Inhaltszusammenfassung zur Seite Nr. 1
Wireless
WIRELESS STEREO HEADPHONES
INSTALLATION AND
OPERATING INSTRUCTIONS
AW770
Inhaltszusammenfassung zur Seite Nr. 2
Wireless Stereo Headphones Installation and Operation Manual Model AW770 CONTENTS Connect the Transmitter .............................................................................................. 4 Power the Headphones .............................................................................................. 5 Adjust the Transmitter.................................................................................................. 6 Tune the Headphones ....................................
Inhaltszusammenfassung zur Seite Nr. 3
U L A. Self-Adjusting Headband B. Battery Compartment Cover C. Power Indicator Light A D. Charge Input Jack E. Power ON/OFF Button F. Volume Control Wheel L R G. Tuning Control Wheel H. Tuning Indicator Light POWER STEREO I. Audio Level Indicator Light B C D E F G H J. Charge Output Jack K. Transmitter Power Input Jack O N I L. Output Level Control Wheel DC 12V FREQ. CHARGE LEVEL ADJUST M. Audio Input Cable N. Frequency Control Wheel J K L M P O. Antenna P. AC Adapter Q Q. “Y” Cable Adapter R S
Inhaltszusammenfassung zur Seite Nr. 4
UL MODEL: 35- 12- 150C E1A 172 9310 D MADE IN CHINA I DIRECT PLUG-IN CLASS 2 TRANSFORMER 1\P: 120V AC 60HZ 5W D / P 1 2 92 VN D 5 C 150mA L STED E100839 LR 98553 Transmitter Power CONNECT THE TRANSMITTER Input Jack (K) Connect the transmitter as follows: DC 12V FREQ. CHARGE LEVEL ADJUST Step 1 Power the Transmitter 1. Insert the power cord from AC Adapter (P) into the Transmitter Power Input Jack (K).
Inhaltszusammenfassung zur Seite Nr. 5
UL Battery POWER THE HEADPHONES Compartment The AW770 headphones are powered by 3 AAA Cover (B) Nickel Cadmium (Ni-Cd) batteries. Insert the Batteries L R 1. Make sure the headphone Power ON/OFF Button (E) is “OFF” or in the “out” position. 2. Remove Battery Compartment Cover (B) by pushing down and out at the same time on the POWER STEREO notch at the top of the cover. Power On/Off Button (E) 3. Insert batteries following polarity (“+” and “–”) as diagrammed inside battery compartment. Charg
Inhaltszusammenfassung zur Seite Nr. 6
For maximum battery life, it is recommended that you fully discharge the batteries about once every 30 days, followed by an Extended Use charge. To discharge the batteries, simply leave the headphones turned “ON” until the Power Indicator Light goes out. About Batteries WARNING: The AW770 built-in charger will charge Ni-Cd batteries only. DO NOT attempt to recharge alkaline or rechargeable alkaline batteries as this will damage the headphones and/or transmitter. Over time, with repeated use, Ni-
Inhaltszusammenfassung zur Seite Nr. 7
Note: If the light does not flicker, confirm secure connection of the AC Adapter. If the light still does not flicker, confirm secure connection to the audio source output. If, there is still no response, leave the Output Level Control Wheel completely to the left (as shown) and see the following Note. Note: If the transmitter is connected to a variable output (i.e. headphone jack, TV audio out) on the audio source, leave the Output Level Control Wheel turned all the way to the left (as shown)
Inhaltszusammenfassung zur Seite Nr. 8
Hint: When connecting to the fixed audio outputs of a VCR, remember that for the wireless system to work, the VCR must be active. In other words, turn the TV on to the channel you would normally use to watch a videotape (channel 3 or 4), turn the VCR on, then press the TV/VCR button on your VCR remote control one time to make the VCR the controlling piece of equipment. At this point, whatever channel is showing on the tuner for the VCR should be the channel playing on the TV. Change channels on
Inhaltszusammenfassung zur Seite Nr. 9
In another variation, there are those who wish to listen to TV in such a way that no sound comes from the TV speakers. Hint: If you wish to use the headphones in such a way that you are the only person who can hear the audio from the TV (e.g. use them in bed while another person in the room is sleeping), connect as described in the above Hint. However, if there is no VCR to connect to, use the following configuration: Connect to the variable audio outputs of the TV, then turn the TV’s internal s
Inhaltszusammenfassung zur Seite Nr. 10
Trouble Checks and Adjustments No Sound/ • Check the batteries – they may be weakening. Distortion/ Static • Confirm the batteries are “good.” When batteries begin to weaken, there can be static breakup. If necessary, replace/recharge the batteries. • Check that the antenna is in the upright position • Check that the Transmitter Audio Level Indicator Light is flickering intermittently. If you are using a fixed output and the light is on solid or flickering very rapidly, or if the light is not
Inhaltszusammenfassung zur Seite Nr. 11
SPECIFICATIONS & FEATURES Transmitter Omnidirectional Effective Transmitting Range: Up to 300 feet* Adjustable Audio Level Input Variable Frequency Adjustment between 912.5 and 914.5 MHz Line Audio Input with 3.5mm Stereo Mini Plug plus 1/4" and Composite “Y” Cable Adapter UL-Listed AC Adapter Headphones Power ON/OFF Button (left headphone) Volume Control (right headphone) Frequency Fine Tuning (right headphone) Frequency Response: 20 Hz - 20 kHz Speaker Element: 40mm, Titanium-Impregnated Myla
Inhaltszusammenfassung zur Seite Nr. 12
WARRANTY ONE YEAR LIMITED WARRANTY Recoton Corporation (the Company) warrants to the original retail purchaser of this product that should the product or any part thereof be proven defective in material or workmanship within One Year from the date of original purchase, such defects will be replaced without charge for parts or labor. This warranty does not apply to any incidental or consequential damages. To obtain replacement within the terms of this warranty, the product should be delivered, tr
