Bedienungsanleitung SkyLink GT-100

Inhaltszusammenfassung zur Seite Nr. 1

TM
Garage Door Closer Model GT-100
1. INTRODUCTION
2. INSTALLATION (CONT)
®
Congratulations on your purchase of the Skylink Garage Door Closer Step 2 – Mount the sensor on to your garage door
®
Model GT-100. Skylink Garage Door Closer is very easy to install, and
provides you with the peace of mind you have been looking for by You can mount the sensor onto your garage
®
knowing your garage door will not be left open anymore. Skylink door with double-sided foam tape if the sur-
Garage Door Clos

Inhaltszusammenfassung zur Seite Nr. 2

2. INSTALLATION (CONT) 3. OPERATION ® After installing the Skylink wall console, you may connect the power to 2) Multi-Function Wall Console the garage door opener. Multi-Function Wall Console normally comes with 3 buttons that can be used to: The garage door closer monitors the door position in order to determine 1) operate the garage door opener lighting, when the door needs to be closed. The Garage Door Sensor will send 2) lock the receiver so it doesn’t accept remote control operation, and

Inhaltszusammenfassung zur Seite Nr. 3

3. OPERATION (CONT) 3. OPERATION (CONT) ® ® ® Chamberlain , Lift-Master , Sears Craftsman Multi-Function Operation Wall Console Antenna There are 3 buttons on the Multi-Function Wall Console: 1) Push Button - Open / Close garage door. 2) Lock Button - Enable / Disable handheld remotes to operate the garage door opener. Push button 3) Light Button - Turn on / off light. ® Loss of Signal LED Timer / Learn LED Skylink Wall Console also has 3 buttons, their functions are identical to ® ® ® the Chamb

Inhaltszusammenfassung zur Seite Nr. 4

5. FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to