Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety Precautions ...................................... 3 Active Antenna ...................................... 20 Scan Encrypted .................................... 20 Air Circulation ......................................... 3 Receiver Upgrade .................................. 20 Heat Damage.......................................... 3 Note on Analogue switch-off .................. 20 Mains Supply .......................................... 3 Audio Description (optional) ..........
Inhaltszusammenfassung zur Seite Nr. 3
Dot Clock .......................................... 30 PC Picture controls ................................ 30 Digital Text and Interactive Services ....... 31 Using Digital Interactive Services ............ 31 Analogue Text Services (if available) ....... 31 Using Text Button - .......................... 31 Acessing Sub-Pages ............................... 31 Revealing Concealed Text ...................... 31 Holding a Page..................................... 31 Enlarging the Text Display
Inhaltszusammenfassung zur Seite Nr. 4
Safety Precautions This equipment has been designed and manufactured to meet international safety standards but, like any electrical equip- ment, care must be taken to obtain the best results and for safety to be assured. Please read the points below for your own safety. They are of a general nature, intended to help with all electronic consumer products and some points may not apply to the goods you have just purchased. Air Circulation Do not Leave more than 10cm clearance around the televisi
Inhaltszusammenfassung zur Seite Nr. 5
Installation and Important Information Where to install * Button and stand style is dependent on model. Locate the television away from direct sunlight and strong Interactive video games that involve shooting a “gun” type of lights. Soft, indirect lighting is recommended for comfortable joystick at an on-screen target may not work with this TV. viewing. Use curtains or blinds to prevent direct sunlight Make sure the television is located in a position where it cannot fal
Inhaltszusammenfassung zur Seite Nr. 6
Digital Switchover switchover, and you won’t need to re-tune. Keep this Television in the UK is going digital, bringing us all more choice and new services. Starting in late 2007 important information about how to re-tune your TV during the digitalTV switchover and ending in 2012, television services in the UK will go completely digital, TV region by TV region. How to re-tune: Please see abo
Inhaltszusammenfassung zur Seite Nr. 7
The Remote Control Simple at-a-glance reference of your remote control. Inserting Batteries and Effective Range of the Remote Control Remove the back cover to reveal the battery compartment and make sure the batteries are inserted the right way round. Suitable battery types for this remote are AAA, IEC R03 1.5V. Do not combine a used, old battery with a new
Inhaltszusammenfassung zur Seite Nr. 8
Connecting External Equipment Before connecting any external equipment, turn off the On/Off switch and remove the mains plug from the wall socket. PC format signals will also be displayed. Aerial cable:........................................................... NOTE: Although this television is able to connect to HDMI Connect the aerial to the socket on the rear of the equipment, it is possible that some equi
Inhaltszusammenfassung zur Seite Nr. 9
Connecting an HDMI® or DVI Device to the HDMI Input The HDMI input on your television receives digital audio and To Connect a DVI Device uncompressed digital video from an HDMI source device Connect an HDMI-to-DVI adaptor cable (HDMI type A con- or uncompressed digital video from a DVI (Digital Visual nector) to the HDMI terminal and audio cables to the PC/Side Interface) source device. AV/YPbPr sockets (see illustration). This input is designed to accept HDCP (High-Bandwidth • The recomm
Inhaltszusammenfassung zur Seite Nr. 10
Connecting a Connecting a USB Computer Disk When connecting a PC to the RGB/PC terminal on thetele- To Connect a USB Disk vision, use an analogue RGB (15-pin) computer cable anda • You can connect a USB disk to your TV by using PC audio cable for the AUDIO socket. the USB input of the TV. This feature allows you to display/play music, photo or video fi les stored in a USB stick. • It is possible that certain types of USB devices (e.g. MP3 Players) may not be compatible with this TV. • Yo
Inhaltszusammenfassung zur Seite Nr. 11
Power Save Mode and Cable Holder Environmental Information • This television is designed to consume less energy to save environment. • You not only help to save the environment but also you can save money by reducing electricity bills thanks to the energy effi ciency feature of this TV. To reduce energy consumption, you should take the following steps: • You can use Power Save Mode setting, located in the Feature menu. If you set Power Save Mode as On, the TV will switch to energy-saving m
Inhaltszusammenfassung zur Seite Nr. 12
Controlling the TV A wide variety of external equipment can be connected via the sockets located on the side of the television. Whilst all the necessary adjustments and controls for the television are made using the remote control, the buttons on the right side of the television may be used for some functions. Switching on Using the Remote Control If the standby LED is unlit, check that the mains plug is con- Press the MENU button on the remote control to see the menus. necte
Inhaltszusammenfassung zur Seite Nr. 13
Initial Installation - Digital & Analogue Before switching on the television put your decoder and media recorder to Standby if they are connected and ensure the aerial is connected to your television. To set up the television use the buttons on the remote control as detailed on page 4. 1. Connect the mains plug and switch the TV into Note : standby using the side On/Off switch. Press • For proper functioning of digital teletext in DTV any numbered or standby button on the remote mode, yo
Inhaltszusammenfassung zur Seite Nr. 14
Auto Tuning • After search is completed for digital channels, a Auto Tuning message asking whether to search for analogue As new services are broadcast, it will be necessary to channels appears on the screen: re-tune the television in order to view them. Auto Tuning will completely re-tune the television and can be used to update the channel list. It is recommended that Auto Tuning is run periodically to ensure that all new services are added. All current • Press the OK button to sea
Inhaltszusammenfassung zur Seite Nr. 15
Manual Tuning The television can be tuned-in manually using Manual Tuning feature. Digital Manual Tuning Analogue Manual Tuning The feature is available for service engineers or The television can be tuned-in manually. For example: can be used for direct channel entry if the multiplex if the television cannot be connected to a media channel is known. recorder/decoder with a SCART lead or to tune-in a station on another System. • Select Channel Search from the Installation menu and press OK.
Inhaltszusammenfassung zur Seite Nr. 16
Analogue APS and Programme Sorting Before switching on the television put your decoder and media recorder to Standby if they are connected and ensure the aerial is connected to your television. • When the search is complete the television will APS (Automatic Programming System) automatically select programme position 1. This may When the APS feature is selected all channels and not be a clear picture or the signal may be weak, so settings will be lost, the television will return to factory
Inhaltszusammenfassung zur Seite Nr. 17
Stereo and Bilingual Transmissions and Channel List Stereo and Bilingual Transmissions Moving a Channel For ATV programmes • Highlight the desired channel by using Up or Down buttons. If stereo or dual language broadcasts are transmitted, the word Stereo or Dual will appear on the screen each time posi- • Select Move option in the channel list and press tions are changed, disappearing after a few seconds. If the OK button. broadcast is not in stereo, the word Mono will appear. • Edit Numbe
Inhaltszusammenfassung zur Seite Nr. 18
Renaming a Channel and Viewing Info Banner and Programme Locking EPG Renaming a Channel Viewing Info Banner • Select the channel that you want to rename and • Press INFO button the information screen will select Edit Name option. Press OK button to appear giving details of the channel and programme continue. currently being viewed. • Whenever you change channel, the TV displays the broadcast picture along with an information banner at the bottom of the screen (available only in DTV mode).
Inhaltszusammenfassung zur Seite Nr. 19
Programme Guide, Displaying Subtitles and Language Selection Programme Searching Language Settings From the guide screen, you can use search feature. Using this menu you can adjust the preferred language settings. • Press “0” button on the remote control to view Guide Search menu. Using this feature, you can search the • Select Language from Setup menu and press OK programme guide database in accordance with the to view this menu. Press the BACK button on the genre selected or wi
Inhaltszusammenfassung zur Seite Nr. 20
Digital Settings - Parental Control, Menu Lock, Set PIN You can view or set parental preferences of your TV. Viewing Parental Control Menu Menu Lock • While in DTV mode, press MENU to view main In menu lock you can set locking for all menus, or the menu. Select Setup from the list and press OK Installation Menu to restrict access to these menus. button. If the menu lock is disabled, there will be free access to the menu system. • Use Up or Down buttons to go to Menu Lock option. Use Left
