Bedienungsanleitung Vector VEC012APC

Inhaltszusammenfassung zur Seite Nr. 1

VEC012APC
TWO YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing, Ltd., regarding this product. There is no other warranty, other
than those described herein.
This Vector Manufacturing, Ltd. product is warranted, to the original purchaser only, to be free of defects
in materials and workmanship for two years from the date of purchase without additional charge. The
warranty

Inhaltszusammenfassung zur Seite Nr. 2

SAFETY INFORMATION CONTENTS 1. INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5 WARNINGS: (Warning statements identify conditions or practices that may result in personal 2. USING VECTOR JUMPER AS A JUMP-START SYSTEM . . . . . . . . . 6 injury or loss of life) 2.1 Easy, Step-by-Step Jump-starting Instructions . . . . . . . . . . . . . 7 1) When working with lead acid batteries, always make sure immediate assis- tance is available in case of accident or emerge

Inhaltszusammenfassung zur Seite Nr. 3

CAUTION: INTRODUCTION Caution statements advise against certain conditions and practices that may Congratulations on selecting the VECTOR® JUMP-STARTER, AIR COMPRESSOR result in damage to vehicles, appliances and/or the jump-starter. and 12 VOLT DC POWER SUPPLY. This compact jump-starter is unique in the amount of energy it can supply for its size. The internal battery is a high densi- IMPORTANT: ty sealed, lead-acid battery that stores and delivers energy comparable to full Although this unit

Inhaltszusammenfassung zur Seite Nr. 4

9 2 2. USE AS A JUMP-START SYSTEM 1 10 4 WARNING: 3 14 1. Before using this system to jump-start any vehicle or boat, read and 6 understand all instructions, safety tips, warnings, cautions and first aid 5 information provided in this manual and on the product labeling. Additional important information may also be provided by the vehicle’s battery system manufacturer. 2. Be aware of first aid procedures before attempting jump-start procedure. 7 3. Always wear protective eyewear when working

Inhaltszusammenfassung zur Seite Nr. 5

2.1 EASY, STEP-BY-STEP JUMP-STARTING INSTRUCTIONS • There is a risk of explosive gases being released when batteries are charged or This jump-starter is equipped with an automatic ON/OFF that only allows jump-start discharged, failure to follow instructions may cause property damage, explosive energy to flow when proper connections are made to battery and frame. The auto- hazard, and/or personal injury. • matic ON/OFF works in conjunction with an audible reverse polarity alarm and a Always use

Inhaltszusammenfassung zur Seite Nr. 6

3. After initial 24 hour charge, charge this device for at least 14-16 hours or until Table II shows the estimated 12 volt DC operation time when using a fully the green FULL indicator lights. Charge at least once a month when not in use. charged system. ® 4. When charging is completed and the green FULL LED lights, remove the Table II - VECTOR as a 12 Volt DC Power Supply AC/DC charger plug and store in a safe place. Appliance Estimated Power Usage Operating Time ® NOTE: The unit cannot be ov

Inhaltszusammenfassung zur Seite Nr. 7

7. REPLACEMENT PARTS 6.2 Tire inflation or products with a valve stem 1. Place connector (chuck) on valve stem. For replacement parts (batteries, nozzles, etc.), contact Vector Customer Service: (954) 584-4446 or toll-free (866) 584-5504. 2. Push connector toward valve stem and close thumb latch. 7.1 Battery replacement 3. Make sure connector is pushed onto valve stem as far as possible before clos- ing thumb latch. It is recommended that the unit be returned to Vector Customer Service for bat-