Inhaltszusammenfassung zur Seite Nr. 1
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 1
®
Bluetooth Headset
for Mobile Phones
ET2000 v1.2
User Guide
Inhaltszusammenfassung zur Seite Nr. 2
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 2
Inhaltszusammenfassung zur Seite Nr. 3
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 1 USER GUIDE Contents Overview ............................................................................................................................ 2 Unpacking ezTalker mini .................................................................................................. 2 Getting to Know ezTalker mini .......................................................................................... 3 Getting Started ..................................
Inhaltszusammenfassung zur Seite Nr. 4
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 2 Overview TM ezTalker mini by Tekkeon is a miniature cord-free headset that enables comfortable, ® handsfree communication with your Bluetooth mobile phone. ezTalker mini works with your Bluetooth mobile phone to provide clear, high-quality communication. While using your ezTalker mini headset, you can store your mobile phone in your pocket, backpack, or briefcase—just about anywhere in close proximity that is convenient for you. ezTalker mini is comp
Inhaltszusammenfassung zur Seite Nr. 5
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 3 Getting to Know ezTalker mini TALK Button Used for turning headset on/off, pairing, and making/receiving calls Amber and Blue LEDs Provides visual indication of headset status: power on/off, pairing mode, muting mode, charging mode, and low battery Speaker Charging Jack Input for power adapter to charge the headset Volume Control Used to adjust the speaker volume, mute the Microphone microphone and initiate last number redial Getting Started Before u
Inhaltszusammenfassung zur Seite Nr. 6
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 4 Charging ezTalker mini Before using ezTalker mini, you must charge the headset for approximately two hours. When fully charged, the battery provides up to five hours of talk time and up to 120 hours of standby time. To Charge the Headset 1. Remove the rubber plug that covers the charging jack on the upper left side of the headset. 2. Plug the power adapter into the charging jack. 3. Plug the power adapter into a wall outlet. While the headset is char
Inhaltszusammenfassung zur Seite Nr. 7
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 5 To Pair the Devices 1. Turn on the mobile phone and place it next to the headset. 2. Initiate the Bluetooth device-pairing (discovery) feature on the mobile phone. Refer to the mobile phone user guide for instructions on initiating this feature. 3. With the headset turned off, press and hold the TALK button until the blue and amber LEDs flash alternately or until you hear Pairing tone (approximately five seconds). 4. Release the TALK button. The he
Inhaltszusammenfassung zur Seite Nr. 8
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 6 Fitting ezTalker mini On Your Ear ezTalker mini is designed to fit comfortably in your ear. For added comfort, you can change the ezFit Earpiece. For added stability, you can add the ezEarhook. To Place the Headset On Your Ear 1. Place the ezTalker mini speaker in your ear with the microphone angled toward your mouth. The headset should fit snugly in your ear and remain in your ear when you move your head. However, if the ezEarpiece is too large for
Inhaltszusammenfassung zur Seite Nr. 9
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 7 To Remove the ezEarhook 1. Gently pull the ezEarhook away from the headset stem until it separates from the headset. Powering ezTalker mini To Turn On the Headset 1. Press and hold the TALK button until the blue LED flashes or until you hear the On tone (approximately four seconds). The headset turns on and is placed in standby mode, ready to make and receive calls. While the headset is on and in standby mode, the blue LED will flash at two-second
Inhaltszusammenfassung zur Seite Nr. 10
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 8 To Make Calls Using Voice Dialing (if supported by your mobile phone) 1. Press the TALK button on your headset. You will hear two beeps. 2. When prompted by the mobile phone (usually about five seconds), speak the name of the person you wish to call. The call is automatically connected to your headset. TIP: In a noisy environment, you should dial the number from the mobile phone keypad as the loud background noise may interfere with voice commands. R
Inhaltszusammenfassung zur Seite Nr. 11
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 9 To Answer a Call Waiting Call (if supported by your mobile phone) 1. When you hear two beeps while connected on a call, press and hold the Volume button until - you hear a short beep followed by a long tone (approximately 3 seconds). The original call will be placed on hold and the new call be will be connected. Your phone will display the incoming and connected calls. 2. While connected on a call, press and hold the Volume button to toggle between t
Inhaltszusammenfassung zur Seite Nr. 12
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 10 Adjusting the Volume The volume can be adjusted using the volume controls on ezTalker mini or your mobile phone. To Increase the Volume 1. Press and release the top VOLUME button+. Figure 4. To Decrease the Volume Volume buttons 1. Press and release the bottom VOLUME button . - Muting ezTalker mini You can mute and un-mute the microphone temporarily so that you cannot be heard by the connected party. To Mute the Headset 1. With a call connected to
Inhaltszusammenfassung zur Seite Nr. 13
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 11 Visual and Audible Indicators Two LEDs (blue and amber) indicate the status of the headset, while tones heard through the headset provide an audible indication of a requested action. Following are descriptions of visual and audible indicators provided by your ezTalker mini headset. Visual Indicators LED Status Indicates Blue LED flashes at two-second Headset is in standby mode, ready to make and receive calls. intervals Blue and amber LEDs flash Hea
Inhaltszusammenfassung zur Seite Nr. 14
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 12 Troubleshooting Issue Solution When you initiate the Bluetooth device Verify that ezTalker mini is placed in Pairing Mode (blue and amber LEDs pairing feature on your mobile phone, are flashing alternately). If not, place the headset in Pairing Mode. your phone cannot find ezTalker mini. Your ezTalker mini headset is not Ensure that the headset is on and charged, and that you have paired the communicating with your mobile phone. headset with your Bl
Inhaltszusammenfassung zur Seite Nr. 15
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 13 Troubleshooting (continued) Issue Solution 1.Ensure that your Bluetooth mobile phone is set to Bluetooth mode, Even though your headset is turned on, and that ezTalker mini (BTHS) has been selected as the connected the call is not automatically connected Bluetooth device. (This is important as most Bluetooth phones are to ezTalker mini when you dial a number designed to pair with more than one Bluetooth device.) on your mobile phone. 2.The proble
Inhaltszusammenfassung zur Seite Nr. 16
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 14 Disclaimer of Warranties Any user of this product does so at the user’s own risk. To the maximum extent permitted by applicable law, Tekkeon, Inc. and its suppliers provide the hardware and any support services related thereto “as is” and with all faults; and hereby disclaim all warranties and conditions, whether express, implied or statutory, including, but not limited to implied warranties of merchantability, fitness for a particular purpose, non-
Inhaltszusammenfassung zur Seite Nr. 17
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 15 FCC Statement for Class B Digital Devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
Inhaltszusammenfassung zur Seite Nr. 18
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 16 NOTES: 16
Inhaltszusammenfassung zur Seite Nr. 19
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 17
Inhaltszusammenfassung zur Seite Nr. 20
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 18 www.tekkeon.com © 2004, 2005 Tekkeon, Inc. All Rights Reserved Rev. A4 10/05
