Swipe a suitable Magnetic Swipe Card through the TS086

Inhaltszusammenfassung zur Seite Nr. 6

Notes TS0861 Magnetic Swipe Card Reader Installation Guide 6

Inhaltszusammenfassung zur Seite Nr. 7

Notes TS0861 Magnetic Swipe Card Reader Installation Guide 7

Inhaltszusammenfassung zur Seite Nr. 8

N4131 Note — This product conforms to the standards set by Standards Australia on behalf of the Australian Communications Authority (ACA). This is a Class A product. In a domestic environment this Warning product may cause radio interference, in which case the user may be required to take adequate measures. The customer is responsible for testing and determining the Disclaimer suitability of this product for specific applications. In no event is GE Interlogix Pty Limited responsi