Bedienungsanleitung PASCO Specialty & Mfg. CI-6742

Inhaltszusammenfassung zur Seite Nr. 1

012-06757B
08/98
Instruction Sheet
$1.00
for the PASCO
Model CI-6742
Motion Sensor II
Narrow/Std.
Introduction
ultrasonic switch
target
transducer
indicator
The PASCO CI-6742 Motion Sensor II is a sonar
LED
ranging device with a sensing range of 0.15 to about 8
meters. When used with an interface, the Motion
Sensor II emits ultrasonic pulses and detects pulses
positioning
dial
returned as echoes from the target. The
ScienceWorkshop program calculates the distance to
the object from the speed of

Inhaltszusammenfassung zur Seite Nr. 2

Motion Sensor II 012-06757B Equipment 3. Set the Narrow/Standard (Std.) switch based Included: on your application. For experiments that • PASCO CI-6742 Motion Sensor II involve sensing distances of 2 meters or less • detachable cable with two color-coded phone with highly reflective targets (such as a typical plugs Dynamics Track experiment), set the switch to Additional Equipment Required: Narrow. This setting reduces sensitivity to • computer and ScienceWorkshop 500, 700, or false targets ne

Inhaltszusammenfassung zur Seite Nr. 3

012-06757B Motion Sensor II 6. Open a Graph display in ScienceWorkshop. 7. Start monitoring data. Note: When the ScienceWorkshop program is set to monitor or record data, the Motion Sensor II transducer will be triggered to produce the ultrasonic pulses that are used by ScienceWorkshop to determine the location of the target. 8. Adjust the angle of the transducer, the Narrow/Std. mode, and the trigger rate as necessary to achieve the optimal signal. Note: The LED will light when the Motion Se

Inhaltszusammenfassung zur Seite Nr. 4

Motion Sensor II 012-06757B frequency energy and, if not installed and used in Operation with CBL and EA-100 systems accordance with the instructions, may cause harmful An accessory cable (available separately, PASCO interference to radio communications. However, there part no. 514-06862) is required for operation of the is no guarantee that interference will not occur in a Motion Sensor II with a Texas Instruments CBL particular installation. If this equipment does cause System™ or a Casio EA-1