Bedienungsanleitung Nady Systems UB-10

Inhaltszusammenfassung zur Seite Nr. 1

URR-10
UHF Wireless Microphone System
URR-10 RECEIVER
UB-10 BODYPACK TRANSMITTER
UH-10 HANDHELD MICROPHONE
NADY SYSTEMS, INC.
6701 Shellmound Street
Emeryville, CA 94608 USA
Tel: 510.652.2411 • Fax: 510.652.5075
E-mail: service@nadywireless.com
OWNER'S MANUAL
www.nadywireless.com

Inhaltszusammenfassung zur Seite Nr. 2

CONTENTS CONTENTS ............................................................................................. 3 INTRODUCTION ...................................................................................... 4 URR-10 RECEIVER ................................................................................... 5 Nady wireless systems are type accepted under FCC rules, parts UH-10 HANDHELD MICROPHONE .......................................................... 8 90, 74 and 15. UB-10 BODYPACK TR

Inhaltszusammenfassung zur Seite Nr. 3

INTRODUCTION SPECIFICATIONS Thank you for purchasing a Nady URR-10 Diversity Wireless Microphone System and Frequency Response URR-10 TRANSMITTERS congratulations on your choice. The URR-10 is the best performance and price value 50 Hz - 15 KHz, +/- 3 dB Audio Inputs available in rackmount UHF wireless systems and is loaded with features: Dynamic Range UB-10 Bodypack: 3.5mm 120 dB locking mini-jack 3-way select • Clear channel operation on the wide open, uncluttered UHF band for Total Harmonic D

Inhaltszusammenfassung zur Seite Nr. 4

URR-10 RECEIVER 1. Rackmounting the Receiver The URR-10 is supplied with RACK EARS (17) which can be attached with the screws provided on the front of the side panels to enable rackmounting the receiver. (Note: Do not mount the receiver in a rack directly above an amplifier or other source of high heat–this could degrade the performance of the URR-10. Always ensure adequate air flow and heat dissipation in any rack configuration.) 2. Powering the Receiver 24 Plug the 12V AC/DC ADAPTER (15) provi

Inhaltszusammenfassung zur Seite Nr. 5

5. Connecting the Audio Output For optimum performance, an INPUT LEVEL CONTROL (32) is provided. Adjust The URR-10 receiver provides both a fixed mic level BALANCED AUDIO OUTPUT the gain by turning the control with your thumb. For lavalier mic use, it is recom XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4" JACK mended that the level be set at about 2/3 maximum. For headworn mic use, it (13). The level from the UNBALANCED OUTPUT is controlled by the front panel may be advisab

Inhaltszusammenfassung zur Seite Nr. 6

The AF LEVEL LED DISPLAY (5) on the URR-10 receiver will light up to 5 LEDs for FRONT PANEL all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, turn down the instrument volume or the INPUT LEVEL CONTROL (33) on the UB-10 transmitter, or noticeable distortion may result. (Note: Scratchy noises can sometimes occur when some electric guitars with dirty pots or connections are used with

Inhaltszusammenfassung zur Seite Nr. 7

UH-10 HANDHELD MICROPHONE UB-10 BODYPACK TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (19) and remove, exposing the 1. Slide open the hinged BATTERY COMPARTMENT (24) and insert a fresh 9V BATTERY HOLDER (20). Insert a fresh 9V ALKALINE BATTERY (21), observing the ALKALINE BATTERY (25), observing the correct polarity. A fresh alkaline battery correct polarity as marked, and screw the cover back on to the microphone. Make can last up to 10 hours in use, but in order to ensure optimum perf