Bedienungsanleitung Earthquake Sound BP112

Inhaltszusammenfassung zur Seite Nr. 1

EARTHQUAKE SOUND
12" POWERED & LOADED
BANDPASS ENCLOSURE
Owners Manual
MODEL:
BP112
The Sound That Will Move You.
Earthquake Sound reserves the right to amend details of the specifications without notice.
Copyright © Earthquake Sound Corporation
Earthquake Sound Corporation • 2727 McCone Avenue Hayward CA, 94545 • Phone: 510-
732-1000 Fax: 510-732-1095
Sound That Will Move You.

Inhaltszusammenfassung zur Seite Nr. 2

WARRANTY TABLE OF CONTENTS Cautions and Advisories Page • 2 Five (5) year limited warranty: Earthquake warrants the original purchaser that all Factory Sealed New Audio Warranty Page • 3-4 Products be free from defects in material and workmanship under normal and proper use Specifications Page • 5 for a period of five (5) years from the date of purchase (as shown on the original bill of sale Installation Page • 6 wit

Inhaltszusammenfassung zur Seite Nr. 3

WARRANTY SPECIFICATIONS warranty claim will not be valid if the warranty registration card is not properly filled Max Power: 2000-Watts out & returned to Earthquake with a copy of the sales invoice. Speaker impedance: 4ohm A Peak power: 565W (4ohm) RMS power: 400W (4ohm) (E) Service Request: Frequency Response: 5Hz (+0.5dB)---350Hz (-3dB) To receive product/s service, contact Earthquake's service department at Phase shift: 0-180 (510) 732-1000 and request an RMA number (Return Material Author

Inhaltszusammenfassung zur Seite Nr. 4

POWER SUPPLY CONNECTIONS TUNING BP112 Power-Supply Connections BP112 provides several controls that simplify sonic integration with virtually any HI INPUT LOW vehicle’s unique acoustic properties. Please read the following section carefully INPUT Positive: Connect a wire (at least 12-gauge) L+ R+ to familiarize yourself with the function of each control. L between the vehicles +(positive) battery terminal and the "+12V" connection on BP112 R L- R- amplifier. You must install a fuse holder w

Inhaltszusammenfassung zur Seite Nr. 5

TUNING BP112 Phase Control: The phase control is a switch located on the panel with the electrical connections. This switch will reverse the phase of BP112's output with respect to its input. When installing BP112 with an existing factory or aftermarket system, depending on BP112’s location in the vehicle and the distance between it and the other speakers in the car, reversing the phase (by moving the phase switch) may produce a discernable increase or decrease in the amount of upper bass

Inhaltszusammenfassung zur Seite Nr. 6

1. Start with gain control set to minimum and the crossover control and bass TROUBLESHOOTING control rotated midway, to 12 o’clock. 1. Power LED not lit: fuse blown, head unit not functioning properly (no 2. Choose program material with substantial bass content and turn the remote voltage), faulty power, ground or remote connection. volume control on your head unit to three-quarters of its total output (approximately 3 o’clock on rotary controls). 2. Power LED lit but no sound output: inputs