Bedienungsanleitung Edelbrock 65913 (Ti-Tech Coated)

Inhaltszusammenfassung zur Seite Nr. 1

EDELBROCK HEADERS
CATALOG #65912 (Ceramic-Coated) & 65913 (Ti-Tech Coated)
for 1972-1991 Jeep, Full Size Cherokee, Wagoneer & J-Series Pick-Up,
1972-1981 Jeep CJ5, CJ7, & CJ8
1970-1979 AMC, AMX, Javelin, Rebel, Matador
with 304, 360, 390, or 401 without A.I.R.
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before installing your Headers. If you have any questions or problems, please
call our Technical Hotline at: 1-800-416-8628 from 7:00 am - 5:00 pm, Monday-Friday, Pacif

Inhaltszusammenfassung zur Seite Nr. 2

DISASSEMBLY 4. With wire ties, route any hoses, wires or lines away from headers as necessary. 1. Disconnect negative battery cable. 5. Re-install your factory heat riser valve using the 2. Raise vehicle and disconnect 02 sensor, if supplied flat gasket along with the factory equipped. exhaust pipe and supplied 3/8 x 3 Hex bolts, 3. Unbolt stock exhaust pipes from manifolds. lockwashers and flatwashers. Do not 4. Remove heat riser valve, clean and check for overtighten! proper operation. Repl

Inhaltszusammenfassung zur Seite Nr. 3

HARDWARE SUPPLIED Qty. Description Qty. Description q 1 #25-9367 Header left side (Painted) q 4 3/8” Flat washers (Standard) q 1 #25-9368 Header right side (Painted) q 8 5/16” Lockwashers q 1 #25-9369 Header left side (Ceramic-Coated) q 1 Heat riser gasket q 1 #25-9370 Header right side (Ceramic-Coated) q 4 Hardened washers (for header flange slotted holes) q 12 Hex header bolts 3/8” q 1 Heat stove flex tube 2” q 2 Port gaskets q 8 Hex header bolts 5/16” (late model) q 2 3/8” x 2” Hex bolts q 1