Bedienungsanleitung Dakota Digital MCL-3207

Inhaltszusammenfassung zur Seite Nr. 1

7
6
5
4

MODEL MCL-3207
3-3/8” SPEEDOMETER/TACHOMETER for 2008-2010 Rocker

IMPORTANT NOTE! This gauge has an odometer preset option that is only available one time in the first 100 miles
(160km) of operation. See “Odometer preset” for instructions.


GAUGE SETUP AND CALIBRATION
The setup menus are entered by holding the switch in while turning the
key on. The menus are as follows:
Menu Description
dIag read diagnostic codes
ADJUST adjust calibrate speed
vnIt select speed un

Inhaltszusammenfassung zur Seite Nr. 2

SPEEDOMETER SETUP Press and hold the switch while turning the key on and starting the engine. Once the engine is running, release the switch. Press and release the switch to change the menu selection. d d d dI I I IA A A AG G G G Diagnostics mode for checking/clearing trouble codes • Press and release the switch until “dIAG” is displayed, then press and hold the switch until “ - ” is displayed. • Release the switch. The display will show “ENGINE”, “SECvRE”, ”ABS”, or “DoN

Inhaltszusammenfassung zur Seite Nr. 3

n n n nI I I Ig g g gH H H Ht t t t Night Dimming Your display system has a dimming feature that dims the display intensity automatically at night. Normally the system is at full brightness for daytime viewing. To have the system at full brightness all of the time, go into the setup menu as described above and select “ngt” (night). Press and release the function switch to select “OFF” instead of “on”. Press and hold the function switch to save the new setting. • Press and release

Inhaltszusammenfassung zur Seite Nr. 4

P PE ER RF F Performance menu setup P PE ER RF F The performance readings can be turned on or off. When they are turned off the odometer display will only toggle through the mileage readings. • Press and release the switch until “PErF” is displayed, then press and hold the switch until “ - ” is displayed. • Release the switch. The current setting will be displayed (on or oFF). • Press and release the switch until the desired setting is displayed. • Press and hold the switch until “ -

Inhaltszusammenfassung zur Seite Nr. 5

Troubleshooting guide Problem Possible cause Solution Gauge will not light up. Orange/White wire does not have power. Inspect and repair stock harness. Brown/Gray wire does not have power. Inspect and repair stock harness. Black wire is not getting a good ground. Inspect and repair stock harness. Gauge is damaged. Return gauge for repair. (see instructions) Clock resets when key is off. Brown/Gray wire does not have constant power. Inspect and repair stock ha