Bedienungsanleitung Xantech ISM4

Inhaltszusammenfassung zur Seite Nr. 1

TYPICAL SYSTEM CONNECTIONS
ISM4 INTELLIGENT SYSTEM MANAGER
PROGRAMMING QUICK START GUIDE




Front




Rear






This ISM4 Programming Quick Start Guide provides the basic instruction to programming an ISM4. To use the Quick Start Guide, fill
out the Macro Programming Table and follow the Programming Instructions. For complete instructions on installation, connections and
additional programming capabilities, refer to the ISM4 Installation & Programming Manual.

The Syst

Inhaltszusammenfassung zur Seite Nr. 2

MACRO PROGRAMMING TABLE IR Source 1 Source 2 Source 3 Source 4 Command ON OFF ON OFF ON OFF ON OFF Brand Device Command

Inhaltszusammenfassung zur Seite Nr. 3

PROGRAMMING INSTRUCTIONS The following instructions cover the basic Source programming procedure. Each Source ON and OFF Macro can include up to five IR Commands. Please refer to the ISM4 Installation & Programming Manual for complete programming instructions. To properly Program and Test IR Commands, each of the Source IR Emitters must be connected to the appropriate ISM4 Source IR Out Port, and attached to the appropriate device over the IR Eye. If Source 1 is going to be turned

Inhaltszusammenfassung zur Seite Nr. 4

Adding Delays 9. To add a DELAY after the IR Command (following Step 5), press the DELAY button. The PROGRAM LED will flash once to indicate that the ISM4 has entered delay mode. 10. Press the NEXT button once for each second of delay to be added to the IR Macro Command. Press the PREV button once for each second of delay to be subtracted. To save the Delays, press and release the SEQUENCE button. NOTE: The first press of the NEXT button will add one second of delay. Each additional

Inhaltszusammenfassung zur Seite Nr. 5

Deleting IR Commands and Macros 17. Delete a Single IR command (must be in EDIT mode): Press and release the DELETE button. The PROGRAM LED will blink once indicating that the IR command was deleted. 18. Delete a Macro: Press and hold (approximately 2 seconds) the DELETE button until the SOURCE (active Source) blinks once. The PROGRAM LED will blink once indicating that the Macro was deleted. 19. Delete All Macros: Press and hold (approximately 4 seconds) the DELETE button unti

Inhaltszusammenfassung zur Seite Nr. 6

NOTES

Inhaltszusammenfassung zur Seite Nr. 7

NOTES

Inhaltszusammenfassung zur Seite Nr. 8

(Effective for products sold after October 1, 2006) Xantech Corporation (“Xantech”) warrants to the holder of a valid proof of purchase as the first end-user purchaser (“You”), its products to be free from defects in materials and workmanship as defined herein, for the periods specified below from the date of purchase. This limited warranty extends only to You for product purchased and used in the United States of America. For product purchased outside of the United States of America, the t