Bedienungsanleitung Edelbrock Torker-Plus 5002

Inhaltszusammenfassung zur Seite Nr. 1

TORKER-PLUS
Camshaft/Lifters/Lube Kit
CATALOG #5002
MODEL: 265-400 c.i.d. Chevrolet V8
� PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to call our
Technical Hotline at: 1-800-416-8628.
� CAMSHAFT: Edelbrock Torker-Plus camshafts are ground specifically for use with the corresponding Torker II manifold. The Torker II manifold
#5001, and Torker-Plus camshaft #5002, are designed to work as a team to give you bet

Inhaltszusammenfassung zur Seite Nr. 2

3. Drain radiator coolant, move fan shroud back and remove fan and spacer from water pump. On air conditioned vehicles, remove bolt, lower idler pulley and compressor-to- water pump mount. Disconnect hoses and brackets. Most vehicles will require radiator removal prior to cam removal. Remove water pump. 4. Disconnect all linkage from carburetor such as throttle, throttle springs, transmission, cruise control and automatic choke. 5. Tag and remove vacuum lines. 6. Remove valve covers. 7. Remove d

Inhaltszusammenfassung zur Seite Nr. 3

� INSTALLING DISTRIBUTOR AND TIMING ENGINE NOTE: Before installing your distributor, check the gear drive on the distributor and oil pump for any signs of wear. If worn, be sure to replace with new or you may wear out your camshaft prematurely. This is especially true when rebuilding your engine and a high performance oil system is used, which generates a heavier load on the camshaft gear system. Edelbrock camshafts are designed to use OEM-type gears only. 1. Turn the engine over in the directio

Inhaltszusammenfassung zur Seite Nr. 4

� WARNING In order for this Torker-Plus cam and lifter kit to be covered under ANY WARRANTY you MUST use the correct Edelbrock Sure Seat Valve Springs. The end flap or label from your Sure Seat Valve Spring box must be sent in with your camshaft warranty card. Failure to install new Edelbrock Sure Seat Valve Springs with your new Torker-Plus cam and lifter kit could cause the cam lobes to wear exces- sively and could cause additional engine damage. IF YOU HAVE ANY QUESTIONS ABOUT THIS APPLICATIO

Inhaltszusammenfassung zur Seite Nr. 5

� CAMSHAFT: Torker-Plus Hydraulic � CAMSHAFT: Torker-Plus Hydraulic � CATALOG #5002 � CATALOG #5002 � ENGINE: Chevrolet 265-400 c.i.d. V8 � ENGINE: Chevrolet 265-400 c.i.d. V8 � RPM RANGE: 1500-6500 � RPM RANGE: 1500-6500 � CAUTION: Do not use dual valve springs. � CAUTION: Do not use dual valve springs. Use only recommended Edelbrock Sure Seat Use only recommended Edelbrock Sure Seat Valve Springs #5703. Valve Springs #5703. Use stock ratio rocker arms only. Use stock ratio rocker arms only. D