Inhaltszusammenfassung zur Seite Nr. 1
Use & Care Guide
Model: 122.16134110
Kenmoreo
@
@
P/N 19000343A0 (1110)
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
Inhaltszusammenfassung zur Seite Nr. 2
Warranty 2 \ WARNING Safety Precautions 2~4 Failure to comply with these instructions could Package Content List 5~6 Hardware Contents. 7 result in a fire or explosion that could cause serious bodily injury, death, or property damage. Preparation. 7 Parts Diagram 8 Parts List............................................... 9 //_ WARNING Assembly Instructions. 10-15 Your grill will get very hot. Never lean over the Lighting Instructions 16~17 cooking area while using your grill. Do not touch Clean
Inhaltszusammenfassung zur Seite Nr. 3
• Have your LP gas tank filled by a reputable propane gas dealer and visually inspected and re- A tank of approximately 12 inches in diameter by 18-1/2 qualified at each filling. inches high is the maximum size LP gas tank to use. • Do not store a spare LP gas tank under or • near this appliance. You must use an OPD gas tank which offers an • Never fill the tank beyond 80 percent full. If this Overfill Prevention Device. information is not followed exactly a fire causing death or serious injury
Inhaltszusammenfassung zur Seite Nr. 4
/_ WARNING A strong gas smell, or the hissing sound of gas indicates a serious problem with your gas grill or the LP gas tank. Failure to immediately follow the steps listed below could result in a fire or explosion that could cause serious bodily injury, death, or property damage. • Shut off gas supply to the gas grill. • Turn the control knobs to OFF position. • Put out any flame with a proper fire extinguisher. • Open Grill Lid. • Get away from the LP gas tank. Visually check the burner flame
Inhaltszusammenfassung zur Seite Nr. 5
A. Firebox ........ 1pc. B. Bottom panel .... 1pc. C. Tank Tray Bolt---lpc. D. Swivel Caster with Brake---lpc. E. Swivel Caster ......... 1pc. F. Caster .......... 2pcs. G. Side Panel, Left..... 1pc. H. Side Panel, Right ..... 1pc. I. Back panel .... 1pc. J. Gas Tank Barrier Bar---lpc. K. Door handle ..... 2pcs. L. Door, Left ...... 1pc. O. Left side shelf with side M. Door Right ..... 1pc. N. Side Burner bowl assembly frame with Side burner control panel ..... 1pc. shelf front panel ......... 1
Inhaltszusammenfassung zur Seite Nr. 6
T. Bezel U.. Control Knob V.1.5 Volt "AA" Size Alkaline 1 pc 1 pc Battery .......... 1pc. W. Grease Tray ..... 1pc. X. Grease Cup 1pc Y. Manual Lighting Stick ..... 1pc. 6
Inhaltszusammenfassung zur Seite Nr. 7
Item Specification Quantity Description Phillips Head Screw AA 1/4 x 15mm 16 pcs Phillips Head Screw BB 1/4 x lOmm 14 pcs Phillips Head Screw CC 5/32 x 8mm 19pcs Flat Head Screw DD 5/32 x 8mm 8 pcs Flat Washer EE 1/4 4pcs Lock Washer FF 1/4 26pcs Lock Washer 5/32 GG 15 pcs Hex Wrench HH 5/64 1pc Before beginning assembly, make sure all parts are present. Compare parts with package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble the product. Contact
Inhaltszusammenfassung zur Seite Nr. 8
• 0 1 5 7 ............... 5 4 9 / ................. 4 8 i i 7_ @ .@- 14 c _' @.® 5 7 4 4O 9 8 2 8
Inhaltszusammenfassung zur Seite Nr. 9
QUANTIT KEY# PARTS DESCRIPTION QUANTITY KEY# PARTS DESCRIPTION Y 1 0773-001 Main Lid 4 1 30 0773-030 Door Hinge 2 0773-002 Main Lid Screw 1 2 31 0773-031 Front Door, Left 1 3 0773-003 Temperature Gauge Housing 1 32 0773-032 Front Door, Right 1 33 0773-033 Door Handle 2 4 0773-004 Temperature Gauge 1 5 0773-005 Logo 1 34 0773-034 Lighting Rod 6 0773-006 Hood Buffer 1 4 35 0773-035 Lighting Rod Cover 7 0773-007 Main Lid Handle 1 36 0773-036 Gas Tank Barrier Bar 1 1 8 0773-008 Flange, Left 1 37 077
Inhaltszusammenfassung zur Seite Nr. 10
Fig. 1 D B CAUTION: While it is possible for one person to assemble this grill, obtain assistance from another person when handling some of the larger, heavier F pieces. Note: Be sure to slide grease tray out of back of grill head and remove all packaging from tray. 1. Use the parts list to check that all parts have been included. 2. Inspect the grill for damage as you assemble it. Do not Fig. 2 assemble or operate the grill if it appears damaged. If there are damaged or missing parts when you u
Inhaltszusammenfassung zur Seite Nr. 11
(e) Attach door handle (K) to left door (L) using (2) 5/32 x Fig. 5 8mm Phillips head screws (CC) and (2) 5/32 lock washers (GG). Repeat to assemble the other door handle to right door (M). (Fig.5) / i /' (f) Attach two doors (L & M) to side panels (G & H) using (8) 5/32 x 8mm flat head screws (DD). (Fig. 6) 2. Firebox Assembly L M (a) Be sure grill cart doors are closed to stabilize cart. Remove grill head (A) from carton. Place onto cart from above as shown in (Fig. 7) CAUTION: Grill head is h
Inhaltszusammenfassung zur Seite Nr. 12
iO Fig.9 3. Side Burner & Side Shelf Assembly ......s;S;XZ_--- --_ j-o _o- ..... (a) Attach side shelf and front panel (O) together using (2) 5/32 x 8mm Phillips head screws (CC) with (2) 5/32 lock washers (GG). (Fig. 9) (b) Attach side burner shelf and front panel (N) using (2) 5/32 x 8mm Phillips head screws (CC) with (2) 5/32 lock washers (GG). (Fig. 10) (c) Loosen (2) preinstalled 1/4 x 10mm Phillips head screws and (2) ¼ lock washers from right side of grill head (A) as shown. Do not screw
Inhaltszusammenfassung zur Seite Nr. 13
4. Side Burner Valve Assembly Fig. 14 N (a) Remove side burner grate from side burner shelf and set aside. Remove the two Phillips head screws attaching side burner (N) to shelf to make room to install side burner valve. See (Fig.14) \ \ \ (b) Remove two screws from side burner control valve face. Insert side burner valve control stem through hole in side burner control panel. Place side burner control knob bezel (T) over side burner valve control stem. Secure bezel to control panel and valve wi
Inhaltszusammenfassung zur Seite Nr. 14
5. Grease Cup Assembly Fig.18 From the back, pull out grease tray (W), remove any packaging materials from it, then insert grease cup (X) into grease tray (W) as shown in (Fig. 18). Push grease tray back into grill. 6. Installing Cooking Components (a) Place heat diffusers over burners as shown. Diffuser ends insert into channels on front and back of firebox. W X (Fig. 19) (b) Evenly space cooking grates (R) on the ledge above heat diffusers. (Fig. 19) Fig.19 S To obtain sear marks in cooked mea
Inhaltszusammenfassung zur Seite Nr. 15
8. Connecting LP Gas Tank to LP Grill Fig.21 (a) From front of the cart, place foot ring of 20 Ib tank into C the hole in bottom panel. Make sure the tank valve is in OFF position. Use the tank bolt to secure the tank in a fixed position (Fig.21). (b) Check the tank valve to ensure it has proper external mating threads to fit the hose and pressure regulator assembly provided. (c) Make sure all burner valves are in OFF position. (d) Inspect the valve connection port and pressure regulator assembl
Inhaltszusammenfassung zur Seite Nr. 16
3. Be sure all gas connections are securely Checking for LP gas leaks tightened. 4. Turn on gas supply. Never test for leaks with a flame. Prior to first use, at 5. Open the grill main lid. the beginning of each season, or every time your LP 6. Push and turn any main burner control knob to gas tank is changed, you must check for gas leaks. HI,position. Push Electronic Ignition button for 3 to 5 seconds to light burner. 1. Make a 50/50 (soap/water) mild soap solution. 2. Turn the control knobs to
Inhaltszusammenfassung zur Seite Nr. 17
! WARNING If Grill Still Fails To Light Never lean over the grill cooking area while 1. Check gas supply and connections for leaks. Check lighting your gas grill. Keep your face and body that all wire connections are secure. a safe distance (at least 18 inches) from the cooking grid surface when lighting your grill by 2. Repeat basic lighting procedure. If your grill still match. fails to operate, turn the gas off at source, turn the control knobs to OFF, then check the following: Manually Light
Inhaltszusammenfassung zur Seite Nr. 18
Cleaning Exterior Stainless Steel Surfaces Weathering and extreme heat can cause exterior stainless steel surfaces to turn tan in color. Machine oils used in manufacturing process of stainless steel can also To ensure a proper working unit the following proper cause this tanning color. Use a stainless steel cleaner to care and maintenance is suggested. polish stainless steel surfaces of your grill. Never use abrasive cleaners or scrubbers because they will scratch Cleaning Cooking Grids and dama
Inhaltszusammenfassung zur Seite Nr. 19
/_ WARNING 2. Clean any clogged ports with a stiff wire, such as The location of the burner tube with respect to the an open paper clip. orifice is vital for safe operation. Check to ensure the 3. Inspect each burner for damage (cracks or holes) orifice is inside the burner tube before using the gas and if such damage is found, order and install a new grill. If the burner tube does not fit over the valve burner. After installation check to ensure that gas orifice, lighting the burner may cause e
Inhaltszusammenfassung zur Seite Nr. 20
Indirect Cooking To cook indirectly, the food should be placed on the left or right side of your grill with the burner lit WARNING on the opposite side. Do not leave the grill unattended. Your grill will get very hot. Never lean over Flare-ups the cooking area while using your grill. Do not The fats and juices dripping from grilled food can touch cooking surfaces, grill housing. Grill Lid cause flare-ups. Since flare-ups impart a or any other grill parts while the grill is in favorably,distincti
