Bedienungsanleitung Chamberlain THE PROTECTOR SYSTEM 916GA

Inhaltszusammenfassung zur Seite Nr. 1

®
®
THE PROTECTOR SYSTEM
WARNING
WARNING
SAFETY SENSORS MODEL 916GA
®
The Safety Sensor Kit is compatible with Chamberlain Gate Access
Systems GA400D, GA420D, and GA200D. The Safety Sensors are
CAUTION
WARNING WARNING
designed to detect an obstacle in the path of the electronic beam and
stop the gate operator.
To prevent SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing
ANY service or maintenance.
CARTON INVENTORY
• Correctly connect and align the safet

Inhaltszusammenfassung zur Seite Nr. 2

WARNING WARNING POWER CAUTION CAUTION WARNING Disconnect power and batteries to the operator. To AVOID damaging gas, power or other underground utility lines, SAFETY SENSOR POSTS contact underground utility locating companies BEFORE digging. Use a metal or treated wood post (not provided) to elevate the sensors. Safety sensors must be installed no higher than 24" (61 cm) above the ground. ENTRAPMENT Safety Sensor Posts CLOSE AVERTISSEMENT AVERTISSEMENT Safety Sensor Posts ATTENTION AVERTISSE

Inhaltszusammenfassung zur Seite Nr. 3

ASSEMBLE SAFETY SENSORS Insert hex head bolt through safety sensor and slide safety sensor into bracket. Secure with wing nut. MOUNT SAFETY SENSORS Mount safety sensor assembly to post using appropriate hardware (not provided). Safety sensors must be installed no higher than 24" (61 cm) above the ground. NOTE: Install safety sensor assembly with the two holes in the bracket facing up and the LEDs visible at the top. Safety Sensor Post Safety Sensor Safety Sensor Post Assembly Mark Safety S

Inhaltszusammenfassung zur Seite Nr. 4

U3 BLU RED WHT BRN GRN YEL MOV2 R4 Z22 C33 C68 C2 T ALARM Q6 Q12 Q1 JU1 F11 F2 J18 MOV1 P1 C69 JU1 R186 C12 J2Ø JU1 C11 R329 D4 D1 R27 D8 R9 C64 J19 K4 K3 K2 K1 Q9 J24 J23 3ØA 32V MODEL GA200D NOTE: If the safety sensor wires need to be extended, the polarity must be maintained when connecting the safety sensors to the control board. The black striped wire connects to the negative (-) terminal and the red wire connects to the positive (+) terminal. MODEL GA200D ONLY • Insert red lead wire in