Bedienungsanleitung Harman-Kardon AB 2

Inhaltszusammenfassung zur Seite Nr. 1

AB2 Owner’s Manual 1/25/08 4:25 PM Page 1
Always observe the appropriate safety codes for concealed What Is Included Press and hold this button to select The Bridge/DMP as the Input-Cable Connection Block – Using standard IDC punch-
Introduction
®
wiring. Be extremely careful not to cut through or drill into • Two self-starting, universal-head machine screws for mounting multiroom source. If a compatible iPod (not included) is docked in down tools, connect the Category 5/5e cable linking the

Inhaltszusammenfassung zur Seite Nr. 2

AB 2 Amplified In-Wall Module AB2 Owner’s Manual 1/25/08 4:25 PM Page 2 When making the connections at each end of the cable, strip the trim control down in the opposite direction until the clipping Selector Tap/ABR Remote Press and Hold • The source is turned on, media is loaded, and the Multiroom (AB 2 only) the outer insulation jacket about 1-1/2" to 2" from the end. The stops. This is the correct level for your specific A-BUS-equipped mode is properly activated. cable is constructed of fo